Jump to content

Recommended Posts

Posted

I have a 2015 Sierra 5.3 that does not have the $100 FlexFuel E85 option. I've had FlexFuel trucks before this, and like the option to run E85, but this truck does not have the option. All 2014 5.3s are E85 capable, and the 2015s have it as a standalone $100 option. I did some research on what exactly the $100 option gets you, and I'm pretty sure it is just the yellow colored gas cap. According to GMpowertrain.com, and all parts information I can find, there is NO difference between the E85 and non-E85 5.3. GM Powertrain says the 5.3 is E85 compatible, period.

 

So, I decided to run a couple tanks of E85 to see what happens. Turns out, it runs E85 exactly as I would expect and have seen from my previous FlexFuel trucks. It cranks a little longer on cold start, as others have reported. It get less MPG, maybe 20% less. It idles smoother and feels much more responsive than on 87 octane gas. I had to pull out into 50mph traffic from a stop so I hit the gas pretty hard, the truck smoked both rears and stepped sideways a little bit. It is not that responsive on 87 gas.

 

I also noticed that the truck seems to hold higher gears more, rather than downshift early. I think on 87 octane gas it will downshift much sooner as an anti-knock protection, to prevent a load on the engine at lower RPM. If I would breath on the throttle with 87 gas it would want to downshift. This makes sense, but it also tells me the engine computer is sensing and adapting to E85. It also runs in V4 mode more often and longer on E85, another sign the engine adapts to E85. It is also injecting more fuel with E85 (as is expected with a flexfuel engine), so it must be measuring ethanol content.

 

I'm convinced the $100 E85 option is nothing more than the yellow gas cap and a way for GM to offer a choice. I wonder if there is some advantage to GM in CAFE or fuel economy calculations by having E85 as a customer option, versus a factory default. I see a very noticeable difference in smoothness and responsiveness on E85, and I like how it holds a gear longer. I think I'll try a couple tanks of 93 octane next then 89 octane, to see if there is any difference.

  • Like 2
Posted

I just read your thread on your E85 conversion, wow that is impressive! I did not know there is a separate fuel sensor (didn't see that documented in the parts diagrams I found). I may rethink running a lot of E85, although I gotta say it seems to run it just fine and the truck feels so much better I may do it anyway! It even shifts better. I wonder if it could be using the O2 sensors or some other way of measuring ethanol? My truck seems to be adjusting to E85 just as I have experienced and would expect from a FlexFuel engine. The injectors and fuel pumps are rated for higher flow, and the computer is commanding more fuel flow as it should.

  • Like 2
Posted

Did you put e85 in on empty? If not, you might have had enough regular to keep it sain.

 

Sent from Tapatalk App - Samsung S6

Posted

Yeah, and I'm on the second tank. It is probably more like E60 here in the winter, but still makes me wonder how it is adjusting.

  • Like 2
Posted

I have been running blended 93 & E85 (E85 in lower amount) on my '16 which is not a FFV. I have noticed that the engine runs better than running on straight 93, but I'm unsure if it ran as well as my '15 which was a FFV. I checked the undercarriage and there was no sensor for ethanol content; the electrical connector just sat there disconnected.

Posted

I used to run e85 in my last car. I ran it for 30,000 with no problems it was not ffv either. I bet the ECU has the ability to tune for e85 it will just take much longer without the sensor. My guess would be 2-3 tanks?

  • Like 1
Posted

To each their own. I think the difference between non FFV and a FFV may be more than known.

Posted

Yeah, and I'm on the second tank. It is probably more like E60 here in the winter, but still makes me wonder how it is adjusting.

 

My last tank of e85 is reading 60% alcohol, so you are probably right with your guess.

Posted

Without the alcohol sensor (included with the E85 option) you won't get the horsepower and torque benefit of higher fuel rates in the programming tables for the E85. (and blends)

Posted

I've been running E85 in my 02 for a couple months now. No issues at all other than hard starts on cold morning as in when it is down to 29°F out. It runs smoother and seems to have more power.

 

One other benefit is my used oil analysis came back this last time looking way better than any of my previous UOA's. I also like the fact that E85 here is now $1.16 a gallon. Nice to fill up for under $30. Yeah, my mpg took a hit but when I calculate it out, the cost difference for E85 and 93 I'm still ahead running the corn juice.

Posted

93 in a 6.2 i understand but why in a 5.3? unless it is tuned to run on it. A stock 5.3 requires no more than 89 (87 mfr recommended) at best so why the added expense of higher octane? Here 91 is roughly 50 cents more a gallon.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • I gotta say, I'm enjoying your narration. The troubles you've been having are amusing as you describe them. It's good to see that you're finally getting some satisfaction out the old beast though.
    • Declaring victory would upset the demons that possess this Blazer, so I won't. But I did make progress today--after it put up a fight. Always a fight.   I had the day off so I spent the morning cleaning up the shop and I thought I'd get ahead of things by filling the cooling system in prep for the final part I needed to arrive: the driver's side knock sensor. Glug, glug, glug....and then the unmistakable sound of liquid hitting the shop floor. It induces the same chagrin when the sonar and targeting laser temporarily malfunction during a late night bladder evacuation over the toilet with the bathroom light off. D'OH!!! That made a mess...   Oh, hey, that knock sensor I removed? It threads into a wet port. Who knew?! Learn something new every day. Put a pin in that chore, I'll fill it the rest of the way later.   The knock sensor arrived at about 1pm. I threaded it in, connected the wire, filled up the coolant, checked for leaks, and... drumroll.... fingers crossed for a perfect start, excellent timing, model fuel trims, and ...no squeaks... Here goes.....   No, it didn't start. At all. I cranked it a few times and it wasn't sounding good. Furthermore, I heard leaking again. Jesus H Tapdancing Christ, stop leaking all over the dang floor. This time I had accidentally overfilled the coolant reservoir and the churn of the water pump via cranking caused a bit to burp out. Ok, just, breathe... Put the flamethrower down. Dang thing wouldn't burn anyway, leaks too much...   Did you know the rotation of a round crank sensor in a round hole, matters? I do now. Took me about half hour to retrace steps and realize what I had done. Then it started right up.   No squeaks. The squeak was the old balancer.   Once it entered closed loop, fuel trims are dead on, hovering right around zero at idle. No more -30%. I'll credit the injector rebuild on that one.   Timing? I think there's an OBD 1.5 translation error with my Actron scanner. It's anywhere from -20 to -30 at idle, sometimes as high as -40 cruising. Sorry, the engine just isn't running that smoothly at -40 degrees ignition advance. It's just not. It's smooth all through the rev range and has decent power. I'm going to have to trust the seat of my pants on this one.   The new exhaust is very quiet. The old catalytic converter? Not melted, but definitely not healthy. Rains glitter when you turn it on its end...all the precious metal is flaking out. Once the new exhaust system burned in/smoked off a bit, the engine's exhaust smell is normal again. Not that I'd recommend going around huffing car exhaust, but, you know what I mean?   One problem to correct. The new exhaust has the opposite problem of the old spliced up exhaust. It wants to hit the floor where the old one wanted to rest on the cross member. Happy medium, please? Still noodling on that one, need to look at how I can adjust some hangers.   I don't know what's next. On one hand I want to run away from this thing as far and as fast as I can -- there have been a lot of NOT fun moments. On the other, now that it kinda drives nice, maybe drive it around for a little bit?   Shhh... it's not currently dripping oil all over the floor. I can see just a little wet at the bottom of the timing cover where it meets the oil pan seal. It's not dripping multiple drops with every ignition cycle, in fact, after some driving this evening it has yet to even form a drop that could drip off yet. But the weekend is young... I fully expect this could turn into Exxon Valdez by Sunday. Because this Blazer hates me. LOL.      
    • About that:   Once upon a time in a land far far away lived a car company that was shy about taking your money and wanted to be sure that they gave you more that you asked for so that you'd come back. No really, not a fairytale. 😱   But after the field got thinned out enough to limit the competition it seemed good enough to give you only what you asked for. Fair enough I say but in such a market you have to give something the others are not or they go to the one who does. Gimmicks or glitz. Oh, fins and chrome. Yea, shinny crow like cars. Yum.    Field narrows a bit more and 'brand loyalty' becomes a thing and the minute it does they start thinking to themselves, "Could we make more money if we gave them less than they expect and they will hang in there for brand and comfort with the known?" They gave it a try and da*n, it worked!!    Well, what if we teach them, groom them into believing that less is "Normal" and cut some more corners. Will that work? Oh heck yea!    🤔 I wonder, can we give then WAY less than they expect and make them mad enough to spit nails and STILL get them to pay up? Sure, if we get everyone else to do the same so that the choice is less or nothing at all. How would be do that? Platform sharing.  What a concept, right?  Steal like there is no tomorrow and it's legal too!    Truth is no one is going to give up driving, not for very long. The Gen Z crowd is fine with it and will be as long as someone not Gen Z will haul them around. At some point we all die.    Economic voting only works if you cast a NO vote now and again and enough of them to get dumb and dumber to wise up. Well, that's how I was taught anyway. And it should have worked. Would have worked. But the Bail out!!   Look, you have another choice if  you take that bag off your head. If the dumb it down to some predetermined expectation of how John Q Public will use it the, that is under design it to failure they you use it to a lower stress mode. D'ho!    A 1950 Royal Enfield Bullet 500 will go anywhere a Suzuki Hayabusa will and for just as long. But you will have to treat it for what it is and not for what you wish it was. 
    • Maybe I was just too unlucky, but I had nothing but bad luck with Bridgestones. Out of 3 sets, they all started losing a lot of air when they got down to about 1/2 tread life, and at that point also wet traction suffered more than it should have. Also, the only tire I ever had in my 60 years of driving that had a side wall blow out was a Bridgestone.   I'm currently running Goodyear Wrangler Workhorse AT and am very happy with them.   
    • maybe when the trip is over, check all the other joints in the front end, like all the ball joints, tie rods, pitman & idler arms, etc...
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...