Jump to content

Which level kit for RST?

jb177
 Share

Recommended Posts

scdaren Enthusiast

scdaren

Posted
Posted (edited)
5 minutes ago, Maize & Blue said:

Another thing to think about if their 1” rear lift block is really lifting the rear by 2” is your shock travel.  You’re going to bottom out your shock and will likely have a rough ride if you don’t replace the shock with a longer travel shock.

So far have not noticed any issues with ride or shock travel, but haven't done anything more extreme than a few speed bumps so far.  I'm thinking of keeping it how it is, looks more aggressive like that, and the front is up which is the issue that matters most to me.

 

If it's an issue probably whatever shock size they are using on the Trailboss would be right.

Edited by scdaren
  • Replies 68
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Jmike
Jmike

Finally got it back. turned out pretty good in my opinion. 35x11.50r20 ridge grapplers have just enough space between ball joint and tire. No rubbing no trimming. They do run a little small so same si

Jay Teez
Jay Teez

2019 RST Z71  2 inch Southern Truck Level kit lower strut mounted paid $395 out the door with alignment at local shop which did my last truck. My Closest dealership was using exact

Jay Teez
Jay Teez

updated with 285 60 20 Nitto Ridge Grapplers. No rubbing      

Posted Images

Jmike Enthusiast

Jmike

Posted
Posted

Well I'm going on day 2 without my truck back. The 35x12.50s were too wide and kept hitting the control arm. Tire shop is ordering the 35x11.50s and they will be in tomorrow.

Dmart Enthusiast

Dmart

Posted
Posted
9 minutes ago, Jmike said:

Well I'm going on day 2 without my truck back. The 35x12.50s were too wide and kept hitting the control arm. Tire shop is ordering the 35x11.50s and they will be in tomorrow.

That sucks hopefully the thinner tire will fit. I just ordered 295/70s so a little under 35s and thinner too. 

jb177 Enthusiast

jb177

Posted
  • Author
Posted
32 minutes ago, Jmike said:

Well I'm going on day 2 without my truck back. The 35x12.50s were too wide and kept hitting the control arm. Tire shop is ordering the 35x11.50s and they will be in tomorrow.

Is that with the stock wheels?

Jmike Enthusiast

Jmike

Posted
Posted
43 minutes ago, jb177 said:

Is that with the stock wheels?

Yes stock 20s. The guy at the shop said it cleared turning so hopefully the 1/2" will let it clear the control arm.

Jmike Enthusiast

Jmike

Posted
Posted
1 hour ago, jb177 said:

Was it rubbing at full lock while in reverse like the older body style?

 

No, the inside of the tire was right against the ball joint when mounted to the truck. 

Jmike Enthusiast

Jmike

Posted
Posted

Finally got it back. turned out pretty good in my opinion. 35x11.50r20 ridge grapplers have just enough space between ball joint and tire. No rubbing no trimming. They do run a little small so same size trail grapplers might require a little trimming.

IMG-0751.JPG

  • Like 6
scdaren Enthusiast

scdaren

Posted
Posted
44 minutes ago, Jmike said:

Finally got it back. turned out pretty good in my opinion. 35x11.50r20 ridge grapplers have just enough space between ball joint and tire. No rubbing no trimming. They do run a little small so same size trail grapplers might require a little trimming.

IMG-0751.JPG

Looks awesome!  Thanks for posting this I have the same wheels and want to do something similar.  You said you have a 3" lift? Was it just the ball joint you are having issues with?  I have a 2" lift and I'm thinking those tires could fit with that lift as well.

  • Like 1
Jmike Enthusiast

Jmike

Posted
Posted

Apparently they are different for the 19 (ford convert so not sure about previous models) and have a very small gap between the tire and ball joint. If you were going with aftermarket, I'm sure an offset would cure that but I wanted to stay stock for my wheels. I'd say nothing wider than right at 11.5" would work. The guy at the shop said they would have probably cleared with a 2" level but I wanted a little higher ride so went with 3" rough country.

scdaren Enthusiast

scdaren

Posted
Posted
2 minutes ago, Jmike said:

Apparently they are different for the 19 (ford convert so not sure about previous models) and have a very small gap between the tire and ball joint. If you were going with aftermarket, I'm sure an offset would cure that but I wanted to stay stock for my wheels. I'd say nothing wider than right at 11.5" would work. The guy at the shop said they would have probably cleared with a 2" level but I wanted a little higher ride so went with 3" rough country.

Sweet... yeah I want to keep the stock wheels I have, just like yours.

 

Your truck looks pretty level -- is it actually level or do you still have a slight rake?

Jmike Enthusiast

Jmike

Posted
Posted
7 minutes ago, scdaren said:

Sweet... yeah I want to keep the stock wheels I have, just like yours.

 

Your truck looks pretty level -- is it actually level or do you still have a slight rake?

I believe it has a slight rake but I can barely tell.

Dmart Enthusiast

Dmart

Posted
Posted
On 5/9/2019 at 2:02 PM, Jmike said:

Finally got it back. turned out pretty good in my opinion. 35x11.50r20 ridge grapplers have just enough space between ball joint and tire. No rubbing no trimming. They do run a little small so same size trail grapplers might require a little trimming.

IMG-0751.JPG

Looks awesome man. I guess I'll be the guinea pig for the readylift 4"

  • 3 months later...
mattt_1533 New Member

mattt_1533

Posted
Posted
On 5/9/2019 at 4:02 PM, Jmike said:

Finally got it back. turned out pretty good in my opinion. 35x11.50r20 ridge grapplers have just enough space between ball joint and tire. No rubbing no trimming. They do run a little small so same size trail grapplers might require a little trimming.

IMG-0751.JPG

What do you think of the ridge grapplers? I've always ran trail grapplers.

  • 2 months later...
Tyler Greymountain New Member

Tyler Greymountain

Posted
Posted

I used the Readylift level and I'm running 275/65/20 with no problem. I'm definitely looking into adding a block for the rear just so I can have that rake look. 

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • newdude
      Seems to be Missing a lot of Updates

      By newdude · Posted

      Based on what I can tell, yes.   As for updating it, its a mixed bag.  Updates do fix a lot of issues, but occasionally can create some oddities.  They do more good than harm though overall.     Here's what the most current one does and a  V171 Improvements Important: Improvements will vary by model, build configuration, system, and sales region. Not all vehicles have all features. OnStar and Wi-Fi may not work after remote start CarPlay may not automatically reconnect Part of the Driver Attention messaging screen may be in English even though the language is set to something else XM may not work After a dead 12V the radio may set to Arabic at each startup Bluetooth contacts might not be able to sync with the vehicle During an OTA the 12V battery may drain Customer might see a screen telling them to return to the dealer After changing the Wi-Fi SSID or password a device may not disconnect If a device is connected on the 2.4Ghz band, nothing will connect to the 5Ghz one, which could show as slow Wi-Fi speeds Customers might have noticed Wi-Fi dropping in certain areas and reconnecting later Customer might see the top of the screen blinking during Android Auto Android Auto may not connect CarPlay audio might momentarily cut out The "Add Phone" button may be grayed out The radio may not start up   V167 Most Notable Improvements:   Outside Air Temperature is incorrect. -You may see a popup message for Engine Shift. (Corvette Only) After changing the exhaust sound they get a popup that "mode change not applied", even though it was. -When changing volume, the volume bar is for Traffic instead of Audio. -(Corvette Only) Improvements to the placement of buttons and text. -If the customer receives the message "Apple CarPlay Could not connect", the cursor might move in the opposite direction than expected when using the control knob. -Android Auto automatically starts playing their music, even though they have turned that off in settings. -Intermittently they have a red OnStar LED with no OnStar function and/or no audio. -The minimum length of the Wi-Fi password was increased to 12 characters. -The popup message "Driver Attention Check, check your mirrors or Super Cruise will shut down" may not have come up on the display when it should have. -Startup animation added for 20th anniversary of the V-Series on Cadillacs. -The Navigation app received location improvements when going under long underpasses. -In the Navigation app there are filters for charging points that the vehicle cannot use.   V164 Most Notable Improvements Most notable improvements contained in this release may include: Apps Intermittently, an “SD Card Removed” message will pop up in the Navigation app. While in the audio app, the radio may stop working. Trailer Tire Pressure sensors may not be learned in the Trailer app. Not being able to return to the home screen while in the Camera app. After an ignition cycle, the radio might go to a black screen or stop working if using Sirius XM. Spotify icon truncated on Audio app.   SXM When changing power modes with the ignition switch, the HVAC pop up might appear. During startup, the radio will show the brand splash screen then go blank. Receiving a confirmation pop-up when changing drive modes. A “Return to Dealer” message may appear on the radio screen. SuperCruise setting toggle may not work. System After an ignition cycle, the radio might go black or stop working if using Sirius XM (SXM). Settings When performing a factory reset, the radio may stop working. After performing a factory reset, the radio may stop working when trying to switch users. When trying to go into the Language section quickly after startup, the radio may stop working. Projection Wireless CarPlay cannot be connected after unpairing another wireless Android Auto device. When the Android Auto screen comes up to connect wirelessly, the screen may freeze if the Cancel button is pressed. Removed the Apple CarPlay Cannot Connect screen when a device fails to pair during the autoconnect process. CarPlay information may not show up in the audio app. Near Field Communications (NFC) chime may be heard when NFC does not work. The Cannot Connect screen does not pop up after the first connection on wireless CarPlay fails. Apple CarPlay is now functional in Guam. Over the Air (OTA) When a software update is cancelled, the downloading logo may still be displayed. Energy When using the Energy app, the radio may stop working. When plugging in the vehicle, the display might show “Now” instead of “Charging Upon Plug In.” Instrument Cluster Voice recognition can be started while on an OnStar or phone call. When downloading contacts, there is a progress bar and circles on the Recents page of the cluster. The temperature on the cluster and the display may be different. After receiving and ending a call on the secondary paired phone, the cluster may get stuck on the phone menu. Bluetooth Intermittent Bluetooth connection loss.
    • AndrewF
      Front End Rattle

      By AndrewF · Posted

      Looking for help troubleshooting a metallic like front end rattle. Figured I’d see if anyone had thoughts before I schedule an appointment with the dealer.   The rattle is fairly loud and occurs primarily when the front driver side wheel hits a bump, even fairly minor road seams. Sometimes does it when the passenger hits a bump but I don’t believe when the rear hits. Rattle still occurs when foot is pressing brake peddle so I think that rules out the caliper rattle I’ve read about. I’ve also checked the running boards and they are tight.   Most noticeable at slow speeds.    Any insight is appreciated. 
    • KARNUT
      What did you do to your "other" car (aka musclecar) today

      By KARNUT · Posted

      We try to make cruise the coast. It’s where our favorite casino is. I only want to spectate. Never took a car. Always had one to take. I belonged to a club once. Even when I used to drag raced. It was during test and tune. Probably because I’m not a night owl, party person. 
    • RyanbabZ71
      What did you do to your "other" car (aka musclecar) today

      By RyanbabZ71 · Posted

      We had a pretty big cars and coffee in Indy this past weekend.  Pretty much anything and everything was there.  
    • Atlas
      What did you do to your "other" car (aka musclecar) today

      By Atlas · Posted

      Good looking Olds, and TRX!   I haven't been into car shows either. I'm probably not a convert but I did push myself this year to attend a few select events to challenge some assumptions and try to experience car-based social clubs in a different way. I joined up with the local Hagerty group for some cars/coffee events, group drives. A month ago I showed my '94 Camaro I rescued last fall at Radwood. Had a good time, but, there was some sitting around with the car and that's the part of shows I don't enjoy as much. I prefer to be a spectator, walk the show, grab a burger, go home.   Radwood was the only era-limited event, but where it had strict model year limitations, it made it up in variety. Having Jason Camissa there was also a hoot.   Where I see old 50's car shows, doo-wop and winga dinga music stuff fading out, same with "only" vintage muscle clubs, it seems to be the activity-based clubs/events which are gaining strong popularity. Places where all cars and interests come together.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...