Stock wheels on lifted trucks!

WendysOrBust · August 20, 2015

It's not a thread about specs! He just wanted to see lifted trucks on stock rims.

It just makes sense to post up your setup specifications to filter out the "what size tire/lift" questions that fill up the thread. It takes two seconds to post up tire size and lift specs. I'm not sure about anyone else, but when I like particular setups I save the picture and make notes on wheel and tire size, offset and lift, soooo useful if you are looking for a particular look and finish.

/rant

JUSTINASS · August 20, 2015

RC 2.5" Toyo Open Country MT 33x12.5x20

Tim99GT · August 20, 2015

It has a 4.5 inch Zone lift with 35x12.5x20 Nitto Trail Grapplers on stock rim. There is no spacers.

How bad does it rub? Did you have to do any cutting to fit those tires?

Great looking truck btw!

Edited August 20, 2015 by Tim99GT

XMR15 · August 20, 2015

How bad does it rub? Did you have to do any cutting to fit those tires?

Great looking truck btw!

Thank You!

I'm pleased in how it turned out

They don't rub at all. No cutting or modification were required either! I was told it may tag the front plastic valence however I had it off previous to the lift and tires so not sure about that. I notice you have yours off as well anyway.

pbjeep · August 21, 2015

It's not a thread about specs! He just wanted to see lifted trucks on stock rims.

It has a 4.5 inch Zone lift with 35x12.5x20 Nitto Trail Grapplers on stock rim. There is no spacers.

How's the ride compared to stock with that lift. Best looking truck I have seen on here. I had the Nittos on my ram 2500, didn't care for them after about 15000 miles. they pulled really bad. Post more pics I am really rethinking level vs lift now.

XMR15 · August 21, 2015

It's not a thread about specs! He just wanted to see lifted trucks on stock rims.

It has a 4.5 inch Zone lift with 35x12.5x20 Nitto Trail Grapplers on stock rim. There is no spacers.

How's the ride compared to stock with that lift. Best looking truck I have seen on here. I had the Nittos on my ram 2500, didn't care for them after about 15000 miles. they pulled really bad. Post more pics I am really rethinking level vs lift now.

Why thank you! Means a lot.

The ride isnt much different than stock to be honest! Still smooth and runs straight as an arrow. I had a gentlemen ride with me the other day and commented how how nice it rode. Said you wouldnt think it had a lift!

I would def suggest zone or bds (very similar). You wont be dissapointed with those lifts. Pay for what you get in my opinion.

I will post more pics tomorrow. I'm at work and only have a few in my email. Only other one I have at the moment.

eznonby · September 15, 2015

XMR15 your truck is badass. I have been looking for a 4" on stick wheels setup for a month or so. I'm wanting to do the same setup on my truck with the chrome 20's that come on the Silverados and run 35 Toyo MT's I it. I have been undecided between the 3.5" RXC or the 4" BDS. Do you know your fender measurements or could you get them for me?

peejaykay · November 14, 2015

Anyone running 33x12.5x18, stock wheels...no lift?

CBRAGA · November 14, 2015

It's not a thread about specs! He just wanted to see lifted trucks on stock rims.

It has a 4.5 inch Zone lift with 35x12.5x20 Nitto Trail Grapplers on stock rim. There is no spacers.

How much did the track width change in the front? Did you run rear spacers to even it out?

TX_AT · November 16, 2015

6" BDS lift, 35x12.5 on stock AT wheels

Sierra1500mm · November 16, 2015

6" BDS lift, 35x12.5 on stock AT wheels

Great looking truck man!

Sent from my iPhone using Tapatalk

XMR15 · November 16, 2015

It's not a thread about specs! He just wanted to see lifted trucks on stock rims.

It has a 4.5 inch Zone lift with 35x12.5x20 Nitto Trail Grapplers on stock rim. There is no spacers.

How much did the track width change in the front? Did you run rear spacers to even it out?

The track width definitely increased, however it isn't that much. I don't have spacers in the rear because it is fairly close, but they probably could use a 1 inch spacer at most to match the fronts.