Jump to content

Recommended Posts

Posted

I took another trip today. Hoping that the issue would disappear now that Onstar was no longer active I reset a trip log on the truck and the trailer mileage in the app to zero. I watched closely and they were in sync as I started the trip.

 

After a while I got into some traffic and I needed to pay attention to driving. When I was out of that I checked the mileage and found that the trailer mileage was 20 miles less than the truck. I don’t know if it had just stopped tracking for a while or if it had pealed off 20 miles. I paid attention for the rest of the trip and it was tracking. When I got to the ramp it was still off by that same 20 miles.

 

I then parked and turned the truck off while I got ready to launch the boat. When I started the truck I checked the mileage on the app. It had changed and showed 4 miles more than the truck.

 

When I was driving home that 4 mile difference stayed the same for the whole trip, meaning it worked correctly. Since I only intended to use this for tracking maintenance needs I will just live with it. I will mention it to the dealer when I take the truck in for service but I doubt they will figure anything out.

Posted
On 4/7/2020 at 10:06 AM, zelmo said:

While I had looked at the manual and read some of the info on the trailer app I should have studied it better.  I went back and did that.  Here is the section on the security feature: 

 

Security Alert

A security alert can be set if a trailer is connected and the alert is enabled. When the trailer is disconnected and the vehicle is off, an alarm will sound.  Touch Security Alert in Settings to view the Security Alert settings page. These alerts are based on the Trailer Profile, so the settings for each Trailer Profile must be turned on or off. Touch a profile to view more information or adjust the setting for that profile.  This setting will be off by default for each Trailer Profile, including the Guest Trailer Profile.  A smartphone will receive a notification that the trailer related to the selected Trailer Profile is disconnected from the vehicle, if the setting is on for the active Trailer Profile, the vehicle has an OnStar or connected service plan and the smartphone number has been added to the account for this notification.

If the setting is turned off for a given Trailer Profile, the smartphone will not receive this security notification even if the Trailer Profile is active.

 

Too bad you need Onstar for the smartphone feature to work.

Guys -  I noticed my trailer lights will blink when the truck is turned off and just sitting there with boat hooked up.  I thought something was wrong....but I guess not.  So to be clear.. if I unhook my trailer while the truck is locked.. the truck alarm will go off?   Or do I need the onstar stuff for it to work? 

Posted
Guys -  I noticed my trailer lights will blink when the truck is turned off and just sitting there with boat hooked up.  I thought something was wrong....but I guess not.  So to be clear.. if I unhook my trailer while the truck is locked.. the truck alarm will go off?   Or do I need the onstar stuff for it to work? 

It’s supposed to honk or something if the trailer is disconnected.


Sent from my iPhone using Tapatalk Pro
Posted
11 minutes ago, GMC-AT said:

 Or do I need the onstar stuff for it to work? 

 It is my understanding that the honk will work without Onstar but in order to receive a notification on your phone you do need Onstar.

Posted

ok, great... that's I all need is a honk, my boat and trailer are always parked close to me.  I'll try it out soon and see if works.  I always thought the light flash was a back feed issue or something....

Posted

I have been meaning to experiment with this but haven't gotten around to it.  Let us know how it works.

Posted
7 hours ago, GMC-AT said:

ok, great... that's I all need is a honk, my boat and trailer are always parked close to me.  I'll try it out soon and see if works.  I always thought the light flash was a back feed issue or something....

You do need to activate the feature for it to honk.  Default is deactivated..

Posted

I tried the honk feature after i turned it on, and locked the truck it did not honk when i disconnected the trailer.  

Posted
4 hours ago, Greyhound6.2 said:

I tried the honk feature after i turned it on, and locked the truck it did not honk when i disconnected the trailer.  

It won't work if you have your fob in your pocket.  The fob needs to be out of range, otherwise the truck thinks you're the one disconnecting the trailer and won't sound the alarm.

Posted
On 5/28/2020 at 11:44 AM, zelmo said:

Well I don't know what is going on.

 

I took another trip with the starting mileage at 49.  This time the destination was 64 miles away.  That means that when I got there the mileage should have been 113.  The app said the mileage was 119. 

 

While that was off it wasn't the worst.  When I got in the truck to go home the mileage had changed to 161.  As I traveled the mileage ticked up and was at 210 when I got home.  It should have said 177 (or 183 if you add 64 to 119.)

 

Any theories?  Nothing adds up on this trip.

 

 

Wife pointed this issue out to me this weekend.  Picked up a new travel trailer and moved it from dealership to storage in about 33 miles.   The app showed I put on 96 miles.   New profile and all.  I’d be interested in hearing what others have noticed.  

Posted

I had a trailer tire temp warning pop up on the cluster after being stopped for a lunch pit stop at 139 degrees but when i opened the app it showed all 4 tired under 130 degrees. plus i have seen the tire temps up to 145 without a warning pop up. also curious what temp the sensors are supposed to alert you at. 

Posted
2 hours ago, Greyhound6.2 said:

I had a trailer tire temp warning pop up on the cluster after being stopped for a lunch pit stop at 139 degrees but when i opened the app it showed all 4 tired under 130 degrees. plus i have seen the tire temps up to 145 without a warning pop up. also curious what temp the sensors are supposed to alert you at. 

I just towed my trailer 300 miles yesterday and temps were in the low to mid 70s.  Pressure went from 65 psi cold to upper 60s.  Unfortunately, I haven't seen anything indicating when over temp or underinflation warnings pop up. 

Posted
3 hours ago, Brian Autwell said:

Wife pointed this issue out to me this weekend.  Picked up a new travel trailer and moved it from dealership to storage in about 33 miles.   The app showed I put on 96 miles.   New profile and all.  I’d be interested in hearing what others have noticed.  

Mine seems to be pretty accurate.

  • 5 years later...
Posted

I have a 2020 GMC Sierra 2500HD AT4 with the premium package.  I have a Springdale camper with the TPMS sensors. Everything works but every once in a while, it says no trailer connected. The default brake setting of 5 is set. I normally have it at 6.  Everything works, lights, brakes etc.  If I load the Trailering app and manually select the profile for this camper it loads everything normally.  Not sure if there is an updated version of the app to fix these bugs or what.  I will check that later today.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • I have a Retrax pro that I first had on my 2020 chevy and transferred it to my current GMC.  It stays in the garage most of the time, so hard for me to judge it's long term weather resistance.  It still works perfectly, been very durable.  It doesn't see oil patch usage, but it's not a mall queen.  It keeps most things mostly dry (small leaks) and the security of it is enough to slow someone down but not keep them out for long.  I would buy one again, it works for me.     
    • Thanks to the convenience of Amazon, I was able to get a few things done to the truck today.  I installed Carquest Premium oil and air filters with five quarts of Mobil1 High Mileage 10-30 along with a quart of Pennzoil Platinum 5w-30 I already had.  The latch for the flip up center console lid was broken so I replaced it along with the power mirror switch.  I found my push retainer assortment this morning and reattached the plastic under the bumper and it was only held on with a few screws and retainers.  Then I programmed a new remote keyless entry fob so I can lock my dog in the truck when I take her out with me (I've got to keep the air going for her since it's been in the 100s).  Finally, I ordered some LED interior bulbs and replaced the reading lamps.  The front lights are working fine while one of the back lights only works intermittently and the other not at all.   While under the truck, I found the source of at least one of the noises: the sway bar links need replacing.  I ordered a set of Suspension Dudes links with Code Red bushings.  Never heard of them, but they're made in the USA and have decent reviews.  While making yet another Amazon order, I went ahead and added a set of front tow hooks.  I went with red, since that's the color of the sway bar link and bushings and it should look decent enough on a black and chrome truck.  Speaking of which, it doesn't bug me much, but the passenger side mirror has a chrome cap while the driver side doesn't, so eventually I'll make them match one way or another.  Oh, and I ordered a $20 TPMS reset tool.  No idea if it will do anything for my sensors but it was cheap and will work for the Ford Transit Connect as well.     For tradition's sake, I ordered a new oil change wrench.  I kept the Snap-On 9/16"x15mm GM wrench I bought when I was 18 in the 2006 GMC from the time I bought that truck until the truck was lost.  While I was tempted, there's no need to spend $80 for a new SO wrench, or even $50 with shipping for a used one on Ebay.  I just bought a Duratech 15mm extra-long ratcheting wrench to do the job as needed.  It works, and if I like that wrench enough, I'll buy the set.  
    • The recall is for exactly this issue - those drain holes combined with the limited environmental capability of the tailgate electronics card inside the tailgate were a problem. The “safety issue” was the potential for the tailgate to spontaneously open, but all kinds of tailgate misbehavior can occur from water contamination of that control card.    There is no real fix yet. The initial recall just disabled the tailgate. Later, when parts became available, they would replace bad parts with new parts of the same bad design. My dealer is going nuts because the few times I let them get their hands on my truck, my tailgate is off due to a slide-in camper installation. They really want to cut my tailgate wires, but I won’t give them the chance. I will let them get their dirty hands on it when a real fix (redesign) is available.  My tailgate, which works just fine with sealant plugging the drain holes, will remain safe in a dry storage crate until then.  
    • Yes your absolutely right, I been looking at the 4 inch BDS one and it acutely states you can use the stock 20’s just not the 17’s or 18’s, I also didn’t realize that with my 275/60r20 stock wheels I’m already running 33 inch diameter wheel setup lol so I can just run my stock wheels and tires atleast to start.
    • I would expect that to be lift-kit dependent.  If the kit has interference issues w stock wheels, then the kit/manufacturer should indicate that somewhere.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...