Jump to content

Recommended Posts

Posted

So I am in the process of buying my first Silverado. It is a 2015 black edition left over brand new. Just learned it is only 2wd and I live way upstate New York. Winters can be a little harsh. Since I never owned one I am curious how the RWD 2wd will be in the winter?! It's such a good deal I hate to pass it up! Thoughts?

Posted

Plenty of people with 2wd in snowy areas. Knowing how to drive, some weight, and decent tires help

Posted

Well my neighbor has a 2WD truck and has gotten stuck on wet grass before and I give me grief telling him he has a grocery getter with a bed on it.

IMHO only no way I would have a 2WD here, let alone up there where you are unless you have a good job where you can work from home and not be out on the road much during winter time.

Don't get me wrong I have seen plenty of 4WD stuck in the snow, but they have a much better chance of not getting stuck than a 2WD

Posted

I've done just fine during my winter stays up in MN with my 2wd. As mentioned earlier, you just have to be a bit more cautious, and can toss some tube sand in the bed over the axle as well for a peace of mind. 4wd would definitely be beneficial in the event that you don't leave yourself some extra time to reach a destination (which can vary depending on the conditions)

Posted

I'm in my first 4 x 4. I will never own another 2 wheel unless I'm back in a warm climate. :happysad:

Posted

I look at 4WD like insurance....you don't always need it,but nice to have it when you need it.

Posted

Snow tires.

 

Snow tires.

 

Snow tires.

 

A little ballast in the rear won't hurt either.

 

Sent from my SM-G920V using Tapatalk

Posted

I've done just fine during my winter stays up in MN with my 2wd. As mentioned earlier, you just have to be a bit more cautious, and can toss some tube sand in the bed over the axle as well for a peace of mind. 4wd would definitely be beneficial in the event that you don't leave yourself some extra time to reach a destination (which can vary depending on the conditions)

I lived in north dakota with 2wd, there is a huge difference in new england because it's so hilly and curvy. The roads have to navigate and swerve through the hills. I would never ever live in new england with a rwd pickup. Fwd at a minimum. You would need a ton of weight in the bed and real dedicated snow tires for life not to be a pain in the ass.

Posted

Snow tires make a HUGE difference - studded blizzaks if possible, and some weight in the back helps. Truth be told a 2WD truck w/ studded snows will turn, handle, grip, & stop better than a 4WD truck w/ all seasons or AT's, the 4WD gains advantage from a dead stop in sloppy conditions or under engine load/throttle while turning.

 

But I run snows on my 4WD truck, so I have the best of both worlds :smash:

Posted

I personally think you'll regret buying the 2wd. The fact that you are asking the question leads me to believe you are having doubts. A two wheel drive, properly equipped, will manage snowy conditions but not as comfortably as a 4 wd.

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,840
    Total Members
    8,960
    Most Online
    appletrav
    Newest Member
    appletrav
    Joined
  • Who's Online   1 Member, 0 Anonymous, 254 Guests (See full list)

  • Latest Articles

  • Posts

    • This is a 1/2 ton thing ONLY.  All HDs 2020-2026 have the two speed transfer case, with Autotrac as an option.     1/2 tons 2019-2026, regular 4x4s come with a single speed case (no 4LO!), and trucks with Z71 ordered, or all Trail Boss trucks come with the 2 speed case.  2 speed case is also an option on WT, and is also standard on High Country.  
    • 2013 5.3 still to this day calls for the PF48 filter.  Which as a 15psi bypass pressure.     There is a TSB, 17-NA-157 that talks about the PF-63 and PF-64 filters which have a higher bypass rating of 22psi.    TSB HERE - temp.xml   "Beginning in 2012, the oil pumps began to regulate main gallery feedback instead of pump out pressure. This means that the oil pump now does not begin to regulate until pressure is built up to the main gallery. This change reduces the amount of time it takes to provide oil to the engine bearing and lifters during extreme cold start conditions.  Main gallery feedback oil pump control systems are present on the following engine families which use Spin-on oil filters: Small Gas Engine (SGE), Large Gas Engine (LGE), High Feature (HFV6) Gen2 and Small Block Gen5 gasoline engines. These engines with the main gallery feedback oil pump control systems are factory built with an ACDelco® oil filters"   It also calls out what engines use those filters.  The gen 4 small blocks were not on that list (LMG, LC9, L9H, L92, L94, L20, L96).  Gen 5 small blocks use the higher pressure filter.          That all said...   Your 7045 Napa filter is the PF63 equivalent, with 22psi bypass.  You are already using the higher bypass pressure filter.  You CAN keep using it, you don't technically have to use it though.  
    • Do you know WHY the filter relief setting was increased to 22 psig?    When the new system goes into the second stage the pump volume ramps up considerably. It was found that the 15 psi filter bypass setting put the filter in bypass on a warm engine when the second stage was activated. Raising the filter bypass setting forced the filter to do what it designed to do. Filter. Preventing debris from circulating during high load, high rpm operation.    So next question is how did GM find this out? VLOM/lifter failures and a deep dive by Melling Corp.    Last question. Is it required? Look at it like this; a motor may be equipped with a rev limiter. But it only works if the set point in reached. That 22 psig setting only matters if the pressure differential across the filter media exceeds 15 psig during normal warm operation. Second stage kicks in around 3000-3500 rpm.    I can't answer your question because I don't know you and how you use the truck. But I think there is enough information here to let you decide for yourself. 😉
    • Probably not their first rodeo, so it should go as planned most likely.  Typically the service manager or tech doing the swap will put some seat time to shake it down after they get it all put back together.  We usually put 50-100mi before we hand them back so if something happens, its not after you get it.  A coolant leaks, oil leaks, a ground left off or loose, vibration, etc.     The new engines so far have been good?  There's been a couple that have popped out there again (the replacement engine) but most have been okay.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...