Jump to content

Recommended Posts

Posted

Rinseless warsh in mine and the wifes. I have a dent on the box so my pics are always on the driver side lol 2013-01-20_15-09-43_720.jpg

Posted

Added 5 gallons of DEF. Not to bad 19900 miles and this is only the third refill since new. I still think this truck is a keeper. :jester:

Posted

Added 5 gallons of DEF. Not to bad 19900 miles and this is only the third refill since new. I still think this truck is a keeper. :jester:

 

 

i wish GM put the DEF filler where ford does right next to gas filler

Posted

 

i wish GM put the DEF filler where ford does right next to gas filler

 

That would be handy but given what seems to be a long refill interval it isn't so bad. Though I did read the tank hangs down, which I don't particularly like.

Posted

Optimum

 

 

have you tried their new stuff with carnuba in it? Works great!

  • Like 1
Posted

Fully detailed the old thing. The wait for this body lift is killing me!

 

Sent from my SGH-I927 using Tapatalk 2

 

 

Posted

Reinflated tires for going back to school. A couple were down to 20 PSI. I saw a nail in one, but it's $18 to fix it and I'm out of plugs. I already have over $100 in repairs on this set of tires and don't want to spend any more this close to a new set. :lol:

Posted

Yes it is a pain to fill it under the hood, but this was the first time I had problems with the DEF containers!! It took about 20 minutes to get the spout on the first jug. And after I bought the DEF I saw where it was only $2.79 a gallon at the truck stop so next time I am going to fill it up there. :jester:

Posted

Changed the oil and took it through the car wash. Tomorrow im going to clean out the interior and hopefully change the rear end gear oil.

 

Sent from my Samsung Galaxy S3

Posted

 

 

have you tried their new stuff with carnuba in it? Works great!

 

Im going to get it come spring time.

Posted

Installed my HID's.

 

Left is the HID in a projector and right is the halogen in the factory housing

2013-01-21_19-45-17_501.jpg

 

Sent from my DROID RAZR MAXX using Xparent Red Tapatalk 2

Posted

That's a pretty nice difference Chris. My blind ass could use something like that.

 

Sent from my DROID RAZR using Tapatalk 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,912
    Total Members
    8,960
    Most Online
    RangerRick17
    Newest Member
    RangerRick17
    Joined
  • Who's Online   5 Members, 1 Anonymous, 557 Guests (See full list)


  • Latest Articles

  • Posts

    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...