Jump to content

Recommended Posts

Posted (edited)

The titan tank in my 2009 was best mod beside Efi live . Stock 26 gal tanked sucked while towing . The 36 gal is a lot better and unless I was pulling more often won’t change.

Edited by BB&Chiveon
Posted

Also On the Titan discloser it indicates the DIC will be inaccurate. I wonder if GM has come up with a reprogram  solution like ford did

  • 2 weeks later...
Posted

Covid cabin fever got me, or I just got bored.  Ordered the tank from Amazon, I’ll post some pictures when it arrives and I’ll try to install myself in the driveway.

  • Like 1
Posted

I've been thinking about it too. Anxious to hear what your thoughts are and if the gauges read correctly. Good luck!

 

Posted

Gage might read funny, but I'm sure you can get a real good estimate of fuel in the tank, or just multiply the gallons buy MPG and theres your range.

Posted

Range is just a guess on how you might drive in the future...

 

Several ways to estimate range, just as accurately as the estimate from the computer 

 

Just like we did before there were 'guess-o-meters' for range. 

 

 

We might even do it better, if we know that we are going to getting better/worse fuel economy due change in the grades/speeds/loads/etc.

 

 

 

Posted

I don't think you will have to worry about range of fuel with that tank, the limiting factor will be the range of your bladder. I wish they made one for the cclb as I do think 36 gallons is a bit light for a dually.

Sent from my ONEPLUS A6013 using Tapatalk

Posted

I received the replacement tank earlier this week.  The box Titan ships the tank in is about 15 inches too long.  Box was beat up pretty bad, gouges in the cardboard where the tank straps poked through and ripped the cardboard as the tank and straps slid back and forth inside the box.  The tank is plastic and was in surprisingly good condition.

 

I tried to do the replacement in the driveway, but I do not have the tools to disconnect the “quick connect” fuel line fittings.  I got the old tank down, but was unable to disconnect the supply and return lines.  Clearances under the truck would have made it hard to get the new tank in place under the truck, it hangs down about two inched lower, and the top sticks up higher.  Going to a diesel repair shop next week to have the tank installed, I will let you know how it goes.

 

The tank uses the original fuel pickup and level sender, so I expect the fuel level gauge to work as the original, just take longer to fall off the FULL mark.  I have an iDash to backup that reading.  I do expect the ‘Range’ calculation to be off in the low direction.  After all, this tank is roughly 55% larger than the original equipment, so I expect the actual ‘Range’ to be half again further than reported.  I think that is a good thing!

  • 3 weeks later...
Posted

I was finally able to get the truck out for a road trip with the new Titan tank. After a fill-up I put 400 miles on the truck.  Usually takes 60-90 miles on the highway for the fuel gauge to come off the full mark.  The new tank went to 175 miles before falling below full, 40 of those miles were in town.  After the 400 mile trip the fuel gauge was at 11/16 of a tank.

 

The truck did a software update today, but I had to unplug the iDash from the OBD port before it would install successfully.  This is the first software update I have noticed the truck doing since I brought it home last February.  It has been to the dealership for a free oil change and tire rotation once.  They may have done an update then.

 

Photos show old and new tank installed from the driver's side, and a couple of the tank just after it came out of the box.

IMG_4134.JPG

IMG_4136.JPG

IMG_4138.JPG

IMG_4146.JPG

Posted

Only driven a couple of half tanks full so far, no problems.  I'm sure the miles to empty is off, it has not changed since going to the bigger tank.  A full tank shows about 700 miles to empty.  In 15K miles I have been averaging 18.9 MPG.  With a 36 gallon tank that's 680.4 miles.  With the larger tank it should be 1,058.4 miles.  The trucks computer is not aware of the extra fuel in the tank.  If you add about 50% to the trucks estimate, you will be closer to the truth.

  • 1 month later...
Posted
On 2/11/2021 at 3:37 PM, Major Tom said:

Only driven a couple of half tanks full so far, no problems.  I'm sure the miles to empty is off, it has not changed since going to the bigger tank.  A full tank shows about 700 miles to empty.  In 15K miles I have been averaging 18.9 MPG.  With a 36 gallon tank that's 680.4 miles.  With the larger tank it should be 1,058.4 miles.  The trucks computer is not aware of the extra fuel in the tank.  If you add about 50% to the trucks estimate, you will be closer to the truth.

 

Now that you have had it a bit of time - how do you like it?   the good (size), the bad (if any) and the ugly (if any). 

 

Thx 

Posted

The good is the extra 55% on-board.  With the cost of fuel going up, and the limits on credit card purchase at the local pump, that could be the ugly.  The bad for off road is, the lack of a tank skid plate and a metal shield between the driveline and the tank that the original equipment has.

 

All that being said, I’ll keep the Titan tank.  Can anyone use an original tank and straps?  Make me an offer.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,782
    Total Members
    8,960
    Most Online
    ShowMeShooter1332
    Newest Member
    ShowMeShooter1332
    Joined
  • Who's Online   1 Member, 0 Anonymous, 6,638 Guests (See full list)

  • Latest Articles

  • Posts

    • I was around and remember that era very well, so I'm calling b/s on that statement. If they were that bad no police department or taxi company would've bought a single one ... but they were used in both services (and fire) for DECADES. They were bulletproof and proven. Even the early 21st century ones weren't too bad! The early models were legendary.   Mine is proof, but people like atlas are blinded by agenda and refuse to believe facts right before their very eyes.   Even decades after they were built, a new generation started driving them, posting all their builds and shenanigans on Grandmarq.net and Crownvic.net. The failures would show up then, since they all were deep past 100k-150k miles by that point, and younger drivers tend to be a little aggressive, especially with vehicles than can lay a one-tire fire for as long as you hold your foot in it. They've more than proven themselves over the decades.   The only thing that'll really take them out is road salt. The bodies and sheet metal were garbage. A victim of the cheapout FoMoCo and GM have been partaking in before then, and since.   Today it's the stuff that counts - the undercarriage that rots away first!    GMs Caprice was no slouch either. Reliable as a stone ax - the opposite of what they build now.    
    • Let me know how your vehicles do in 10 years. You don't know ******, kid. 😂    There's a reason that Panther platform was used as police, fire, and taxi service for DECADES ... long before you were born, apparently.
    • If your connector also has a big lever to get the connector on and off, you don't want to force the lever either way, as it becomes a bigger problem if you bust the lever or the mechanism it works.
    • It's just useful to disconnect the battery to prevent odd shorting out when unplugging/plugging stuff together.  I also  touch the two cable ends together (after disonnecting) to drain the small amount of stored battery energy in various modules.   I believe the main system where you need to be more concerned with, so you need to do the above and then wait some time, iss when you are working on the air bag system, to prevent inadvertent firing of the air bags.   The in-cab switches are just that, plain switches, it's generally not a problem to swap them in/out.  For my '12, I'll get an error message on the dash if I power up the truck w them unplugged, but that's it (power up= turn the ignition on).   The ITBC located above the spare tire is a computer that manages the trailer brake system.  That is probably more important to have the battery disconnected.  It does have to be programmed to the truck, either before or after it's installed, for it to work.  For my '12, I had a very hard time reinstalling the main connector to it (IDK if yours is the same or not), it turned out the silicon seal was jamming up, preventing it from going on all the way.  I finally got it fully installed by lubing the seal with a bit of dielectric grease, then it slid on and latched in place easily.
    • JR ! I just got the truck back from the Dealership today . The technician did a cold remote start on the truck this morning and it made the noise . It was determined that it was a starter issue and replaced it under warranty . Of course   it did not make the sound after a new starter was put in because the truck was not cold . We will we see what happens tomorrow morning when I start the truck cold  . Keep tuned !   Oh I found a video on YouTube of a cold start and it did the same thing your truck and mine do , I will see if I can find it and post it up
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...