Jump to content

Recommended Posts

Posted (edited)

Just curious your thoughts before I take it in my first service..2024 6.6 gasser

 

intermittent issues

 

1.  On some startups - brake pedal kicks back hard once motor turns over

 

2.  Belt squeal

 

3.  Intermittent hard downshifts, especially at low speeds in traffic

 

4.  Wireless CarPlay works fine most startups, then just won’t on others

 

5.  Lastly, no an intermittent issue, but a one time issue.  Truck stopped in reverse, bumped 4lo button, message in dash to shift to

neutral, pushed 2hi and message went away, drove off but during a short couple mile trip, heard grinding on slow turns, sounds like from the area of front diff

 

Any constructive feedback before I take it in and get a bunch of “could not replicate” at the dealer?

Edited by Meade2024
Posted

How many miles?  My 24 had some quirks when it was brand new, and have seemed to work themselves out.  Everything on new trucks is monitored and controlled electronically.  Sometimes, they need datapoints to function optimally.  Regarding your list:

1. Mine does that too, likely something normal with an ABS self check at startup.

2. That should be an easy dealer fix.  Non issue on my 24

3. I get that rarely on a 2 to 1 downshift, typically at stop signs or quick stop/starts.  I think the truck is anticipating your next move incorrectly.

4. No valuable input on this one

5. I think this was a one-off occurrence where you confused the transfer case mid-shift.  If the problem resolved itself, I wouldnt worry about it.

Posted (edited)

Thanks for some feedback…currently at 8000 miles

Edited by Meade2024
Posted
On 3/6/2024 at 9:19 PM, Meade2024 said:

Just curious your thoughts before I take it in my first service..2024 6.6 gasser

 

intermittent issues

 

1.  On some startups - brake pedal kicks back hard once motor turns over

 

2.  Belt squeal

 

3.  Intermittent hard downshifts, especially at low speeds in traffic

 

4.  Wireless CarPlay works fine most startups, then just won’t on others

 

5.  Lastly, no an intermittent issue, but a one time issue.  Truck stopped in reverse, bumped 4lo button, message in dash to shift to

neutral, pushed 2hi and message went away, drove off but during a short couple mile trip, heard grinding on slow turns, sounds like from the area of front diff

 

Any constructive feedback before I take it in and get a bunch of “could not replicate” at the dealer?

 

 

I too have the belt squeal -- on cold start up before and after work.  Dealer replaced the belt and idler pulley but it is still squealing.  I'm trying to figure out what is causing this.

Posted
On 3/6/2024 at 9:19 PM, Meade2024 said:

Just curious your thoughts before I take it in my first service..2024 6.6 gasser

 

intermittent issues

 

1.  On some startups - brake pedal kicks back hard once motor turns over

 

2.  Belt squeal

 

3.  Intermittent hard downshifts, especially at low speeds in traffic

 

4.  Wireless CarPlay works fine most startups, then just won’t on others

 

5.  Lastly, no an intermittent issue, but a one time issue.  Truck stopped in reverse, bumped 4lo button, message in dash to shift to

neutral, pushed 2hi and message went away, drove off but during a short couple mile trip, heard grinding on slow turns, sounds like from the area of front diff

 

Any constructive feedback before I take it in and get a bunch of “could not replicate” at the dealer?

This is certainly not what we like to hear, Meade2024.  Please know, customer satisfaction is extremely important to us. Our team would be more than happy to take a closer look into the concerns with your 2024 Chevrolet Silverado. To do so, please send an email to [email protected] with ATTN: Meade2024/GM Trucks in the subject line.

Please include your contact information, VIN, a brief description of your concern, and the name of your preferred dealership. We look forward to hearing from you. To learn more about GM’s Privacy Policy, please visit https://www.gm.com/privacy-statement.html. The information you provide may be monitored and recorded and is subject to the GM Privacy Statement.
 
Privacy Statement | General Motors
Your privacy is important to General Motors. This Privacy Statement addresses the personal information GM collects and how GM handles that personal information.
www.gm.com
 

Posted

“Wireless CarPlay works fine most startups, then just won’t on others”

 

I have this happen occasionally on my 2022. I haven’t kept track but maybe once every 100 startups so I haven’t considered it a terrible nuisance although it can be irritating. 

Posted
19 hours ago, 4x4Hank said:

“Wireless CarPlay works fine most startups, then just won’t on others”

 

I have this happen occasionally on my 2022. I haven’t kept track but maybe once every 100 startups so I haven’t considered it a terrible nuisance although it can be irritating. 

2022 Didn't have wireless CarPlay.

Posted (edited)

Y'all might not have ever noticed this is hydroboost setups, but if you hold the break pedal when the engine starts, it always "kicks" like that because the power steering system is boosting the pressure suddenly for the braking assist. This is normal, while some vehicles its more apparent than others. You don't notice it with the key start, because well you don't need to hold the pedal to start. If you hold the brake pedal only long enough for the start sequence to begin (basically push the button and let go) you'll never notice the pedal kick back.

Edited by carkhz316
  • Thanks 1
Posted
22 hours ago, carkhz316 said:

Y'all might not have ever noticed this is hydroboost setups, but if you hold the break pedal when the engine starts, it always "kicks" like that because the power steering system is boosting the pressure suddenly for the braking assist. This is normal, while some vehicles its more apparent than others. You don't notice it with the key start, because well you don't need to hold the pedal to start. If you hold the brake pedal only long enough for the start sequence to begin (basically push the button and let go) you'll never notice the pedal kick back.

Makes sense…but wouldn’t that occur everytime it starts?

Posted

It would depend on how much pressure was remaining in the accumulator. Mine does it nearly every time, though some times its less apparent. No braking issues in my currrent truck or any other I've had. That said, if its violent, then something may be wrong, but a little bump is normal.

Posted (edited)
On 3/12/2024 at 8:11 AM, CRApex said:

2022 Didn't have wireless CarPlay.

My 2022 does. 

Edited by 4x4Hank
Typo
Posted
15 hours ago, 4x4Hank said:

My 2022 does. 

You must have added it.  The wireless option was new to the 2024 model.

Posted
18 hours ago, 4x4Hank said:

My 2022 does. 

 

Did you buy used?  If so, someone added an aftermarket wireless Carplay interface.  As CRApex mentioned, factory wirless didn't get into the HDs until the 2024 refresh.  

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...