Jump to content

Recommended Posts

Posted

2022 Silverado 1500 / 5.3.   I just got out of a Jeep Wrangler that had an auxiliary battery from the factory that ran the accessories when the start/stop was activated.

 

Does my Silverado have this?  Or does the main battery handle everything?

Posted (edited)

 

 

 

 

 

 

 

Just kidding

 

 

 

 

 

 

 

Not a stupid question at all. The only secondary battery I'm aware of on Chevy trucks is for OnStar. I did a parts search on a couple websites. The main battery and the OnStar battery are the only batteries I could come up with. 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

With that said, I've pulled a handful of disabled Jeeps and Dodges off the road because of battery issues where the vehicle failed to communicate with the key fob remote and wouldn't start back up. I have not encountered anybody with a GM product with this issue, yet. Only battery issue I've seen with GM cars is when a military servicemember returns from a deployment and the battery is completely dead and needs replacing because they didn't disconnect it, or put it on a batter tender, prior to leaving. I think you have very little to worry about and will be good to go for the most part. 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Edited by Transient
Posted

Thanks for the replies!

 

Late model Jeep Wranglers have had terrible results with the 2-battery system.  If the Auxiliary battery fails, it drains the main battery and the vehicle refuses to start.  Poor design on Mopars part.

Posted
10 hours ago, Turkey Creek said:

Thanks for the replies!

 

Late model Jeep Wranglers have had terrible results with the 2-battery system.  If the Auxiliary battery fails, it drains the main battery and the vehicle refuses to start.  Poor design on Mopars part.

 

11 hours ago, Turkey Creek said:

2022 Silverado 1500 / 5.3.   I just got out of a Jeep Wrangler that had an auxiliary battery from the factory that ran the accessories when the start/stop was activated.

 

Does my Silverado have this?  Or does the main battery handle everything?

Previous gen trucks had a spot for a second battery. I forget what year but they moved the battery from the right front behind the grille to the left rear by the radio antenna. Supposedly this was so the battery was protected during a front end collision so it could still provide power to Onstar. The old battery spot was left empty and you could add a 2nd one there if you wired it up. When these trucks were redesigned in 19. They braced it differently in the front so it did away with the old battery spot.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Have considered installing a DC to DC charger in your camper to replace your isolator?  
    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...