Jump to content

Recommended Posts

Posted

IMNTBHO;  a manual transmission would deter most scumbags from stealing a car nowadays.  Especially if it were "3 on the tree" for a car.................or a "high/low", or a "splitter" in a truck!!!!

  • Like 1
  • Haha 1
Posted
On 8/18/2024 at 12:41 PM, TheRiver said:

IMNTBHO;  a manual transmission would deter most scumbags from stealing a car nowadays.  Especially if it were "3 on the tree" for a car.................or a "high/low", or a "splitter" in a truck!!!!

 True dat! :) 

Posted
On 8/18/2024 at 5:29 AM, Grumpy Bear said:

Interesting device. Hefty price. 

Cheaper than an insurance claim though and I sometimes have to leave my truck in a Motel or Hotel parking lot, I do have a faraday pouch for the fob that blocks the signal well enough that even sitting in the drivers seat it will not pick it up.

Auto theft is rampant in some areas and I don't always know the "turf"  lol

  • Thanks 1
Posted

I’d be interested in knowing how this works for you. After having my 2020 Sierra stolen from a “secure hotel parking garage” I am very paranoid!

Posted
On 8/18/2024 at 1:41 PM, TheRiver said:

IMNTBHO;  a manual transmission would deter most scumbags from stealing a car nowadays.  Especially if it were "3 on the tree" for a car.................or a "high/low", or a "splitter" in a truck!!!!

Hard to find one of those in todays pickups...

  • 1 month later...
Posted
On 10/5/2024 at 7:39 AM, e.texerado said:

Curious if you ever installed this,  if so does it also disable remote start?

It does render remote start inoperable, I don't use it at home but when travelling it is a minor inconvenience to me.

Well worth 100 bucks IMO.

  • Thanks 1
  • 4 months later...
Posted

I know it's been a while since the last post to this thread, but I thought I should share my experience with 41.22 in case anyone else is considering their Drop-In Kill Switch.  I ordered it after seeing good YouTube reviews.  I never got an email confirmation, so after a week I tried to email them for a an ETA or tracking number.  I found they don't publish an email anywhere, you have to send an inquiry through the help section on their web site.  It's one of those comment box deals.

 

After another week of no response, I sent another inquiry, this time to the sales inquiry box instead of the customer service.  After another week, I finally got an email stating that my order was now complete - no explanation if that meant it was ready to ship or if they thought it was delivered....?  I replied saying that it's not complete until I've received it and that I hadn't.  I searched the web, finally went to the BBB and found their parent company (same address), who at least had a phone number.  They didn't answer, of course, and never returned my voice mail.  I was just about to call the BBB to see what I could do when the package finally arrived. I did notice what I hadn't before - both 44.22 and the parent company have 'F' ratings with the BBB.

 

I had the flu, so a couple weeks went buy until I went to install the switch, only to find that the relay they sent would not fit my 2018 1500 by a long shot. Our starter relays have four small parallel terminals, one at each corner. Their relay has much larger terminals at right angles to each other. My truck, model, engine size, etc. was all spelled out on the order, and on the packing slip.

 

I again did an inquiry through their web site and left a voice mail at the parent company.  So far, no response after two full business days.  I don't expect a response, but I guess I COULD be surprised (doubt it).  I think my only recourse is going to be filing a charge dispute through my bank.

 

I'll update this when there is a resolution.  BUYER BEWARE!!!

 

 

Posted

You may have already installed your kill switch, but for what it's worth, I am planning to use a remote relay instead of a toggle switch to turn on and off whatever type of kill switch I end up with.  I had planned to use the Drop-In relay kill switch from 41.22, inc., but whether I can use that one or just splice into something, it will be triggered by remote. That way, I can turn the kill switch off, then use the remote start without going to the truck.

 

 

On 10/5/2024 at 9:39 AM, e.texerado said:

Curious if you ever installed this,  if so does it also disable remote start?

On 10/9/2024 at 7:25 AM, johnnyquick said:

It does render remote start inoperable, I don't use it at home but when travelling it is a minor inconvenience to me.

Well worth 100 bucks IMO.

 

  • 4 weeks later...
Posted
On 2/9/2025 at 6:46 PM, Neroado said:

I know it's been a while since the last post to this thread, but I thought I should share my experience with 41.22 in case anyone else is considering their Drop-In Kill Switch.  I ordered it after seeing good YouTube reviews.  I never got an email confirmation, so after a week I tried to email them for a an ETA or tracking number.  I found they don't publish an email anywhere, you have to send an inquiry through the help section on their web site.  It's one of those comment box deals.

 

After another week of no response, I sent another inquiry, this time to the sales inquiry box instead of the customer service.  After another week, I finally got an email stating that my order was now complete - no explanation if that meant it was ready to ship or if they thought it was delivered....?  I replied saying that it's not complete until I've received it and that I hadn't.  I searched the web, finally went to the BBB and found their parent company (same address), who at least had a phone number.  They didn't answer, of course, and never returned my voice mail.  I was just about to call the BBB to see what I could do when the package finally arrived. I did notice what I hadn't before - both 44.22 and the parent company have 'F' ratings with the BBB.

 

I had the flu, so a couple weeks went buy until I went to install the switch, only to find that the relay they sent would not fit my 2018 1500 by a long shot. Our starter relays have four small parallel terminals, one at each corner. Their relay has much larger terminals at right angles to each other. My truck, model, engine size, etc. was all spelled out on the order, and on the packing slip.

 

I again did an inquiry through their web site and left a voice mail at the parent company.  So far, no response after two full business days.  I don't expect a response, but I guess I COULD be surprised (doubt it).  I think my only recourse is going to be filing a charge dispute through my bank.

 

I'll update this when there is a resolution.  BUYER BEWARE!!!

 

 

Did you get a response back from 41/22?  I ordered one for my Ram 1500 and had similar tracking issues and lack of response.   I finally got it and when I installed it, it doesn't work properly, the replaced relay is for the fuel pump and the truck will start and then peter out.  i contacted them and they said they would send me a new one "right away" but i'm dubious I will ever see it and in my mind have written them off.  For my Ram trucks, I have an alternative solution where a small company JW Innovations makes a kill switch harness specific to these trucks that i'm going to install. Cheap too.  However, they only do Mopar.  I haven't been able to find a similar setup for the new 1500s.  I'll keep you posted.  

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Yea that's pretty normal to be off a few degrees.  Usually 2-4 degrees from say a weather app or thermometer.  
    • I just replaced the ambient air temperature sensor.  Easy as pie. I simply had to remove about 10-12 clips on the plastic cover over the radiator and remove two T-10 torx screws on the hood release lever to liberate the cover (Amazingly, none of the clips broke.  All came out and went back in with zero problems). Once the cover was removed, the temp sensor is easily accessible. The sensor cable snakes through a few guides and can be pulled out for even easier access to the sensor. I was able to work the sensor out of the mounting hole.  There is a red sliding catch on the plug that must be pulled back to disconnect the cable.  The plug was quite tight.  I had to use a screwdriver to pry it out. I plugged in the new sensor ($6.45 from RockAuto), snapped it into the mounting hole and re-snaked the cable. I put the radiator cover back on and reattached the lever arm to the hood release.  All done!     I started up my Suburban.  The temperature read 82 °F. Other thermometers at my house read 80 °F.  Close enough.  It might be reading high as my vehicle was sitting in the sun.
    • Remember when you were 50 and they called you Old Man?
    • That one looks decent for the price   BUT..I want something that also supports OBDI/1.5. A lot of the prosumer-grade scanners don't have legacy support in order to keep costs low. I believe the Autel does if you go higher end with them.   For fun, I reached out to a local Snap-On rep because I was interested in the 2600. $1895 MSRP, says he can do $1595. That's still a lot, but then again, that's not a horrible discount for just asking out of the blue. Could probably do better if I was a regular buying off his truck, but I'm not.   Not sure if I mentioned but I didn't realize with USED scanners from Snap On that you need to make sure a) the serial number isn't flagged as stolen. On the newer ones, SnapOn can remotely disable the device if it's flagged in their system. And, customer service can tell you if it is, if you're thinking about buying used. B) Make sure it's paid off. If the seller still owes money to the truck or if they financed through Snap On, the device can be remotely disabled until the balance is paid. It's less clear if SnapOn will tell you if a balance is still owed; I didn't make it that far with the used model I was considering. I did read that SnapOn has no way of tracking any "truck financing" deals between the SnapOn rep and buyer, only if they financed through corporate. So there's that extra caution needed.   Still waffling on whether I go with a ~$500ish Autel/TopDon or spend bigger money. The value seems to be in the prosumer brands. I'm not giving them enough credit TBH, actual production repair shops use them daily BUT I'm still allergic to certain kinds of underdog products trying to unseat American companies with solid reputations. SnapOn's scanner isn't wholly made in the US, but it is assembled here and they have US support and probably the most proven/ robust legacy support.   Something to think about. Value, or principles? There's a $1k difference.
    • I'm thankful to live where we don't have extreme weather. We might all be blown to smithereens when Mt. Rainier goes, but 80 is warm enough in the summer and I can generally count the number of hard freezes in the winter on one hand. The cars here don't rust and they don't get sun-baked, either.   We have finished off many of our average 52 days of "clear/sunny" weather, though. Sunsets are coming earlier, the nights are a little cooler. It's right around the first week of September when we get our first warning that summer is coming to a close with overcast skies and the start of "hoodie weather" temperatures during the cooler parts of the day. By October, it's usually time to ditch the shorts. By November, it's mostly raining.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...