Jump to content

AUTO A/C Setting

Trey Beck
 Share

Recommended Posts

Trey Beck Enthusiast

Trey Beck

Posted
Posted

So this may be the dumbest thing GM does.  If I use the auto function for the A/C (I always run the AC being in Florida) it shuts off the recirculating function for the A/C.  This then lets hot moist air into the cab.  My question, is there a way to use the auto function and still have the regulating function stay on?  My Toyota would do the same thing but after you hit auto you could turn the recirculating function on and it would still stay in Auto mode.  This was in a 2010 Highlander.  

GN2018 Enthusiast

GN2018

Posted
Posted

If you start by hitting Auto, it will essentially stay in Auto mode if you hit the recirculating button.  It will still hold the temp and control the fan automatically.  The Auto light will just not be on.  I do this all the time.  Same thing happens if you hit the buttons to redirect the airflow.  I guess it basically stays as automatic as you let it.

Silverado4x4 Senior Enthusiast

Silverado4x4

Posted
Posted (edited)

As GN2018 said as I was getting ready to type the same thing. The problem I had was the wife she would always turn the right temp control knob and take it out of sync then I would have to resync it hit auto then turn on recirc, she finally stopped doing it. I hated when she would do that because the left and right temp knobs would be different temp settings. 

Edited by Silverado4x4
newdude Senior Enthusiast

newdude

Posted
Posted (edited)

In AUTO the system is automated.  Set the temp and the doors and fan will move accordingly based on the temp you set and then the in cabin sensors like the windshield moisture sensor, sunload sensor and HVAC duct sensors.  

 

Recirc door is controlled during AUTO as well.  You can command it independently as well but otherwise in AUTO it will control it.    

 

Automatic Operation

In automatic operation, the HVAC control module maintains the comfort level inside of the vehicle by controlling the A/C compressor clutch, the blower motor, the air temperature actuators, mode actuator and recirculation actuator.

To put the HVAC system in automatic mode, the following is required:

  1. The auto switch must be activated.
  2. The air temperature switch must not be in either the full hot or full cold position.

Once the desired temperature is reached, the blower motor, mode, recirculation and temperature actuators automatically adjust to maintain the temperature selected. The HVAC control module performs the following functions to maintain the desired air temperature:

  • Monitors the following sensors:
    • Ambient air temperature sensor
    • Ambient light/sunload sensor
    • Windshield temperature and inside moisture sensor
  • Regulate the blower motor speed
  • Position the air temperature actuators
  • Position the mode door actuator
  • Position the recirculation actuator
  • Request A/C operation
  • Control of the A/C compressor

When the warmest position is selected in automatic operation the blower speed will increase gradually until the vehicle reaches normal operating temperature. When normal operating temperature is reached the blower stays on high speed and the air temperature actuators stays in the full heat position.

When the coldest position is selected in automatic operation the blower stays on high and the air temperature actuators stay in full cold position. The mode actuator remains in the panel position and the recirculation actuator will remain in the recirculation position.

Under cold ambient temperatures, the automatic HVAC system provides heat in the most efficient manner. The operator can select an extreme temperature setting but the system will not warm the vehicle any faster. Under warm ambient temperatures, the automatic HVAC system also provides air conditioning in the most efficient manner. Selecting an extreme cool temperature will not cool the vehicle any faster.

 

 

 

Recirculation Operation

The recirculation switch is integrated into the HVAC control. The selected recirculation setting is sent to the HVAC control module via LIN-Bus. The HVAC control module controls the air intake using the recirculation actuator. In recirculation mode the recirculation door is positioned to block outside air from entering and circulate the air within the vehicle. In outside air mode the recirculation door is positioned to route outside air into the vehicle.

Recirculation is available in vent and vent/floor mode.

In floor only mode, some airflow is directed to the defrosters. In defrost and floor only modes, the actuator positions the recirculation door so that outside air is circulated to reduce window fogging.

In automatic mode the values of the sensors are used as inputs for the HVAC control module to calculate the fog risk on passenger compartment side of the windshield. The A/C compressor and the defrost mode may activated to prevent or remove fog on the passenger compartment side of the windshield.

Edited by newdude
  • Like 1
PunchT37 Enthusiast

PunchT37

Posted
Posted

Tried mine 5 times today. From off, hit auto and full low on temp. Thing starts blasting. No recirc light. If you hit recirc, the light comes on with no difference in sound. Hit recirc again, light goes off with a difference in sound. Hit recirc again, light comes on with a difference in sound. Off, it repeats.

 

 So, from off, it controls recirc, with no light in auto. Once you hit the recirc button, it`s "in your hands now" even though the auto light is still on.

 

Tried out of temp sync mode. Still the same.

Silverado4x4 Senior Enthusiast

Silverado4x4

Posted
Posted (edited)

If it's hot inside the cab with it on low it will blast until the temp inside is met where you have it set when it is met the fan will slow down when in auto same with heat. Also there is a setting in the Infotainment under climate control where you can pick high medium or low fan speed. So hit sync,auto,hit recirc to turn off and adjust your temp control knobs.

 

Edited by Silverado4x4
newdude Senior Enthusiast

newdude

Posted
Posted (edited)
1 hour ago, PunchT37 said:

Tried mine 5 times today. From off, hit auto and full low on temp. Thing starts blasting. No recirc light. If you hit recirc, the light comes on with no difference in sound. Hit recirc again, light goes off with a difference in sound. Hit recirc again, light comes on with a difference in sound. Off, it repeats.

 

 So, from off, it controls recirc, with no light in auto. Once you hit the recirc button, it`s "in your hands now" even though the auto light is still on.

 

Tried out of temp sync mode. Still the same.

 

 

Correct, in AUTO the light won't display.  If you went into the "Climate" page on the radio however it will show you what is all labeled as AUTO for its function.  

 

AUTO = set the temp, truck does the rest.  Changes the mode doors, fan speed and recirc doors all on its own.  

Edited by newdude
GN2018 Enthusiast

GN2018

Posted
Posted
5 hours ago, Silverado4x4 said:

As GN2018 said as I was getting ready to type the same thing. The problem I had was the wife she would always turn the right temp control knob and take it out of sync then I would have to resync it hit auto then turn on recirc, she finally stopped doing it. I hated when she would do that because the left and right temp knobs would be different temp settings. 

I hate it when my wife turns down the fan using the fan control knob.  If I want the fan, I adjust it by changing the temp.  I like the automatic fan as part of Auto.

Silverado4x4 Senior Enthusiast

Silverado4x4

Posted
Posted (edited)
7 minutes ago, GN2018 said:

I hate it when my wife turns down the fan using the fan control knob.  If I want the fan, I adjust it by changing the temp.  I like the automatic fan as part of Auto.

I agree with that 100% I forgot about that one took me about 1 week to break her of the fan control knob. Then it moved to the Tahoe everytime I got in it the climate control would be all out of wack but all good now. I told her after getting everything back to normal all you have to do is adjust the left knob and don't touch the right knob for temp up or down the vehicle will take care of the rest.

Edited by Silverado4x4
  • Thanks 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • KARNUT
      Missing thrust bearing? And oil selection

      By KARNUT · Posted

      I agree with this assessment. As you know I’m testing longevity with vehicles for the first time. I have a few vehicles I passed to kids and grandkids. We’re all past 100K miles some approaching 170K. I’m the only one doing 5k oil changes. The rest whatever the minder says. I’m the only one doing frequent transmission service. My odyssey the trip vehicle at 200K will be finished as a trip vehicle. I recently changed to high mileage oil, Valvoline. I can’t get past the fact that all manufacturers want to claim long service life. I just don’t make sense that they would go with low weight oil for mileage. While sacrificing longevity.
    • Atlas
      Missing thrust bearing? And oil selection

      By Atlas · Posted

      There's absolutely a mountain of profit in catering to the "I do my own research" crowd, people who are certain they know better. And I don't mean there isn't data to support that 0w40 produces less wear product than 0w20 in an engine like the 3.0 Duramax, that only feeds them the assurance they need. Again, my whole thing with oil selection is, sure, 0w40 or 0w30 produces less wear product. Are we talking the difference between the engine lasting only 100k versus 200k? Or are we talking more like, if the engine will already go 350k on a good 0w20 regimen recommended by the OE, is using 0w40 going to get us to 355k, assuming we can even get the rest of the truck to last that long, meanwhile sacrificing the first 5y, 100k in powertrain warranty. The answer isn't easy, there are tradeoffs.   I willfully use 0w20 Dexos D for this reason, knowing that a 0w40 will produce slightly less wear. I don't believe the delta in wear product is meaningful over the lifetime of the engine, and I place much more importance on driving style and overall feeding and care of the engine as a whole. It's the mentality that someone can abstain from alcohol their whole life which is an amazing boost to health by itself, theoretically. But if they're sedentary, that lifestyle choice will most likely kill them young despite their other, concerted efforts. Maybe someone doesn't drink AND they are the perfect picture of health and activity AND they use 0w40 AND they treat their engine perfectly. If living until 130 years is the goal, sure, do that. But it's going to be a really old truck falling apart around a good engine for that last 30 years, without a doubt.   I watched Demonworks' other video on the 100k+ 3.0 Duramax that had dealer 0w20 changes on what appears to be OLM-prescribed intervals (8-10k).   The QR codes are still present and readable on the main bearings. That's how little wear it has.   That's not proof that anyone else should stick to 0w20, but it's confirmation, for me, that 0w20 is perfectly acceptable to use in these engines.
    • Z45
      Castrol Edge VS Amsoil OE

      By Z45 · Posted

      1Based on independent testing of OE 0W-20 in the Peugeot TU3M Wear Test as required by the dexos1 Gen 2 specification.
    • c4racer2
      summer road trips in the 2026 2500HD

      By c4racer2 · Posted

      oh ya that's good to know - I would rather use a gear than the brakes down a long hill.  I would not let cruise control take over on snow or towing a trailer for sure on hills anyway.     The other thing about the CO trip was that was all done above 6K feet for the most part, so that has to use more gas as the motor is down a good amount of power up there.   If I drove my 2016 Camaro with a very similar V8 to this 6.6 it would probably get about 23-24 on the fast run up to NE.  But the premium fuel premium is steep here in CO, so it would still only save about $40 in overall costs for the round-trip.  And you sure can't carry much gear in a convertible camaro!
    • newdude
      Magnetic ride struts

      By newdude · Posted

      Got part #s of what you ordered vs what you got?  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...