Jump to content

Advent OGM-1 Like New

TigerJ684

By TigerJ684
in Classifieds (Buy/Sell/Trade)

Recommended Posts

TigerJ684 Enthusiast

TigerJ684

Posted
Posted

Advent OGM-1 nav unit for 2007-UP GM trucks and SUV's. The unit is like new. There are no scratches or marks on any part of it. All accessories are fully functional. This is a great replacement for the factory units. Comes in all of the original packaging, with all of the original parts (gps, bluetooth mic, etc). Also included is the JLink cable for video playback from your iPod/iPhone.

 

From ADC mobile website:

Interfaces with factory backup camera (if equipped), interfaces with factory backup sensors (has a visual display of the sensors), runs iGo Primo nav software, reads CDs, DVDs, MP3 CDs, USB thumb drives, interfaces with factory XM (if equipped), has a Parrot bluetooth system, has iPod direct control cable included. Plug-and-play, no adapters or wire splicing needed (unless using factory backup camera).

 

Full details here:

http://www.adcmobile.com/category/navigation/navigation-advent/advent-navigation-gm/advent-gm-navi-chevrolet/

 

I'm asking $925 shipped. If you live near Kennesaw, GA you can come by and pick it up. PM for details.

 

post-111072-0-15059100-1359475809_thumb.jpg

post-111072-0-15059100-1359475809_thumb.jpg

post-111072-0-15059100-1359475809_thumb.jpg

post-111072-0-15059100-1359475809_thumb.jpg

puckyou Enthusiast

puckyou

Posted
Posted

Bump. $900 shipped.

 

 

GLWS, I just purchased mine new from Walt and it arrives today, or I would have taken this off your hands....

TigerJ684 Enthusiast

TigerJ684

Posted
  • Author
Posted

GLWS, I just purchased mine new from Walt and it arrives today, or I would have taken this off your hands....

 

Missed it by that much. Thanks for the bump, though.

Knowklew Enthusiast

Knowklew

Posted
Posted

What all is needed/involved for factory reverse camera hookup? I have the factory reverse camera that shows up in my mirror, will this unit make it show up on the screen as well?

TigerJ684 Enthusiast

TigerJ684

Posted
  • Author
Posted

What all is needed/involved for factory reverse camera hookup? I have the factory reverse camera that shows up in my mirror, will this unit make it show up on the screen as well?

 

Yes, you can incorporate your camera with this unit. Refer to this thread for details:

http://www.gm-trucks...howtopic=145376

 

A quick call to Walt at ADC Mobile is always the easiest option.

 

Edit: And I think all you'll need is an RCA adaptor wire which Walt can provide you.

07ccz71 Enthusiast

07ccz71

Posted
Posted

First post on the forum and you low ball hahahaha yard sales start in the morning champ set your alarm

Chris Senior Enthusiast

Chris

Posted
Posted

Yea no one let's these go that cheap.

 

Sent from my DROID RAZR MAXX using Xparent Red Tapatalk 2

TigerJ684 Enthusiast

TigerJ684

Posted
  • Author
Posted
First post on the forum and you low ball hahahaha yard sales start in the morning champ set your alarm

Yea i guess i forgot to say no low ball offers, haha.

 

Sent from my SPH-D710 using Tapatalk 2

 

$600? email me, [email protected]

Just too low man, sorry.

 

Sent from my SPH-D710 using Tapatalk 2

TigerJ684 Enthusiast

TigerJ684

Posted
  • Author
Posted

Ok guys $875 shipped. Need to get this gone. This is a great deal.

 

Sent from my SPH-D710 using Tapatalk 2

Chris Senior Enthusiast

Chris

Posted
Posted

If I had a 900 series I would buy it. Sorry I wish I could help out

TigerJ684 Enthusiast

TigerJ684

Posted
  • Author
Posted

Thanks for the replies chawkins. Was getting pretty lonely on here.

 

Sent from my SPH-D710 using Tapatalk 2

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • Chuck FB
      Software Update

      By Chuck FB · Posted

      I trust you saw the other comment where he knew what he was talking about !. Yes, these darned newer vehicles with all their so smart they are stupid technology, goes and drains the battery down. As you might see my other comment, I installed a Noco 5 battery tender under the hood and at this point still have the cord routed so I have to lift the hood and then plug it in but am typically parked in a garage or a shed so its not risking the engine hood in the wind. That way I am assured or hopefully so of not finding I have a battery drawn down and can't even start the truck and that also damages the battery to draw it down too far. 
    • Chuck FB
      Software Update

      By Chuck FB · Posted

      I guess no surprise my guesses were wrong !, at least now I know if I ever happen to see it grayed out in my own truck as to what is going on.    I never happened to catch my truck with it grayed out, it seemed every time I would test to see if there was an update it never found anything and yet more than once I would check to see if there was an update and there was nothing, then a day later or even that same morning I would drive to town and after more than one engine shut down in town as I did my errands it would pop up that there is an update now ready to install and the only place I have a connection to the internet is at home by wifi so its not as if it grabbed the download while driving. I don't trust these new vehicles due to all the crap they can decide to do while sitting for some days not running and run the battery down so most of the time if I know the truck will sit for a few days I plug in the battery tender I have mounted under the hood and so the only time the truck must have downloaded software was when it was sitting in the garage where the signal is awful but I have that tender plugged in and somehow it managed to download it. I honestly detest all this crap, way to easy to leave a person stranded.    Since I don't trust any of it I don't do the install of the already downloaded software until I get home and sometimes have even sat in the truck to watch what its doing as its going through the process to its conclusion as its not like it is set up that it will tell you the next time you fire up the engine that the update that was initialed actually installed or installed properly. Yes I can go into the updates and see the list. After I go through the install where I feel its safe to do so in case it breaks down as a result, I will plug in the battery tender after the fact to recharge as I don't know how much power its taking just to do the install and that can take a while for it to install. 
    • nfisherman
      Software Update

      By nfisherman · Posted

      Thanks for the reply. All settings were correct and the engine was off, as it was supposed to be. It turned out to be something simple. I took a drive for about an hour. I must have had a low battery without knowing it. The voltage gauge on the display looked ok. At the end of my drive, I shut off the engine and the update prompt came up and it updated normally. It’s ironic because one of the features of the update is a reduction of battery drain. 
    • kickass audio
      Software Update

      By kickass audio · Posted

      when it's greyed out that is it's way of telling you that it's downloading the patch in the background. Eventually it will be fully downloaded and then it will prompt you at ignition shut down to run the update. I highly recommend doing the update once you get home and can run it a few times. I've had several issues with updates not going the first time around and I had to retry the update multiple times in my driveway before it was successful.   Some updates are huge and take awhile to download. You can help it by connecting to your home WiFi and keep the truck on service mode for the ignition and keep it alive for awhile on a battery charger too. There are specs it needs to be in for updating such as a full enough battery charge, no running ignition, etc.
    • Chuck FB
      Software Update

      By Chuck FB · Posted

      I am not techy at all but wondered if you have the truck running but sitting still in park as some functions gray out as soon as the truck is moving. I believe in the settings for updates you can choose for it NOT to update and I wonder by chance if maybe that was chosen before and now it won't allow you to chose to press update, I think that is back in the settings menu where it has all the items one wants on or off etc. Also I assume you have a wifi connection and checked that it has some signal strength, not that it would have anything to do with the grayed out updates choice in that case. What I am thinking out loud of here may be be of no value but thought I would suggest it, sometimes it can be the simplest thing that resolves an issue.  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...