Jump to content

2006 2500HD 6.0 Low Pressure Oil

Meek27

Recommended Posts

Meek27 New Member

Meek27

Posted
Posted

Have been trying to search for this Topic Title. Can't find much info. Was wanting some help in this area.

 

2006 2500HD 6.0 Low Pressure Oil 162,000 Miles. 0 oil pressure on gage in truck, engine making lots of noise, Sounds almost like a pulley/bearing going out. I'm going to test pressure in sensor spot today with mechanical gage. Thinking its the Oil Pump. Was wondering if someone would point me in the right direction as to how to change oil pump by steps. With maybe some diagrams.

Rogue Leader Enthusiast

Rogue Leader

Posted
Posted

Chek out my reply to your post in the other thread. IMO your problems are most definitely more than an oil pump.

oldscsc Enthusiast

oldscsc

Posted
Posted

Chek out my reply to your post in the other thread. IMO your problems are most definitely more than an oil pump.

+1

 

If the engine has been starved for oil for any length of time, you're in for a rebuild or used engine swap.

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • asilverblazer
      Another 6.2L engine failure!

      By asilverblazer · Posted

      I included the first gen-cylinder de-activation (active fuel management) in my statement.
    • No1UKnow
      Transmission Woes :-(

      By No1UKnow · Posted

      Hello All!   My 2019 Colorado 3.6 LT, 4WD Crew Cab has approximately 77,500 miles and I recently began experiencing the well-known transmission shudder between about 30 and 65 mph. The problem had worsened to the point that I could no longer attribute it to road conditions - and I had decided to bring the truck to the dealer - when recently, I experienced a sudden loss of power while driving at maybe 40 MPH. Several warning lights flashed, the “Check Stabilitrack” message appeared, and the Check Engine, Stabilitrack, and Traction Control icons remained illuminated. The truck regained driving power, but it stayed in a low gear with unusually high RPMs for the speed. (limp mode?) Because I was only about two miles from home, driving slowly, I was able to make it back and run an OBD-II scan, which showed fault codes U0101, P0700, and U0100. My next trip in the truck was to drive it to the dealer the following day. That trip began normally, but after about a mile I experienced another loss of power, along with the same warning lights and the same “Check Stabilitrack” message. As before the truck remained driveable, but again operated at an abnormally high RPM-to-speed ratio and seemed stuck in a single gear. About a mile later, the dashboard lit up once more, this time displaying “Check 4WD.” Soon after that, I arrived at the dealer. I have verified that the truck still has its original factory transmission fluid, which means it has never received the corrective fluid exchange outlined in GM Technical Service Bulletin #18-NA-355.  That was Thursday of last week and I've heard nothing yet from the dealer.    According to Technical Service Bulletin #18-NA-355 and the build date of my truck, my truck should have the newer LV fluid. I've done a little research and read something about a problem with the wiring harness as well.   Anyone have an insights into this situation?  Thank you!!
    • GMCustomerService
      Damaged Left Rear Bumper & Left Rear Quarter Panel - Repair Questions

      By GMCustomerService · Posted

      Having bumper and other body damages can be very frustrating, especially as a result of a parking lot collision/bump. Our team wants to learn more about the damages to your truck so we can look into ways we might be able to help. When you get the chance, please fill out our support form with more details: https://s.gmc.com/support-request . A member of our team will follow up with you as soon as next available. We want to get you enjoying your truck to the fullest again. 
    • PhilB
      Gas Prices

      By PhilB · Posted

      Did you even read this article?   Even the title of the article says "U.S.-Iran Deal Doesn’t Mean a Swift Return of Oil and Gas Flows"   Remember, crude oil prices are based on FUTURE purchases by the oil companies.  Gas prices are based on FUTURE purchases by the station.  This article stated that many of the oil producing nations have to restart their processes to get the oil produced.  Then the oil has to be shipped to wherever.  And it doesn't get there overnight.  And most of that oil is not coming here. Check out this site:  https://afdc.energy.gov/data/10621   A graph will pop up to show where the US imports their oil from.  Notice that there isn't a lot of import from OPEC and Iraq.  Most of the US import comes from Canada. The US oil produces are selling their oil on the open market, which is why the US fuel costs went up.  So you're correct, the US oil companies are going to slow walk the price downward.
    • GMCustomerService
      Tranmission stays in Low

      By GMCustomerService · Posted

      Having codes and an engine light with no hints on what might be causing it is nothing short of frustrating. How long have these concerns been present? We want to know more so we can look into ways we might be able to help you. When you get the chance, please fill out our support form with additional details on your experience so far. A member of our team will follow up with you as soon as next available: https://s.gmc.com/support-request 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...