Jump to content

Recommended Posts

Posted (edited)

Yes this backup camera on the '14 Silverado is much Lower resolution than the last two cars I have owned which had backup cameras (neither were Chevy's). For the most part it seems to work and I can see, but the biggest problem w/ the low resolution is that once it gets even a little dirty you are totally blind. At least on the higher res cameras I've had when they get dirty you can still make out stuff in the screen. That said, the Silverado's camera seems to do better backing up into the sun than my other two cars.

Edited by Nickshu
Posted

The other big problem is it takes a long time for the camera to night/day mode to update when backing out of the garage. I can back all the way out and by the time I'm putting it in drive it updates and you can finally see something.

Posted

I agree... The sharpness is quite bad compared to my wife's 2008 Honda... But the BIG screen makes a huge difference... If I could have the big screen and a crisper video... that would be awesome.

Posted

I want to install a quick connect so I can unhook the camera from the tailgate and connect a different camera (On the back of my camper) once I'm hitched up.

 

I found the schematics, I just need to do a little testing of the pinouts. It will be interesting to see what a different camera looks like on the same display.

  • Like 1
  • 3 weeks later...
Posted

Anyone else notice the camera stays on for a few seconds after putting it in drive?

Posted

Its like...a CRT television with like 480p resolution. Even on the 4 inch MyLink the camera is not better. Needs a higher res camera.

Posted

Anyone else notice the camera stays on for a few seconds after putting it in drive?

Yes

Posted

I have a 2014 Sierra and I agree that the camera quality is horrible.

Posted

I just use it to keep from hitting something or someone. Seems adequate for that.

Posted

I just use it to keep from hitting something or someone. Seems adequate for that.

 

for the most part. I have trouble seeing where my trailer hitch until im about 5' away from it then I can see it.

 

if someone made a higher res camera I would buy it in a heartbeat!

Posted

Sorry if this is a dumb comment, but... Does cleaning the lens help? Maybe there is a layer of wax or oil over the len?

Posted

I just had my camera replaced by the dealership. NO improvement!

Perhaps a 3rd party will provide a HD camera replacement.

Posted

HD camera or any other higher resolution camera will do no good when the infotainment screen is the controller of the end result resolution. So unless you have a way to change out the infotainment screen with one with higher resolution then a higher resolution camera wont do a thing.

 

I already posed this question to the engineers when I was working on the radio process.

Posted

The screen is not the problem. The resolution of the screen is very good.

 

Gringo

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,944
    Total Members
    8,960
    Most Online
    flyclt
    Newest Member
    flyclt
    Joined
  • Who's Online   5 Members, 0 Anonymous, 636 Guests (See full list)


  • Latest Articles

  • Posts

    • The timing marks are ok, that is #1, you can turn it over until they line up and it won't change anything, the crankshaft turns twice for every camshaft revolution, I have always set up SB Chevs as your pic shows using a straight edge
    • Someone's been here before.... There is a receipt for a 3-piece timing set, purchased earlier this year.   Is this picture something, or, nothing?   I have the timing cover off and my crank is perfectly TDC and the keyed gear's locating mark is dead on 12 o'clock.   The cam gear locating mark is also at 12 o'clock. Now, I'm not an expert, but all the install guides say the two locating marks should meet and be perfectly aligned when installing a timing set. The mark on the crank should be dead on 12:00 and the cam gear's mark should be dead on 6:00, and both marks should be perfectly vertically aligned.   I believe the timing gear is keyed or has a dowel that ensures it can only be installed on the cam in one position, so I have to believe the cam is out of phase somehow. At the very least, with a triangular bolt pattern, it can only be installed in one of 3 different positions.   Before I pulled the front cover, the truck was running alright, no service engine soon lights except an occasional P0172 / rich condition. Timing -16 timing at idle (should be +16), and total -35% fuel trim, two conditions I haven't been able to figure out.   In related news, my injector tested pretty well, wasn't leaking, but I had it rebuilt anyway, and it's on it's way back to me.         Along with this discovery, the good and bad:   Good: The oil pan seal appears undamaged.   Bad: -The timing cover has been reused, and the positioning dowels have been broken. That could explain some of the leaking. -Some kind of white paste or grease was used to try to seal the oil pan seal and timing cover (since wiped off..). -Then, someone globbed silicone all over the front of the cover and also buried the ckp sensor in it. But, they didn't put any inside the cover or use RTV to try to seal the oil pan seal with the timing cover (good).
    • The guy that owns K&P filters last I checked in with him has over 300,000 miles on his Dodge base Hemi using his own 35 micron absolute stainless mesh filter from its first oil change.    The GM study I've posted a dozen times shows the relationship in engine life based in multiples of base units, not miles or years. That is the base unit is the number of miles the motor ran using the reference filter efficiency.    The above two paragraphs dismantle anecdotal arguments IF one changes oil often enough to prevent particle formation and the motor is in otherwise good shape. That is not full of silica (no air filter) or suffering a metallurgical issue that is not part of the lubrication discussion. Poor heat treat in example.   Data from UOA's I've reviewed from more than a few engines can show remarkably broad variations in oil cleanliness using the exact same filter over the course of an engines life.     Lastly there is the common sense of it. Wear debris WILL circulate the engine BEFORE it ever sees a filter in route to that filter and WILL harm the pump which NEVER sees filtered oil.    Alpha question then becomes, given the facts, how long do you believe is a reasonable service life from a vehicle you are certain you will not pass down? That is the junk yard will be it's resting place when you're done with it? (the moral issue most don't care about).    Omega question is then how diligent are you prepared to be in general mechanical, air & oil maintenance? Preventing particulates and keeping them sufficiently dilute; preventing the precursors from generation, amalgamation and precipitation.    If I get a good look at the engine bay of a vehicle I have a fair idea of the owners commitment to the inside of the power train. That 30 micron WIX is still more efficient than a sieve.                 
    • It also depends on what criteria someone is using for “best” when talking filters.  Are we going off best efficiency?   Best quality/QC?  Etc. because the two may not mutually exclusive.  
    • They’re not the same wiz as 10-15 years ago.  QC has fallen pretty hard.  The XP line was never good though in the first place.    https://bobistheoilguy.com/forums/threads/wix-filter-rusted-through.386492/post-6991372   https://bobistheoilguy.com/forums/threads/i-ve-used-my-last-wix-filter.27299/   https://bobistheoilguy.com/forums/threads/looking-for-a-better-replacement-for-wix-51258.403977/   https://bobistheoilguy.com/forums/threads/convince-me-in-using-the-purolator-boss.401537/post-7420147   the forums are littered with posts and examples of not great wix filters the last couple years 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...