Jump to content

What did you do with your truck/shop today

SarahsGMC

By SarahsGMC
in The Off-Topic Bar

 Share

Recommended Posts

Daryl LBZ Senior Enthusiast

Daryl LBZ

Posted
Posted
On the camaro forum I am on people are raving over vmax throttle bodies. I am tempted to get one. $150

 

Off of a 6.0 truck motor? How many mm are they?

  • Like 1
  • Replies 16.9k
  • Created
  • Last Reply

Top Posters In This Topic

  • Chris

    2024

  • RyanbabZ71

    1417

  • Jsdirt

    1327

  • SarahsGMC

    1181

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

C25A1guy
C25A1guy

Took my wife to labor & delivery. Daughter born.

Chris
Chris

I drove across town to pick up my degree since im still waiting on parts

srwoolc
srwoolc

Took my truck into the back country of Colorado.     Sent from my SAMSUNG-SM-G930A using Tapatalk

Posted Images

Chris Senior Enthusiast

Chris

Posted
Posted

I have heard the silver blade LS2 is good for F/I

RyanbabZ71 Senior Enthusiast

RyanbabZ71

Posted
Posted

Off of a 6.0 truck motor? How many mm are they?

 

No they are the stock throttle bodies ported. I forget offhand what size. You have to pay a core charge so they can keep the supply going

Jennabear Senior Enthusiast

Jennabear

Posted
Posted (edited)
I have heard the silver blade LS2 is good for F/I

 

Still only a 90mm. For FI, it is only a concern if air is being forced through the throttle body rather than pulled, like a Magnacharger.

 

Sent from a jelly bean.

 

Edited by Jennabear
zach1990 Senior Enthusiast

zach1990

Posted
Posted

Getting the exhaust fixed. One of the tips have broke loose and the rattle is driving me nuts

 

Sent from my SGH-I927 using Tapatalk 2

JaBradt85 Enthusiast

JaBradt85

Posted
Posted

Drove it 1,049 miles to and from Virginia(30 min south of Richmond) wed-today. I avg'd 19.7 mpg and 1.25 qts of Mobil 1 lol.

Carder09 Senior Enthusiast

Carder09

Posted
Posted

Installed new Pro-Comp ES9K's on the front. Tightest fitment in a truck I have ever seen/done. Really, they do not fit trucks with 2wd coil springs with 2.5in spacers like they claim. But, they did firm the ride up which is what I was looking for so time will tell.

RyanbabZ71 Senior Enthusiast

RyanbabZ71

Posted
Posted

At the lake

 

My truck and my cousins

 

4uja8u6e.jpg

 

edetu6yd.jpg

 

Dog went swimming

 

e6u7aput.jpg

 

 

Ryan

 

 

j-ten-ner Senior Enthusiast

j-ten-ner

Posted
Posted

I was sneeking around the GM dealer lot in my neighborhood again.

 

Looked at the new arivals of double cabs.

Climbed into the cabin and played on the knobs.

 

It's like "self punishmend" to resist the desire to go inside and grab the salesman.

 

so long

j-ten-ner

Chris Senior Enthusiast

Chris

Posted
Posted

I thought all gen 4's had either 87 or 90 mm throttle bodies.

 

Sent from my Samsung GS4 using Xparent Red Tapatalk 2

 

 

RyanbabZ71 Senior Enthusiast

RyanbabZ71

Posted
Posted

u5ahu8yr.jpg

 

My son actually fished with a lure for the first time :)

 

usuju7az.jpg

 

 

Ryan

 

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,911
    Total Members
    8,960
    Most Online
    jaszr2
    Newest Member
    jaszr2
    Joined

  • Who's Online   6 Members, 0 Anonymous, 550 Guests (See full list)

  • Latest Articles

  • Posts

    • newdude
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By newdude · Posted

      No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • jaszr2
      Active Grille Delete

      By jaszr2 · Posted

      Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
    • devonthegreat
      anyone interested in a 2002 Chevy Silverado 4x4 parts truck NYC

      By devonthegreat · Posted

      **SOLD** Please end or delete post. thank you
    • PBNB
      Tire pressure for 37s

      By PBNB · Posted

      Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...