Jump to content

Recommended Posts

Posted

It cannot be removed per se, but the limit can be increased by altering the calibration.

Posted

You really have the need to go faster then 100 mph? Have you ever seen a driveshaft that is not designed for those speeds come out at 100 plus mph? You ever seen a tire blow out that is not designed for high speeds. Make sure your the only one on the road if your going to go faster then 100 mph.

  • Like 1
Posted

What's the cheap and best way to remove the speed limiter for 2016 Silverado High Country 6.2.

You have a 50+ thousand truck and your looking for a cheap way.... come on man!!!

  • Like 3
Posted

Just about any tuner can change the limiter. Be aware that you will run into issues exceeding the speed rating of your tires and potentially the drive shaft.

Posted

2014 and newer trucks have the option in the ECM to have the BCM control the speed limiter. If that is enabled in the ECM a hand held tuner may not change the speed limiter. You can do it with EFILive and probably with HP tuners software.

 

 

Jay

Posted

You can get a superchips programmer right off their website for 280 bucks shipped. It will change the speed limiter. You can also change tunes or leave it stock. It will also disable afm so you can keep the truck from kicking into v4

Posted

You have a 50+ thousand truck and your looking for a cheap way.... come on man!!!

Because I'm not planing to tune it and only looking for one function.

Posted

Know anyone with EFILive or HP tuners? You could get someone to do it for the cost of a VIN license. $125 for EFILive.

 

Jay

Posted

Know anyone with EFILive or HP tuners? You could get someone to do it for the cost of a VIN license. $125 for EFILive.

 

Jay

But I need to return it stock before service.

 

Will this do the job: Hypertech Max Energy 2.0 Tuner for 2014-2015 Chevy Silverado 1500 6.2L EcoTec3 V8.

Posted (edited)

Just did mine this morning oddly enough lol. The pic that Jay P has is correct.... just switch it to ECM and then set it to whatever you want it at...... or so high the truck could never reach it. I used EFILive after I updated it to the latest and greatest and licensed my ECM. It's $125 to buy a license..... but I already own the software so that's not what it costs someone else lol. My trucks speed limiter is now dead and active fuel management is shut off permanently. Those were the 2 biggest things I actually cared about lol.

Edited by 1994Vmax
Posted

But I need to return it stock before service.

 

Will this do the job: Hypertech Max Energy 2.0 Tuner for 2014-2015 Chevy Silverado 1500 6.2L EcoTec3 V8.

 

If you are worried about warranty they will look for reflashes on a big claim anyway.... but if you are worried about them just updating and overwriting you then I see the point.

 

The Hypertech says right on their site you can set the limiter as high as 255 mph so yes it would work.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Oil pump noise was discussed before.  I will try to remember to record a remote start later this morning. 
    • There are probably a few threads talking about fuel mileage but this one seemed to fit the stats I have seen based on my typical local driven route but with different outcomes based on different seasons/temperatures. I have a few hundred pounds of items that consistently ride on the truck at all times such as a bak flip cover, rubber bed mat, tools and extra fuel so I would be something over 8100 lb without me in the truck. All these examples are based on a 100 mile round trip to a town plus running around town so maybe 110 to 120 miles in total for a trip. Using regular fuel and I assume it always has some ethanol in it but don't know the percentage they blend in. Also speed wise I am going at 62 mph and non aggressive driving although less speed yet if its crappy winter condition roads. I am going by an initial reset of the computer generated fuel use numbers averaged over a couple of thousand miles or so for each weather/season so they may be more optimistic then actual hand calculated numbers. Basically this is painting a picture of doing the same drive but seasonal conditions and temperature being the major variable to the end result. Oh and although I am in Alberta Canada, I am converting it to miles per US gallon so there is no confusion.    So winter time it gets cold here, no real surprise there and the roads can be clear at times but also often have packed rough snow or are are driving through loose snow ( they do a poor job of plowing the highways ) and yes this includes the extra idle engine time due to trying not to freeze ones butt off. 12.7 mpg is what I was getting during the winter months on average.    Then during the spring when it was around the freezing point and the highways are clear of snow, I was getting around 14.25 mpg.   Summer time, I have been getting around 15.15 on average but certainly some of the trips showed quite a bit better fuel mileage, so much depended on how much or little I had driven around town and number of engine restarts after sitting for a while at each location. But stating a best fuel mileage trip to town pretending that is what the truck gets on average is fooling ones self for sure !.      As I said in a different post, I had driven a 645 mile trip over a couple of days stint to a different destination then these other daily to town examples above, and was done during the summer with nice weather and not bucking a head wind, also keeping at 62 mph and its a rolling landscape type highway drive ( this isn't southern Alberta or Saskatchewan flat lands ) Hand calculated fuel mileage in this case though and it came out to 17.65
    • On my wife's 2020 Blazer (~69000 miles), we started to notice the brakes pulsating at faster speeds. Typically around town you don't notice anything, but highway/interstate driving you will notice it. I decided to pull of the front tires and look at the brakes. I figured with the milage, the pads should be wearing out to their life span, but they actually looked decent. Still with "meat" on them. One pad has a ridge wearing in it, and that same rotor is showing the ridge too. That's not the concerning part...the other rotor appears to have a raised bump on it!  The picture make it look like a pimple! Very odd and strange! NOTE: These are the factory brakes and rotors.   I'm attaching pictures of the front brakes and what they look like ate ~69000 miles.
    • 2024 Chevrolet 2500 HD Custom 6.6 Gas Canadian built Truck  I tried to search for my previous thread on this topic but cant find it so my apoligies  for starting another one    #1   Since we have owned our truck purchased new it has this strange noise after using the remote start function  you press the remote start and you hear it start but right at the end of it starting it almost seems like it wants to start again after the truck is running .   There is no gap in time it is right at the end of the start . Almost sounds like when you have started a car/truck and its running and then you try and start it again and you get that grinding noise ,sort of     #2  You can only hear this if you are standing outside of the truck and near the truck  you cant hear it when you start the truck from inside  the cab . So it may very well be happening when starting the truck that way as in normally    #3   This only happens when it is started after sitting . For how long I don't know but it happens after sitting overnight for sure and it wont do it if you stop the engine after starting and then start it again  I have had it in to the Dealership before concerning this but they did not have the truck  when it was cold to hear it . Now its back in the Dealership left it overnight so they could possibly hear the problem . They said they tried and nothing happened . Well they did not know what they were listening for . I started the truck remotely and BINGO it makes the noise . Oh that sounds weird they say . We need to look into it ! I have left for this week at the Dealership    Does your 2024 2500 HD gas do this ?  Any of you fellas care to take the time and trouble to film this operation from a cold start  so I can hear what your sound like  Really  would like to know if this is anormal sound  Thank You Fellas !!
    • 2026 Z71.  The other day I was backing a trailer into the barn.  The alarm was going off just because the trailer was in the field of the warning sensors when you get too close to something.  For some reason now the warning alarm doesn't work anymore.  It used to go off when I was just normally backing my truck into garage.  I still have the guidelines in the back up camera.  Is there a button or something to push to turn the sound/Alarm on and off?  I have the touch screen in this truck.  There isn't a "P" on the dash except for the parking brake.  I can't find anything in the touch screen under settings or vehicle.  Thank you in advance.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...