Jump to content

2012 Silverado reduced power issue

Bradley William Bumbie Babarovich
 Share

Recommended Posts

Bradley William Bumbie Babarovich New Member

Bradley William Bumbie Babarovich

Posted
Posted

My 2012 2500HD Silverado has a throttle body performance issue and reduced power problem.the engine has no power when you punch it the goes into reduced power.the flow master muffle isn't as loud as it was so I'm curious if it could be a back pressure problem the local dealership said I need to put the stock air cleaner system back on but I've had 5he spectra cold air on it for 4 years and the muffle is 5 years old  anyone run into this problem .I have new plugs ,wires,coils,new mass air flow sensor,cleaned the throttle body, the dealership is just trying to rack up some $$$ not give me a straight awnser after 600 bucks and all they did was change one oxygen sensor and not give me a definite awnser.

CamGTP Senior Enthusiast

CamGTP

Posted
Posted

Reduced engine power will show a code for why it did it.

 

Do you have that code?

 

If it's tied to the throttle body itself it could just be the throttle body itself that is the problem. Your intake or muffler swap isn't going to make it go into reduced engine power.

MORSNO Enthusiast

MORSNO

Posted
Posted (edited)

I've had two previous Chevy trucks do that too, it was the fuel pump both times.  I could idle and drive if easy on the throttle, but no power to accelerate fast or climb hills, pump was running but putting out very little pressure.

 

Edited by MORSNO
MORSNO Enthusiast

MORSNO

Posted
Posted

Let us know what it ends up being so we can all learn, thank you.

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Chuck FB
      Towing In Loose Gravel

      By Chuck FB · Posted

      Its possible you never had the joy of the crappy boat launches we tend to have around here or really some of them are just grades down to the river if its a river scenario and the conditions change all the time with the river levels and silt deposits. Some of the lakes we went to years ago, there was no such thing as a cement pad that went down into the water that the trailer stayed on, it was gravel maybe up to the water line and then duck crap much beyond that so sinking the boat tires into mud. Of course some of the more established lakes had a cement bar type boat ramp but sometimes it was covered in green slime closer and certainly within the water and a two wheel drive had all sorts of fun if one had to touch that slime with the rear tires.    A neighbor of mine had made a comment years back with his chev truck that was probably about the same year as yours but a half ton extended cab 4x4 and he a a fiberglass boat with an inboard so it wasn't a feather weight and he had gone out to one of the large popular lakes in the area and don't ask me how this happened but he was in two wheel drive as he figured he didn't require four wheel drive for that boat ramp and somehow upon pulling the boat out he twisted one of his drive axles. I suspect it must have spun and then grabbed on the cement ramp and shocked it to the degree of twisting it. He would have had the standard 8.5 or whatever it was axle housing as the 9.5 ring gear like my truck has also has larger drive axles as far as I know. Anyway he was feeling a vibration driving home and had it checked out and a shop found that the tire/hub was wobbling because of the axle had twisted so in went a new drive axle. After that bad experience he said he made sure to put it into four wheel drive to lower the stress on the rear axle. Of course that is where an HD truck can handle a lot more stress and no doubt these newer half tons with their larger ring gears probably have larger drive axles as well to match vs back in the day. 
    • asilverblazer
      2027 GMC Sierra: Official Discussion

      By asilverblazer · Posted

      Desirable - as in does someone WANT one, aspire to have one. Could reasonably buy any car they want and CHOOSE these instead.    I didn't watch the video, why did they win?
    • Atlas
      Towing In Loose Gravel

      By Atlas · Posted

      The use of absolutes like "always" to describe gear selection, and giving free advice at a boat ramp sounds like a recipe for disaster. It's a boat ramp, not a farm, for starters.   IMO gear selection should depend on the obstacle. If low range is working and this is a slower speed, controlled ordeal, I'd keep using that.
    • diyer2
      Towing In Loose Gravel

      By diyer2 · Posted

      I had a boat for many years, never had a problem even with a 2 wheel drive 93 Silvy for 20 years. Good tires, proper use of the gas pedal worked.
    • Chuck FB
      Towing In Loose Gravel

      By Chuck FB · Posted

      I read through that and I won't lie, my eyes rolled at some of the quirks about how it can turn off the trailer braking for example but I can see how it could help control or even up the torque applied to the ground with each wheel in a boat ramp scenario. But of course what it can't do is increase the torque to the wheels if the need is there as it ends up being like driving the four wheel drive version of a two wheel drive ( high range that is ). So far the neighbor that ended up with the 3.0 duramax with the max tow package which meant the 3.73 gears and high range only, I think its been doing ok for what he has been towing but doubt he ventures off into the soft stuff with his holiday trailer. He may have towed his dads river boat locally with it ( he always used his 6.6 duramax before ), I'll have to ask him sometime if he got into a lack of power to the wheels situation as after all that engine produces a lot of torque at low speed once the turbo winds out a bit and I think it has the 10 speed and if so they have a pretty good first gear ratio at 4.70 I see which is vastly better than the 3 or four speed overdrive models of years ago. 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...