Jump to content

Adding a Second Battery

rosepaule

By rosepaule
in Modifications, Wheels & Tires

 Share

Recommended Posts

rosepaule Enthusiast

rosepaule

Posted
Posted

I'm looking to add an additional battery to my truck for accessories. There is almost no where to put on under the hood that I can see. Anyone added a second battery yet? I dont believe there was a factory installed second battery option so I'm curious as to where people are putting them... if its been done yet.

 

Thank in advance.

 

I've got a 2019 GMC 1500 Denali 4x4 6.2.

1SLOW1500 Senior Enthusiast

1SLOW1500

Posted
Posted

There is always a spot. Add a isolator and buy a frame mount and then get a sealed battery. Wire it all and never even know you have it till you need it.

Sent from my SM-N960U using Tapatalk

rosepaule Enthusiast

rosepaule

Posted
  • Author
Posted
6 minutes ago, 1SLOW1500 said:

There is always a spot. Add a isolator and buy a frame mount and then get a sealed battery. Wire it all and never even know you have it till you need it.

Sent from my SM-N960U using Tapatalk
 

Thats what I thought... until I looked under the hood. There isnt much room for much, let alone a battery. It was easy on my 2007 Silverado... it had a spot for it already...  Going with a Optima Yellow top... I see you are running dual Red tops.

TXGREEK Senior Enthusiast

TXGREEK

Posted
Posted
Thats what I thought... until I looked under the hood. There isnt much room for much, let alone a battery. It was easy on my 2007 Silverado... it had a spot for it already...  Going with a Optima Yellow top... I see you are running dual Red tops.

Avoid Optima, they’re garbage! Get an Odyssey, excellent batteries.
rosepaule Enthusiast

rosepaule

Posted
  • Author
Posted
13 minutes ago, TXGREEK said:


Avoid Optima, they’re garbage! Get an Odyssey, excellent batteries.

I've had Optima Yellow tops in every vehicle I have owned in the past 15 years except motorcycles.... 1 in a 03 Ferrari 360 Spyder, 2 in my 07 Silverado, 1 in my 03 Accord, and 1 in my 73 Nova.... All of them had lots of accessories and music... never once did one fail that wasnt my fault. I had one fail in the Ferrari after I discovered a short in a light that was always on. 

 

Thanks though.

1SLOW1500 Senior Enthusiast

1SLOW1500

Posted
Posted

Optima was bad for a minute when it was bought out and they switched to Mexico and quality was bad. But they are great again. I have had dozens in cars, boats,ATV, and trailers.
Also a lot of the optima is bad was the issue johnson controls being anti american and moving to Mexico that alone started rumors. But odyssey is good. Best for off self normal batteries I would look at XS power. Then there are the big boy batteries the racers run but the cost is insane.

Sent from my SM-N960U using Tapatalk

1SLOW1500 Senior Enthusiast

1SLOW1500

Posted
Posted
Thats what I thought... until I looked under the hood. There isnt much room for much, let alone a battery. It was easy on my 2007 Silverado... it had a spot for it already...  Going with a Optima Yellow top... I see you are running dual Red tops.
I have a red and a yellow only because I had reds brand new sitting in garage but months later the stock battery was dieing soni call up to get a optima and they said it is a new battery type and Optima Carrie's it in yellow top so I said fine.
With my isolator the batteries are separated until the switch is on or the key is turned. Then if truck is running they both charge.
Nothing fancy but works.

Sent from my SM-N960U using Tapatalk

  • Like 1
  • 1 month later...
rosepaule Enthusiast

rosepaule

Posted
  • Author
Posted

Bump.... looking to see if anyone has found a clever way to install a second battery without having to put it in the bed of the truck.

  • 1 year later...
Trail boss 5.0 New Member

Trail boss 5.0

Posted
Posted
On 11/10/2019 at 10:47 PM, rosepaule said:

Bump.... looking to see if anyone has found a clever way to install a second battery without having to put it in the bed of the truck.

I've been asking the same question for you about year now. Has anyone install a second battery yet?

Transient Senior Enthusiast

Transient

Posted
Posted

Back in MY2007 the Tahoe/Suburban and Silverado were almost identical.  Today they are very different.  I had a 2007 Tahoe and installed the second battery by placing on tray already installed at factory, and securing with mount I bought at the dealership.  It was that simple.  I then changed several wires over to what the PPV/SSV Tahoes were using.  These new Silverados don't have a pre-installed 2nd battery tray, and almost everything got moved to the opposite side of where it sat in the previous several generations.  If I were to do the 2nd battery again, I'd start by trying to find schematics for the Silverados sold via GM Fleet to police and fire departments.  If you can't find schematics, ask a friend that works at the fire station to let you look for a 2nd battery.  I wonder if GM mounted it down low, or under the truck.  It wouldn't be the first time something like this was done.  Iirc, the only battery in the Chrysler Concorde (iirc), was at the bottom of the engine compartment.  Maybe GM installs it under the rear seat in an enclosed compartment.  The battery in my wife's 2017 Traverse is in the floor of the 2nd row on the passenger side.  I have to remove floormats and slide the front passenger seat all the way forward if I want to remove it.

  • 1 month later...
AJ Sullivan Enthusiast

AJ Sullivan

Posted
Posted

I installed a howler siren on my truck between the rails just under the radiator.  I haven't looked too hard, but I bet you could fab a tray that goes all the way across and holds a battery, even if sideways.  I will have a challenge because I have a howler siren under there, but most of you should have no problem.  Pull that plastic shield off and start looking around for mounting holes and placement.  

 

I might get a wild hair and start poking around next week, if I am bored.  

  • 1 month later...
NancyA New Member

NancyA

Posted
Posted

I was recently at the dealership and mentioned a second battery to my service advisor as I was considering it.  She said they were put behind the seat.  Frankly, that sounds unlikely unless maybe two sealed 6 volt batteries were put in series behind the seat, but I thought I would mention it. 

NancyA New Member

NancyA

Posted
Posted

I was just looking at deep cycle lead acid batteries for use in boats, probably computer UPS units, etc., on Amazon  There are a number of different shapes and Ah powers.  They are expensive but could fit nicely behind the seat.  They have terminal that are inset, so screw in. 

 

Also, with different shapes, a place might be found for them in the engine compartment.  Perhaps two 6 volt in series could fit somewhere.  I have been advised in the past for solar applications that if batteries are to be connected in series or parallel that they should both be of the same age, preferably bought new at the same time and equally charged before hitching them up.

Supreme Pizza Senior Enthusiast

Supreme Pizza

Posted
Posted

 

1) What do you need an extra battery for?

 

Powering accessories? What accessories do you need to power for hours, while the truck is not running?

 

When the truck is running, the battery is not being utilized. The alternator does all the work. So why do you need two batteries?

 

Assuming you want to do extended power draws on a battery while the truck is off, it it would be best to use a booster pack, so? Something that isolates your primary battery, so you can still start the truck after extended periods of battery use.

 

As far as mounting a second battery, there are many places to do so - but you should still buy two brand new matching batteries for this procedure, not one new one and one old one with different CCA.

 

 

 

 

 

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.3k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,739
    Total Members
    8,960
    Most Online
    chfkief
    Newest Member
    chfkief
    Joined

  • Who's Online   1 Member, 0 Anonymous, 1,547 Guests (See full list)

  • Latest Articles

  • Posts

    • Chuck FB
      Joke Thread

      By Chuck FB · Posted

      Fred was in the fertilized egg business. He had several hundred young pullets, and ten roosters to fertilize the eggs He kept records, and any rooster not performing went into the soup pot and was replaced. This took a lot of time, so he bought some tiny bells and attached them to his roosters. Each bell had a different tone, so he could tell from a distance, which rooster was performing. Now, he could sit on the porch and fill out an efficiency report by just listening to the bells. Fred's favourite rooster, old Butch, was a very fine specimen, but this morning he noticed old Butch's bell hadn't rung at all! When he went to investigate, he saw the other roosters were busy chasing pullets, bells-a-ringing, but the pullets, hearing the roosters coming, would run for cover. To Fred's amazement, old Butch had his bell in his beak, so it couldn't ring. He'd sneak up on a pullet, do his job and walk on to the next one. Fred was so proud of old Butch, he entered him in the City Show and he became an overnight sensation among the judges. The result was the judges not only awarded old Butch the "No Bell Piece Prize," but they also awarded him the "Pulletsurprise" as well. Clearly old Butch was a politician in the making. Who else but a politician could figure out how to win two of the most coveted awards on our planet by being the best at sneaking up on the unsuspecting populace and screwing them when they weren't paying attention. Vote carefully in the next election, you can't always hear the bells.
    • chfkief
      FS: Black Bear Performance AutoCal Tuning System

      By chfkief · Posted

      Do you still have?
    • 3CarSeatDad
      High Country Suburban build confirmation

      By 3CarSeatDad · Posted

      Can someone confirm if the GM order workbench terminal is able to validate a custom build sequence:   1) Initialize the Allocation Base: Open a new vehicle build queue, select the 2026 Chevrolet Suburban 4WD, and pick the High Country (3LZ Preferred Equipment Group).   2) Select the Diesel Powertrain: Go directly to the engine configuration screen and choose RPO code LZ0 (3.0L Duramax Turbo-Diesel). Ensure it maps to the MHS 10-speed automatic transmission.   3) Deploy the Seating Swap: Navigate to the Interior Options screen and enter RPO code ATT to replace the standard captain's chairs with the power-release 60/40 bench seat. Because you are not trying to force a separate luxury or air-suspension bundle, the standard, premium D07 Fixed Floor Console remains active. The system will accept this change immediately without triggering a warning message.   3)Apply Heavy-Duty Hauling Capability: Input RPO code NHT (Max Trailering Package). The commercial terminal will automatically bundle the required trailering hardware and software modules to support the diesel engine's maximum towing capacity.   5) Layer the Premium Tech and Glass: Separately add code C3U (Panoramic Power Sunroof) and code UKL (Super Cruise) to the order screen.   6) Run the Final Validation: Click the "Validate Order" button at the bottom of the interface.
    • revmanii
      Looking at ordering a '26 WT because I want a std cab, std bed

      By revmanii · Posted

      Spent the last hour or 2 googling and reading up on the spacer thing. I don't like the loss of thread contact on the slip on spacers, but it appears you can get "extended" lug nuts that reach into the hole of the wheel to get back the lost threads. Looks like the only true hubcentric slip on spacers are at least .375". I'd want as little as I could get away with and don't want to cause other clearance issues going any thicker. Bora seems to offer what appears to be a well made .375" spacer and extended lug nuts. I searched here and did find a couple threads recommending Bora. But not cheap. By the time I buy spacers and lugs, new TPMS sensors, then pay a tire shop to install the new sensors, I suspect I'm going to be in over $400. Thinking about running out and getting some washers to put behind the wheel to see if .375" is enough to clear calipers, turn lock to lock without rubbing, and to see if the wheels/tires look strange pushed out a little. This would just be to check fitment.
    • Core-Lokt
      Road Master Active Suspension

      By Core-Lokt · Posted

      Roadmaster makes some quality parts; I have their sway bar. I considered the RAS, but I ended up bagging. I didn't know what kind of ride I'd get with RAS, and the bags have interior jounce bumpers, so I can run 0 pounds pressure. I figured I'd have the best of normal suspension ride with assist on-demand. But it seems you got pretty much the same in one item.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...