What have you done to your K2 today?

[TBaganATX]

What are the specs on these rims and tires? Size, offset brand and do you have a lift? These are the same rims I've been looking at.

Tires are Toyo MT 295/70/18. Wheels are Ballistic Razorbacks (I think) 18x9 -12 offset.

 

RC 2.5 with 3" rear block, replaced rear shocks w Pro Comp 9000 series, and still waiting on the front struts and to put my airbags back on off my F150.

 

the 20" Mt tire is just too rough for me.

 

Sent from my SM-G900V using Tapatalk

[desert]

[KRANK08]

 

Window tint and 2 inch front leveling kit added on Saturday.

 

Really like your setup. Can you tell me the details? Are the wheels oem? What size tires and type? What lift?

Edited June 25, 2014 by KRANK08

[dauthier]

Swapped the chrome caps and handles for body colour! On my A/T

 

 

Sent from my SM-N900W8 using Tapatalk

[Jay700]

Nfab bars covered with linex. Love linex

[KUUG]

Nfab bars covered with linex. Love linex

 

You already know pictures are going to be requested

[Jimenez1041]

Got 1 piece weathertech mats and Huskey gear box

 

2014 Silverado 1500 LT V8 4x4 All-Star Edition

[Kennedy81]

picked mine up from getting re-painted. I bought it off the lot with some cosmetic damage due to a tornado. I also had the bumpers powder coated black. I'm planning on getting the grill and headlight surrounds done in black also. I'll post more pics when it is all done.

[J-Jeezy]

Did you notice if te rear bumper warped any while it was being powdercoated?

[nomadicdogg]

Finally got my exhaust done on my 6.2 local shop did it. I love it. I went mild, nice deep tone. no drone, even when the afm kicks in. love it. pics tomorrow

[SlavO]

Cheap seat covers. Dickies,, Kennett- black/grey

[TX14Z71]

Cheap seat covers. Dickies,, Kennett- black/grey

Do you have a link for those seat covers?

[SlavO]

Dickies/2 pcs. black and gray seat cover

Part Number: 3001055

I picked them up at my local autozone

[Kennedy81]

Did you notice if te rear bumper warped any while it was being powdercoated?

 

Not that I noticed. If metal is going to warp during powder coating, it would be during the prep phase when the media blast it. If whomever does it just uses sand/silica, it can cause more friction and heat the piece up and cause it to warp. When blasting stuff like this, they really need to use a "soft" media, like walnut shells or plastic pellets.

[CoasterCOG]

Wash, Wax, painted tailpipe black to match my exhaust tip, finished pasti-dipping emblems, oh and installed LED tail lights that just came today!