Jump to content

Paint / Color matched Door Handles & Mirror Caps

thewhitestallion

Recommended Posts

  • Replies 130
  • Created
  • Last Reply
Jsmith86 Enthusiast

Jsmith86

Posted
Posted

Where are you located?

I bought some chrome caps a week or so ago from 1aAuto.com. I'll sell my black ones if you want them for 15 plus shipping. They are the textured ones, non painted.

NoLand Enthusiast

NoLand

Posted
Posted

I bought some chrome caps a week or so ago from 1aAuto.com. I'll sell my black ones if you want them for 15 plus shipping. They are the textured ones, non painted.

Thanks, but I'll pass. I was thinking they were the painted caps. How much did the caps run from 1aAuto?

Jsmith86 Enthusiast

Jsmith86

Posted
Posted

Thanks, but I'll pass. I was thinking they were the painted caps. How much did the caps run from 1aAuto?

I believe they were 65$.

  • 7 months later...
Slabsides45 Enthusiast

Slabsides45

Posted
Posted

Sorry for the Frankenthread, but figured it beats starting a new one.

 

Anyone want to swap mirror caps?  I have a 2015 Brownstone colored Silverado LT, has the brown color DL8 mirror caps.  Looking for chromed variety.  

 

Also have a set of 4 Brownstone Metallic door handles, already broke down and bought the chromed version of those so will sell the whole set for $75 shipped if anyone wants them.

ecrouch Enthusiast

ecrouch

Posted
Posted

I guess since the old thread got started up again.

 

Anyone have any current good leads on where to get color matched door handles and body moldings?  Or want to swap for my Chrome ones? 

 

I need Crimson Red. 

 

Also would be willing to switch out my Chrome Mirror caps with someone for the black ones. 

 

 

  • 2 weeks later...
Carter8 Enthusiast

Carter8

Posted
Posted
On 2017-09-16 at 9:42 PM, trp3383 said:

I have a set of Painted black handles from my 2017 silverado double cab I just traded in for sale. PM me or send to trp3383 at gmail

Do you still have these and any pictures 

2014sierra-rich Enthusiast

2014sierra-rich

Posted
Posted

I’m looking to color match my iridium truck. If anyone has iridium they would trade for my chrome ones, or knows where to get a set let me know.


Sent from my iPhone using Tapatalk

  • 5 months later...
samckitt Enthusiast

samckitt

Posted
Posted
On 7/18/2014 at 8:16 AM, tutiii said:

Here are the numbers for paint to match door handles and mirror caps, also the window trim

Qty
4 13583889 Door handle kits
1 13583891 Passenger Door Handle Cover
1 13583894 Key Bezel
2 13585748 Rear Door handle cover
1 22919757 Mirror cover
1 22919758 Mirror cover
1 20964063 Front Left Window Trim
1 20964064 Front Right Window Trim
1 20963927 Rear Window Trim
1 20963928 Rear Window Trim

I know, old thread, wondering what years these parts cover.  Do these fit an '18 Sierra as well?  Was looking up the parts online & the window trim pieces are discontinued?

  • 1 year later...
Likarok Senior Enthusiast

Likarok

Posted
Posted

Found this old post. But I have to say that since the new trucks came out it is like the 14 to 18 trucks completely fell off the radar. Thinking of swapping the chrome mirror caps and door handles on my HC for Graphite Metallic body colored ones and they are virtually impossible to find. Have not tried a dealer because of Covid but it is looking like my last resort.

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • Another JR
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By Another JR · Posted

      Have considered installing a DC to DC charger in your camper to replace your isolator?  
    • newdude
      Gas fill door

      By newdude · Posted

      Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • newdude
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By newdude · Posted

      No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • jaszr2
      Active Grille Delete

      By jaszr2 · Posted

      Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...