Jump to content

Recommended Posts

Posted

Has anyone used the Kicker Hideaway powered sub? Im talking about the 8" power sub that will fit behind the seat(crewcab) NOT the GM/Kicker sub that mounts under the seat....

I am not looking for anything that is going to shake the windows anymore, i just want something that will make the stock radio(non bose) sound better.

Posted

I don't have any experience with either subs you mention. I do have a lot of experience with audio in general. Adding any sub will improve sound because it fills in the lower frequencies that are missing. 

I would also upgrade the stock speakers.

Posted (edited)

I will be installing the Kicker 46HS10 powered subwoofer in my 23 Denali in a few days.

 

Anyone know the easiest way and location to connect the speaker level wires?  I heard I need to connect to front speaker wires and not the rear.  I plan to locate the sub under the rear seat.  also what and where is the easiest way/location to connect the auto power on?  Should I pull the rear seat and make connections to the factory amp outputs there?

 

https://www.crutchfield.com/p_20646HS10/Kicker-46HS10.html?tp=114

 

Edited by typhoon186
Posted

I had the Kicker hideaway in my 2016 truck, its a nice unit that provides enough low end to the stock system.  I don't know how it will sound with the newer generation stock stereos but it was a nice addition to the previous generation.  

Posted

I got my Kicker hideaway 46SH10 installed.  Turned out nice.  Found it to fit PERFECTLY within the storage area under the rear seat with just a little trimming of the storage area wall.  It's exactly what I was looking for.  Small size with decent sound and easy installation at a good price.  It's not going to pound your chest when the base hits but it does a good job of filling in the low end on the new refreshed Bose system.  I mounted the base boost control under the dash just in front of the driver's knee (just above the .45) both for easy access.

 

IMG_9739.jpg

IMG_9750.jpg

IMG_9744.jpg

  • Like 2
Posted

Looks good, I am thinking of going this route for the new truck so will definitely use these pics for reference in the future. 

  • 2 weeks later...
  • 4 months later...
Posted
On 11/22/2023 at 7:22 PM, typhoon186 said:

Note- 

be sure to connect the sub to the front door speaker wires.   Not the rear.  

Can you tell me how you wired it all up? I have the same wiring questions as you.

Posted

removed the rear upper seat to access the factory amplifier.  Then just tap into the left front and right front speaker wires.  Sorry I can't remember the colors.

Posted

I put a Kicker 46HS10 Hideaway under my rear seat and I love it.  Really fills in the bass that was missing from the factory Bose system without rattling the windows....lol

  • 3 months later...
Posted
On 11/10/2023 at 6:58 PM, typhoon186 said:

I got my Kicker hideaway 46SH10 installed.  Turned out nice.  Found it to fit PERFECTLY within the storage area under the rear seat with just a little trimming of the storage area wall.  It's exactly what I was looking for.  Small size with decent sound and easy installation at a good price.  It's not going to pound your chest when the base hits but it does a good job of filling in the low end on the new refreshed Bose system.  I mounted the base boost control under the dash just in front of the driver's knee (just above the .45) both for easy access.

 

IMG_9739.jpg

IMG_9750.jpg

IMG_9744.jpg

 

Posted

No.  It's the factory bracket for the jack handle.  Just modified it to go over the sub.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Thanks for the point of reference 
    • Great question. Answer....depends. One the volume of the crankcase, the driver that will actually be using the vehicle and the amount it uses plus the distance expected for that next trip. Couple of for instances:   Wife is going to drive Dizzy to Moline and back plus a bit around town so say 500 miles on the day. I know from years with that SUV that around town and local rural it uses about a quart in 1250 miles. But on the Interstate and her at the wheel without her anchor nagging her she'll push it and it will drop a quart in about 800 miles. Hence, around town I wait to somewhere between a quarter down to a quart down. On her trip I'd top it if it was down a few ounces and hope for the best.    Have I overfilled one? You mean by adding before it needs a full quart I assume. No, not once after finding the true fill mark.  I know the dipsticks of everything I drive and add what it needs. I learn this by doing the first oil change a quart low. Run the motor for a few minutes. Let it sit over night. Check and mark. Then add half a cup at a time making note of the place on the stick. I add through the dipstick tube with a barbeque basting bottle. Give it a few minutes to drain down and check again.    A vehicle like Dizzy that uses this much oil will take a few quarts between 3K changes. I keep one in the vehicle with the bottle and a bag. (Mindful of it's fullness) Not a big deal and never makes a mess of it. There is no such thing as "multiple quarts' in my shop for any specific oil. There will be a maximum however of the number of different oils used over the fleet.     Dizzy holds a nominal 5 quarts. So the first fill was indeed over as it actually took 4.75. My vehicles are fit with Valvomax valves so I can meter an ounce on the drain if need be. Found her mark first crack at it. Never to be repeated.    Pepper uses none between changes so I don't keep a quart in that one. Straight up 6 quarts put her dead on the full line. Check it ever fuel stop. They will surprise you when they start using.    Raven holds 3 liters or 5.44 ounces over three quarts. I add 3 quarts and 6 ounces. That gives me 5 oil changes on my orphan quart.    Lawnmower holds about 3/5 of a quart. I don't over fill it to prevent an orphan. So yea, depends. 
    • 185k on original 6.2L engine and 10 speed. 6" lift with 35" tires. Changed oil (Mobil 1 synthetic) when truck told me to. Original tranny with original fluid and no service or flush done. All highway miles. A/C compressor replaced at 155k. Oil cooler line replaced at 180k. Still daily driver. Love this truck.   This is my 3rd 6.2L vehicle (2008 Yukon Denali / 2018 Cadillac Escalade) with over 150k miles and no issues. Denali had broken motor mount at 100k.
    • 185k on original 6.2L engine and 10 speed. 6" lift with 35" tires. Changed oil (Mobil 1 synthetic) when truck told me to. Original tranny with original fluid and no service or flush done. All highway miles. A/C compressor replaced at 155k. Oil cooler line replaced at 180k. Still daily driver. Love this truck.   This is my 3rd 6.2L vehicle (2008 Yukon Denali / 2018 Cadillac Escalade) with over 150k miles and no issues. Denali had broken motor mount at 100k.
    • Last three days, 12.75". Yesterday, 6" of it in under 2 hours. Lawn loved it, basement not so much. 😏
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...