Jump to content

Recommended Posts

Posted

I have a 2014 Sierra 1500 SLE. My door locks just started constantly locking/ unlocking by themselves. It only happens when the battery is on, like when I unlock it or open the door or when it’s running. I’ve checked mostly all the wiring, and fuses. Disconnected the battery numerous times. Checked all the grounds. Disconnected both door lock switches, still does it. Took apart my remote key just in case it was telling it to lock. I even disassembled the Body Control Module (BCM). I ordered an OEM BCM specific to my model and year. I also noticed, while it was sitting with everything off that my radio screen lights up intermittently. This is why I think my BCM is bad.
 

2 questions:

 

1: will I have to program the ordered BCM? I know if I made upgrades I would but I haven’t and the truck is still stock.

 

2: Where is my keyless entry receiver/ transmitter  located on my truck? This is one of the only things a haven’t ruled out. 
 

Any helps is much appreciated.

Posted
12 hours ago, Jason Stephenson said:

I have a 2014 Sierra 1500 SLE. My door locks just started constantly locking/ unlocking by themselves. It only happens when the battery is on, like when I unlock it or open the door or when it’s running. I’ve checked mostly all the wiring, and fuses. Disconnected the battery numerous times. Checked all the grounds. Disconnected both door lock switches, still does it. Took apart my remote key just in case it was telling it to lock. I even disassembled the Body Control Module (BCM). I ordered an OEM BCM specific to my model and year. I also noticed, while it was sitting with everything off that my radio screen lights up intermittently. This is why I think my BCM is bad.
 

2 questions:

 

1: will I have to program the ordered BCM? I know if I made upgrades I would but I haven’t and the truck is still stock.

 

2: Where is my keyless entry receiver/ transmitter  located on my truck? This is one of the only things a haven’t ruled out. 
 

Any helps is much appreciated.

Pretty confident you will have to go to the dealer to have the BCM programmed.

 

Receiver should be in the back corner of your cab, passenger side, by rear window.

Posted

1) Yes it will need to be dealer programed to your VIN. I cant confirm whether or not it will run long enough to drive to the dealer but it should at least run without programing. It may run but put it in limp mode. It's done through the OBDII port so you will need to have the truck and BCM both there. Maybe if you order through GM they can have it pre-programmed to your VIN? 

 

2) Can't help you here. 

Posted
1 hour ago, L86 All Terrain said:

1) Yes it will need to be dealer programed to your VIN. I cant confirm whether or not it will run long enough to drive to the dealer but it should at least run without programing. It may run but put it in limp mode. It's done through the OBDII port so you will need to have the truck and BCM both there. Maybe if you order through GM they can have it pre-programmed to your VIN? 

 

2) Can't help you here. 

Thanks I appreciate it.

Posted
3 hours ago, JimCost2014 said:

Pretty confident you will have to go to the dealer to have the BCM programmed.

 

Receiver should be in the back corner of your cab, passenger side, by rear window.

Pulled the trim apart rear passenger side by the rear window and nothing, just wiring for rear cab light and window defrost. I even pulled apart the door panel with no joy.

Posted
15 minutes ago, Jason Stephenson said:

Pulled the trim apart rear passenger side by the rear window and nothing, just wiring for rear cab light and window defrost. I even pulled apart the door panel with no joy.

Found this from a post of the previous body style:

 

If neither of those things are causing the concern, it may be an RCDLR antenna or RCDLR issue. They are located behind the "C" pillar trim on the passenger side of the vehicle, if you privy a look.

Posted
2 hours ago, JimCost2014 said:

Found this from a post of the previous body style:

 

If neither of those things are causing the concern, it may be an RCDLR antenna or RCDLR issue. They are located behind the "C" pillar trim on the passenger side of the vehicle, if you privy a look.

Not sure what you mean “C” pillar trim. The trim in between the front and rear seats?

Posted
32 minutes ago, Jason Stephenson said:

Not sure what you mean “C” pillar trim. The trim in between the front and rear seats?

A pillar is the windshield, B pillar would be the doors, and the C pillar would be the rear window area, hope that makes sense.

Posted

Funny thing is the locks stopped acting up. I think it has some to do with the fact that I just started to use the rear defrost a lot lately and the damn thing is right next to the discharge.

  • 4 years later...
Posted

I was preparing to take my truck to the dealership to be reprogrammed, but I was leaving on a camping trip so I just disconnected my battery terminal for 2 days and when I came back the problem was resolved. I suspect that the dealership isn't reprogramming it at all I suspect they're doing a hard reboot

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • 2020 2500 HD...I had some trouble getting the key into the ignition switch but went in fine after applying some extra effort. Since then, the door chimes when open when the key is out of the ignition. Also, when I lock the doors with the switch on the arm rest, the driver door locks but then unlocks. (I can lock everything fine with the fob) The message on the little screen displays the "Engine Hours"...kinda weird.   I'm guessing something happened to the ignition switch and it thinks the key is still in there. I unplugged the batteries for 20 minutes, no change. There are a number of videos on YouTube but nothing I can find that address this specific issue. Ideas appreciated, thank you.
    • Based on what I can tell, yes.   As for updating it, its a mixed bag.  Updates do fix a lot of issues, but occasionally can create some oddities.  They do more good than harm though overall.     Here's what the most current one does and a  V171 Improvements Important: Improvements will vary by model, build configuration, system, and sales region. Not all vehicles have all features. OnStar and Wi-Fi may not work after remote start CarPlay may not automatically reconnect Part of the Driver Attention messaging screen may be in English even though the language is set to something else XM may not work After a dead 12V the radio may set to Arabic at each startup Bluetooth contacts might not be able to sync with the vehicle During an OTA the 12V battery may drain Customer might see a screen telling them to return to the dealer After changing the Wi-Fi SSID or password a device may not disconnect If a device is connected on the 2.4Ghz band, nothing will connect to the 5Ghz one, which could show as slow Wi-Fi speeds Customers might have noticed Wi-Fi dropping in certain areas and reconnecting later Customer might see the top of the screen blinking during Android Auto Android Auto may not connect CarPlay audio might momentarily cut out The "Add Phone" button may be grayed out The radio may not start up   V167 Most Notable Improvements:   Outside Air Temperature is incorrect. -You may see a popup message for Engine Shift. (Corvette Only) After changing the exhaust sound they get a popup that "mode change not applied", even though it was. -When changing volume, the volume bar is for Traffic instead of Audio. -(Corvette Only) Improvements to the placement of buttons and text. -If the customer receives the message "Apple CarPlay Could not connect", the cursor might move in the opposite direction than expected when using the control knob. -Android Auto automatically starts playing their music, even though they have turned that off in settings. -Intermittently they have a red OnStar LED with no OnStar function and/or no audio. -The minimum length of the Wi-Fi password was increased to 12 characters. -The popup message "Driver Attention Check, check your mirrors or Super Cruise will shut down" may not have come up on the display when it should have. -Startup animation added for 20th anniversary of the V-Series on Cadillacs. -The Navigation app received location improvements when going under long underpasses. -In the Navigation app there are filters for charging points that the vehicle cannot use.   V164 Most Notable Improvements Most notable improvements contained in this release may include: Apps Intermittently, an “SD Card Removed” message will pop up in the Navigation app. While in the audio app, the radio may stop working. Trailer Tire Pressure sensors may not be learned in the Trailer app. Not being able to return to the home screen while in the Camera app. After an ignition cycle, the radio might go to a black screen or stop working if using Sirius XM. Spotify icon truncated on Audio app.   SXM When changing power modes with the ignition switch, the HVAC pop up might appear. During startup, the radio will show the brand splash screen then go blank. Receiving a confirmation pop-up when changing drive modes. A “Return to Dealer” message may appear on the radio screen. SuperCruise setting toggle may not work. System After an ignition cycle, the radio might go black or stop working if using Sirius XM (SXM). Settings When performing a factory reset, the radio may stop working. After performing a factory reset, the radio may stop working when trying to switch users. When trying to go into the Language section quickly after startup, the radio may stop working. Projection Wireless CarPlay cannot be connected after unpairing another wireless Android Auto device. When the Android Auto screen comes up to connect wirelessly, the screen may freeze if the Cancel button is pressed. Removed the Apple CarPlay Cannot Connect screen when a device fails to pair during the autoconnect process. CarPlay information may not show up in the audio app. Near Field Communications (NFC) chime may be heard when NFC does not work. The Cannot Connect screen does not pop up after the first connection on wireless CarPlay fails. Apple CarPlay is now functional in Guam. Over the Air (OTA) When a software update is cancelled, the downloading logo may still be displayed. Energy When using the Energy app, the radio may stop working. When plugging in the vehicle, the display might show “Now” instead of “Charging Upon Plug In.” Instrument Cluster Voice recognition can be started while on an OnStar or phone call. When downloading contacts, there is a progress bar and circles on the Recents page of the cluster. The temperature on the cluster and the display may be different. After receiving and ending a call on the secondary paired phone, the cluster may get stuck on the phone menu. Bluetooth Intermittent Bluetooth connection loss.
    • Looking for help troubleshooting a metallic like front end rattle. Figured I’d see if anyone had thoughts before I schedule an appointment with the dealer.   The rattle is fairly loud and occurs primarily when the front driver side wheel hits a bump, even fairly minor road seams. Sometimes does it when the passenger hits a bump but I don’t believe when the rear hits. Rattle still occurs when foot is pressing brake peddle so I think that rules out the caliper rattle I’ve read about. I’ve also checked the running boards and they are tight.   Most noticeable at slow speeds.    Any insight is appreciated. 
    • We try to make cruise the coast. It’s where our favorite casino is. I only want to spectate. Never took a car. Always had one to take. I belonged to a club once. Even when I used to drag raced. It was during test and tune. Probably because I’m not a night owl, party person. 
    • We had a pretty big cars and coffee in Indy this past weekend.  Pretty much anything and everything was there.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...