Jump to content

Stubborn Tailgate Release

tbully
 Share

Recommended Posts

tbully Enthusiast

tbully

Posted
Posted

Hi All - 

 

I know there’s a “spontaneous tailgate opening” thread but I haven’t found much info on this problem so here it goes…..

 

I have a situation where the tailgate won’t open (reliably) with the button on the tailgate.  If I push it enough times it finally opens.  The key fob as well as the button in the cab work fine.  Some info found online suggested maybe a switch.  For $17, I gave it a shot - no go.  It’s not at the dealer and, of course, they’re insisting on changing the switch again.

 

My experience in electronics says this is likely not a physical switch (or even wiring) issue.  The randomness of when or if it opens screams software or something “computer”/BCM.  I thought maybe the truck couldn’t sense the fob reliably in my pocket.  However, the “step release” button works reliably.

 

Any thoughts / ideas?  Dealer has had the truck for a week and no progress.

 

Thanks.

 

tbully Enthusiast

tbully

Posted
  • Author
Posted

Dealer couldn't find the issue and is order (another) switch.  I'm surprised nobody else has had this problem here.  I'll respond once/if they find the culprit.

 

 

nocturnalmotors Enthusiast

nocturnalmotors

Posted
Posted

When you press the switch on the tailgate, can you hear the lock actuating? I found on mine, I have to slightly pull on the top handle / depression with my fingers as I push the button with my thumb and it opens normally. If I just simply push the switch, it's 50/50 if the tailgate will drop due to you're actually pushing the tailgate closed as you push the button...

  • 3 weeks later...
Maninthesea Enthusiast

Maninthesea

Posted
Posted (edited)

I always hear the actuation but do not always get the tailgate to drop.   Eventually it does but I am wondering is there a manual tailgat latch override built in or possible mod.   When this truck has seen better days I want to still be opening the tailgate.  Also can the tailgate be opened with a dead battery?

jim

Edited by Maninthesea
Another JR Senior Enthusiast

Another JR

Posted
Posted (edited)
8 minutes ago, Maninthesea said:

There is a provision for manually opening the tailgate behind a panel on the inside surface of the tailgate, so you could eventually get it open, but it’s not quick to use it.  Quickest way in the case of a dead battery would be to connect another 12v source. 

Edited by Another JR
  • 1 year later...
In2racn Enthusiast

In2racn

Posted
Posted

If you hear the actuation, the electric release mechanism needs lube. I would hear the clicking, but the gate would not open. Cleaning and lubing the locking mechanism got it working.

UWSkier Enthusiast

UWSkier

Posted
Posted

Anyone else have where you don't press the button hard enough and the tailgate won't release, but the fuel pump primes for some reason?

NotoriousGT350 Enthusiast

NotoriousGT350

Posted
Posted

subscribing.... I have this with my '19 and dealer fix before. It's out of warranty, it sometimes opens after unlocking from inside or key fob 3-5 times. And sometimes it doesn't open and I just barely pull on it and it releases. Sounds more mechanically on my end is the problem where it's not disengaging. 

 

I may try some lube and see if that works. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,897
    Total Members
    8,960
    Most Online
    ncleg
    Newest Member
    ncleg
    Joined

  • Who's Online   4 Members, 0 Anonymous, 1,224 Guests (See full list)

  • Latest Articles

  • Posts

    • Z45
      Towing In Loose Gravel

      By Z45 · Posted

      Having owned 4wd vehicle since the 1970s I find there are varying opinions on how to use 4wd, every owner is an expert in their minds.  IMO, 4LO is the appropriate gear and what I would use,  You have to feather the gas to avoid spinning tires and the lower the gear the better chance.  But like I said you will find those that think their method is best.  I live near a boat launch.  Yesterday there was a new Ford Maverick pulling out a pontoon boat almost 2x its size, they had no problems and they don't have a LO range.   True story. One winter day not long ago I was coming out of small town post office and there was a F150 4wd parked in front and was stuck foot deep snow ruts. I knew the lady so I asked her to put it in 4wd (wondering why in the middle of a 2-day snow storm she wasn't).  Her reply surprised me, "my husband" (the expert) told me not use that because it uses more gas. She finally got unstuck spinning in 2wd which likely used more gas than not.  
    • dna9656
      New to Me 2010 SLE (Quirks, Issues)

      By dna9656 · Posted

      Your tire pressure issue may just be batteries, you can reset them using tge Ing switch (I think) and the owner's  manual. ChatGTP will b e a faster, better help than Google.
    • Another JR
      Towing In Loose Gravel

      By Another JR · Posted

      The thinking is that starting out in a higher gear makes it easier to avoid applying excessive torque when pressing the gas pedal. In a modern 4wd truck with 4 low and a limited slip or locking rear end, I would use 4 low and try to crawl up the ramp. Sometimes if they are too slippery, you have to back up to let the boat have some bouyancy, and then accelerate briskly to get some momentum to help you pull the through the slippery parts. 
    • XY74
      Roll up bed cover experiences

      By XY74 · Posted

      I have a Retrax pro that I first had on my 2020 chevy and transferred it to my current GMC.  It stays in the garage most of the time, so hard for me to judge it's long term weather resistance.  It still works perfectly, been very durable.  It doesn't see oil patch usage, but it's not a mall queen.  It keeps most things mostly dry (small leaks) and the security of it is enough to slow someone down but not keep them out for long.  I would buy one again, it works for me.     
    • fm2176
      New to Me 2010 SLE (Quirks, Issues)

      By fm2176 · Posted

      Thanks to the convenience of Amazon, I was able to get a few things done to the truck today.  I installed Carquest Premium oil and air filters with five quarts of Mobil1 High Mileage 10-30 along with a quart of Pennzoil Platinum 5w-30 I already had.  The latch for the flip up center console lid was broken so I replaced it along with the power mirror switch.  I found my push retainer assortment this morning and reattached the plastic under the bumper and it was only held on with a few screws and retainers.  Then I programmed a new remote keyless entry fob so I can lock my dog in the truck when I take her out with me (I've got to keep the air going for her since it's been in the 100s).  Finally, I ordered some LED interior bulbs and replaced the reading lamps.  The front lights are working fine while one of the back lights only works intermittently and the other not at all.   While under the truck, I found the source of at least one of the noises: the sway bar links need replacing.  I ordered a set of Suspension Dudes links with Code Red bushings.  Never heard of them, but they're made in the USA and have decent reviews.  While making yet another Amazon order, I went ahead and added a set of front tow hooks.  I went with red, since that's the color of the sway bar link and bushings and it should look decent enough on a black and chrome truck.  Speaking of which, it doesn't bug me much, but the passenger side mirror has a chrome cap while the driver side doesn't, so eventually I'll make them match one way or another.  Oh, and I ordered a $20 TPMS reset tool.  No idea if it will do anything for my sensors but it was cheap and will work for the Ford Transit Connect as well.     For tradition's sake, I ordered a new oil change wrench.  I kept the Snap-On 9/16"x15mm GM wrench I bought when I was 18 in the 2006 GMC from the time I bought that truck until the truck was lost.  While I was tempted, there's no need to spend $80 for a new SO wrench, or even $50 with shipping for a used one on Ebay.  I just bought a Duratech 15mm extra-long ratcheting wrench to do the job as needed.  It works, and if I like that wrench enough, I'll buy the set.  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...