Jump to content

Recommended Posts

Posted

Mine has not been working for the past couple of weeks. I just disconnected the negative battery cable waited 30 seconds and reconnected and now it is working fine

Sent from my SM-G975U1 using Tapatalk

Posted

I keep meaning to post my findings over the past week. Prior to shutdown, I unplug my radar detector. I don’t plug radar detector back into the outlet until engine has been started. This has been working flawlessly for just over 1 week.

 

since I am not perfect, I do forget to follow these steps from time to time, and the auto shut off fails when the above steps are not followed. Leads me to the assumption that there is something goin on with the wiring or perhaps the infotainment system, and or the open circuit code some others are getting. 

  • 2 weeks later...
Posted

I have noticed that the auto-stop does not work when the defrost in on.  

  • Like 1
  • 2 weeks later...
Posted

I have a 2020 1500 LT( 8 speed trans) with only about 1500 miles on it...mostly city driving so far (25~40 mph).  The auto stop worked fine at first, even in semi cold weather...worked enough to make it noticeable but I decided to leave it on to see if I could get used to it.  Around 800 miles it stopped working, like others have said, can't say I miss it terribly but wondering what is wrong.  Probably crazy but about the same time I noticed the auto climate control system acting wacky.  I have it set at 70 degrees...when I start the truck it will blow full cold until the truck gets warmed up and then the air obviously warms up...in my 2015 Sierra  it would not blow air until the engine was warm enough....and lastly, seems a little rough (transmission) when rolling through traffic at 28-35 mph, like it can't find the gear it wants.  Anybody seeing all these symptoms in a newer 1500?

  • 5 weeks later...
Posted

I took my truck in for the 3 recalls a couple of weeks back.  The Service writer said that the ABS fix might correct the Auto Stop not working.  I got the truck back and after a good run to get everything up to operating temperature, but alas it still does NOT auto stop.  I will take it in after the Shelter In Place is lifted and have that fixed.  I am certain all they will do is reflash the ECM and it will work for a little while afterward anyhow.

  • Like 1
Posted
On 3/10/2020 at 9:03 AM, Waldo Bresh said:

I have a 2020 1500 LT( 8 speed trans) with only about 1500 miles on it...mostly city driving so far (25~40 mph).  The auto stop worked fine at first, even in semi cold weather...worked enough to make it noticeable but I decided to leave it on to see if I could get used to it.  Around 800 miles it stopped working, like others have said, can't say I miss it terribly but wondering what is wrong.  Probably crazy but about the same time I noticed the auto climate control system acting wacky.  I have it set at 70 degrees...when I start the truck it will blow full cold until the truck gets warmed up and then the air obviously warms up...in my 2015 Sierra  it would not blow air until the engine was warm enough....and lastly, seems a little rough (transmission) when rolling through traffic at 28-35 mph, like it can't find the gear it wants.  Anybody seeing all these symptoms in a newer 1500?

I did notice that my climate control blows full force sometimes, it is a little annoying.  I have noticed that my infotainment won't mute and I get an intermittent message on the screen telling me that my rear camera needs servicing.  I am convinced that if this truck was built in the US instead of Mexico I wouldn't have all these problems.

Posted

Update on my 2019 1500 GMC for anyone who cares. Auto stop still not functioning correctly. 23,000 miles so for and truck still running great. Noticed cruising down the highway around 65 miles an hour the engine light started flashing slowly. Light stopped after 5 miles and the truck never missed a beat. Called dealer and they said bring it in right away as the flashing light can be serious. Anyways long story short the dealer has ordered a new ECM and stated that that may be the problem all along. IDK but I am definitely purchasing an extended warranty!!! ECM is on order and will not be in for a week or so. Dealer let me take my truck and asked me to keep an eye on the engine light. Auto stop is now working again for the time being.  Love the truck and ride but getting aggravated as to what is continually going on with the Auto Stop feature.

Posted
1 hour ago, jhuff said:

Update on my 2019 1500 GMC for anyone who cares. Auto stop still not functioning correctly. 23,000 miles so for and truck still running great. Noticed cruising down the highway around 65 miles an hour the engine light started flashing slowly. Light stopped after 5 miles and the truck never missed a beat. Called dealer and they said bring it in right away as the flashing light can be serious. Anyways long story short the dealer has ordered a new ECM and stated that that may be the problem all along. IDK but I am definitely purchasing an extended warranty!!! ECM is on order and will not be in for a week or so. Dealer let me take my truck and asked me to keep an eye on the engine light. Auto stop is now working again for the time being.  Love the truck and ride but getting aggravated as to what is continually going on with the Auto Stop feature.

Let us know if that fixes the auto stop issue.

Posted

2020 AT4, 1,500 miles.  It worked consistently early on (I usually turned it off at the end of my driveway), has not been working the last couple of weeks.  Just noticed it wasn't working lately.

Posted

So my auto stop stopped working a couple weeks after I got the truck. About a week ago my kids were playing around in the back and knocked out the cigarette charger for my camera. Lo and behold it’s working again. So it seems if you have any aux power plugged in it won’t shut off.


Sent from my iPhone using Tapatalk

Posted
So my auto stop stopped working a couple weeks after I got the truck. About a week ago my kids were playing around in the back and knocked out the cigarette charger for my camera. Lo and behold it’s working again. So it seems if you have any aux power plugged in it won’t shut off.


Sent from my iPhone using Tapatalk
I believe that's what it is. The first time it happened I disconnected the battery and it started working again. This last time, I just unplugged my dash cam over night

Sent from my SM-G975U1 using Tapatalk

Posted

Unplugging my camera did work a couple of times but since it does not make any difference. Pay attention to your volt meter as mine is at 15-17 when the Auto Stop feature inst working. After dealer clears or resets the ECM the volt meter returns to 10-12 and Auto Stop works again. I am hoping that the new ECM once installed will fix the issue. 

  • 1 month later...
Posted

Hey, all. We recommend reaching out to your local dealership in order for them to take a look into your concerns. Our team is happy to help facilitate a service appointment . If interested, please send an email to [email protected] ATTN: Forum Username  with your contact information, VIN, brief description of your concern,  and preferred dealership. We look forward to hearing from you. To learn more about GM's privacy policy, please visit http://bit.ly/2h3ZUnC. 

 

Aleigha W. 

Posted

Condition of the battery and charging system is one of the things auto start/stop monitors to decide if it will cause a stop. 

Camera left drawing juice when truck off may have resulted in battery charge lower than computer thinks is necessary for stop/start to function.

 

Auto Stops may not occur and/or Auto Starts may occur because:
. The climate control settings require the engine to be running to cool or heat the vehicle interior.
. The vehicle battery charge is low.
. The vehicle battery has recently been disconnected.
. Minimum vehicle speed has not been reached since the last Auto Stop.
. The accelerator pedal is pressed.
. The engine or transmission is not at the required operating temperature.
. The outside temperature is not in the required operating range.
. The vehicle is in any gear other than D (Drive).
. Tow/Haul Mode or other driver modes have been selected.
. The vehicle is on a steep hill or grade.
. The driver door has been opened or the driver seat belt has been unbuckled.
. The hood has been opened.
. The Auto Stop has reached the maximum allowed time.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,902
    Total Members
    8,960
    Most Online
    whenindoubtuseahammer
    Newest Member
    whenindoubtuseahammer
    Joined
  • Who's Online   3 Members, 0 Anonymous, 427 Guests (See full list)


  • Latest Articles

  • Posts

    • Its no wonder you've gravitated to the oil types and brands you have in later years after trying certain brands and one being a specialty oil or at least very hard to come by up here and the other would have been a commonly found oil of the era and the vastly different outcomes as a result to using the vehicles in question the same distance for an OCI . It shows what marketing hype can do without actually having the product to back up the claims and that is no different now with the insane claims that are written on the side of a bottle of oil from some of the off the shelf oils.    What has surprised me and I was already finding this out before I bought my truck with the GDI engine, that this newer fancy technology that seemingly would suggest better fuel economy/emissions with this high pressure spray of fuel is not in reality kind at all to the engine or at least the oils life. Yet they insist on claiming long OCI with this technology just like they did with the port or similar type fuel injection systems when in reality its a step back in oil life to have a GDI system.    I think the mistake your making Grumpy is that your not sending your samples to Blackstone and getting the feel good glowing report that you can run it another 1000 or more miles and then send another sample where they say run it yet another 1000 miles and on and on it goes until your sending in something that looks a lot like road tar and then they may suggest you change your oil within the next 1000 miles 😆
    • I am guessing that engines of that design back then had a better ability to be abused and survive longer than a new design engine with the long timing chain and the overhead cams and phasers etc. But I would never guess that an engine could go that far and not fail spectacularly or at least die a slow death. 
    • In the 80's 90's I'd run Honda's 7,500 miles between changes using Red Line HP 5W20 and do it for hundreds of thousands of miles with issues. Back in the day it was an SAE 20 with the HTHS of a SAE 30 and SN add load. It was also very polar. Oxidation VOA was over 120. Besides those motors were SPFI and lean burn tech. I could have likely run it longer but never did.    We had a Toyota bought new I ran on Pennzoil's latest and greatest synthetic of the day with "Penthane". A made up word for a very low dose of PAO. Tried 7,500 mile OCI's in that Group III/VI chemistry and the rings tapped out at 90K. Rocker box wasn't as bad as the one Punch put up but it wasn't good either. Also a SPFI motor.    I'm around 3,750 across the board on these GDI monsters and the oil it tapped out by then usually on TBN/TAN crossover and color. Red Line HP Euro.    The AMSOIL SS brochures tell you to follow the OEM values for the service class but that it can be run up to 25K if monitored. I can't imagine what motor could go that distance and not tap out. I've never owned one.    Yes, I know. Lot's of people do. I'm just not going to be one of them. 
    • I knew a guy in the early 80's that bought a new Monte Carlo and ran it a 100,000 miles without ever changing the filter or the oil. Just kept adding. It looked like that inside.     
    • Good evening. I was lucky enough to get passed down to me a 2007 GMC LBZ that was my great uncle's. While the underside and rockers are more or less gone I feel like with time I can restore it to working order since it only has 110,000 miles and he put nearly every option he could get without getting the new body style since he did not trust DEF. So far I have done everything I can think of but when I put the key into the ignition nothing happens. I put 2 brand new batteries in it. Cleaned the terminals. Check all the fuses and relays and they all pass with my multimeter. I know I'm missing something that I just cant think of. The only odd thing is the OBD2 port works which makes me think its not the mega fuse. Any advice would be greatly appreciated. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...