Jump to content

Recommended Posts

Posted

Curious to know if any of you always keep your truck in 4wd auto. If so, does it hurt andything and does it effect MPG?

Posted

Anecdotal, but I had a 2015 that stayed in auto 4wd. It however was owned by my work so I wasn’t afraid to beat it up, and I didn’t track mileage at all. Never had any problems with the truck though.


Sent from my iPhone using Tapatalk

Posted

I think 4 auto keeps the transfer case in open diff mode, so it should be safe. However, if you're on dry pavement, not sure the value doing it. Mostly some mpg loss. If it was raining, I'd definitely use it.

Posted

4 AUTO engages the front axles but sends very little power to the front wheels until slip is detected. The power distribution is handled by an electronic clutch in the transfer case.

 

In auto, there is a slight fuel economy penalty and also more noise / vibration, both due to having the axles engaged and more rolling resistance.

 

Also, in theory, driving all the time in 4 AUTO would increase wear on the transfer case clutch and assorted components.

 

Although it is “safe” to use all the time, you really should be in 2WD unless the road conditions are sloppy. I usually use 4A if there’s been a snowfall in the last couple days and the roads and parking lots aren’t all the way cleaned up. I also have been known to slip it into 4A if I feel like the guy next to me wants to have a little stoplight race. Otherwise it’s 2H basically all the time.

  • Like 8
Posted

I read that it MPG drops by one if it's kept on Auto 4x4. Not bad for it but if you have unpredictable traction, better to keep it on.

Posted
6 minutes ago, Wiggums said:

 

I read that it MPG drops by one if it's kept on Auto 4x4

 

Says who?

Posted
10 minutes ago, Booger T said:

Says who?

Manual states slight drop in gas mileage if set on auto instead of rear wheel drive.

 

 

Screenshot_20190323_185143.jpg

  • Like 2
Posted

There is no good reason to do it... It will cause additional wear on the four wheel drive system.. Are you new to 4x4 trucks? If you have a locking rear end and you're not off road, there will be very few situations outside of snow that you use anything but 2 high... I will use AUTO if I am trying to get a jump on traffic off the line sometimes because the truck is quicker off the line with it but, beyond that unless there is significant snow on the road there aren't many reasons I can think of that any 4 wheel drive mode is needed if you're on paved roads..

  • Like 2
Posted
37 minutes ago, Imcrazy said:

There is no good reason to do it... It will cause additional wear on the four wheel drive system.. Are you new to 4x4 trucks? If you have a locking rear end and you're not off road, there will be very few situations outside of snow that you use anything but 2 high... I will use AUTO if I am trying to get a jump on traffic off the line sometimes because the truck is quicker off the line with it but, beyond that unless there is significant snow on the road there aren't many reasons I can think of that any 4 wheel drive mode is needed if you're on paved roads..

Agree.

:)

 

Posted

I've accidentally left my truck in auto the day after a snowstorm and didn't notice a difference in driving characteristics but like everyone else said, there's no benefit to it, only cons unless it's raining or snowing.

Posted
1 hour ago, Imcrazy said:

There is no good reason to do it... It will cause additional wear on the four wheel drive system.. Are you new to 4x4 trucks? If you have a locking rear end and you're not off road, there will be very few situations outside of snow that you use anything but 2 high... I will use AUTO if I am trying to get a jump on traffic off the line sometimes because the truck is quicker off the line with it but, beyond that unless there is significant snow on the road there aren't many reasons I can think of that any 4 wheel drive mode is needed if you're on paved roads..

Am I new to 4X4? That is a no. I’ve owned more than I can count. Btw, your rear end isn’t locked when you are in auto 4WD. It locks when it senses slipping. Will do the same thing in 2WD

Posted
3 hours ago, Aycock1987 said:

Am I new to 4X4? That is a no. I’ve owned more than I can count. Btw, your rear end isn’t locked when you are in auto 4WD. It locks when it senses slipping. Will do the same thing in 2WD

Yes I knew that about the G80 rear end... The auto mode is really only intended for mixed road conditions, IE partially snow covered roads and getting in and out of slushy parking lots or messy gravel roads. If you leave the truck in auto for a few days accidentally I'm sure you'll be just fine but, there is not really any reason to use auto unless you're off road or the road conditions are poor..

Posted

I agree with the folks who recommend running in 2H unless traction is bad. However, when I'm driving my company's trucks around the plant where I work, I find it will spin a little on the sand and gravel that's all over our roads so I usually shift to 4A so our safety guys don't give me shit. 

Posted (edited)
1 hour ago, Cpl_Punishment said:

I agree with the folks who recommend running in 2H unless traction is bad. However, when I'm driving my company's trucks around the plant where I work, I find it will spin a little on the sand and gravel that's all over our roads so I usually shift to 4A so our safety guys don't give me shit. 

Sand and gravel, yes ?

Clean pavement, no ?

Edited by UGADawgs
Posted
On 3/23/2019 at 7:52 PM, Aycock1987 said:

Curious to know if any of you always keep your truck in 4wd auto. If so, does it hurt andything and does it effect MPG?

I've always ran my trucks in 4wd auto.  No issues at all.  I've noticed that the gas mileage isnt really affected either based on my testing.

  • Like 4

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • I agree with Tim.  As tech heavy as engines are these days, no way I’d be an early buyer of the new 6.6.  Of course, I bought my ‘26 Denali w/the 6.2 after dumping my Tundra with it’s defective 3.5 liter imploding engine disaster, so I’m a little gun-shy.  That said, my 6.2 has been rock solid.  I don’t drive it like I do my BMW Z4 M40i, but I don’t baby it either.  I got a V8 for a reason.  But I’m averaging 18 around town and 22 highway.  I have seen 24 highway as well when I wasn’t loaded up heavy.  Considering my Tundra with the twin turbo V6 only got 14.5 in town and 17 on the road, I’ll take the 6.2 all day, every day.  If I were you, I’d grab a ‘26 while you can.  Inventories are probably gonna start dropping and I’ll bet the deals will start looking sweeter as well.
    • I am curious if anyone has figured out a way to add an hard button AUX or 360 Camera switch to the center row of switches. I have a 2021 AT4, and want to split the hill decent button and add a 360 camera button so that you don't have to go into the center display and locate the camera functionality, etc...   My father's 2024 Yukon XL AT4 and it has a hard button, see below. I found this thread on the Yukons, but it seems like there may not be a part number for the 2021 sierras. https://www.gm-trucks.com/forums/topic/255339-adding-hard-button-for-camera-on-2021/ Anyone else figured this out. Seems like it would need to be a custom switch!   I am getting ready to install the auto stop/start eliminator, so would be nice to knock them out at once.     Upvote1Downvote0Go to comments
    • Looks like the entire state is burning. 😬
    • Through the years it hasn't been my typical method as I tried to drop oil on an engine that was hot from having been worked, however that was not always practical and had to fire up a unit and let it warm up reasonably well and drop the oil when I had the time to do it but am referring to not only vehicles but a variety of farm equipment and highway tractors etc. However on a vehicle where one is crawling under it and the exhaust is nearby to ones body and if wanting to pull the plug without danger of being hit with boiling hot oil or attempting to remove a HOT oil filter, its sure safer and easier to not have everything smoking hot and can remove the filter right away when under the vehicle and let it all drain. Of course its not the end of the world if a bit of oil stays in the engine that might have eventually found its way out, I like to get out as much as possible but any oil changes that take place in shops would rarely be sitting around for very long at all before the plug is thrown back in and filter slapped on and oil poured in and sent out the door quick like. There would be very little time spent ( assuming they even did it ) in starting the engine with oil to fill the filter, then waiting to verify the level on the stick. A good reason to check ones oil level shortly after a shop changed the oil on a vehicle just to make sure its correct and to look under for any oil around the drain plug or filter. 
    • Cool to see another Vermonter!
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...