Jump to content

Seat riser kit from seating solutions

BPVTB

By BPVTB
in Modifications, Wheels & Tires

 Share

Recommended Posts

BPVTB Enthusiast

BPVTB

Posted
Posted

Randy at seating solutions has come up with a 2 piece design for the custom trailboss to raise the drivers seat. Excellent product, easy to install and he will answer any question you have. +1 (770) 401-9307 is his number his name is randy. Tell him I sent you over and he will help you out. My truck is the first kit with the “2nd design” of this product and is just what I needed.

DF611E52-2AFA-44D7-99E0-AD5C86F51F84.jpeg

839CE5A6-89F5-438F-915D-CDB08EBB1829.jpeg

4C5C7A61-2757-4378-8C5F-473EE14CB981.jpeg

AEC3B44C-992D-47D9-9833-3A2DAA445370.jpeg

K455 Enthusiast

K455

Posted
Posted

This was the 1st thing I complained about, for high the TB sits I thought you should sit higher in the truck.

Jason k Enthusiast

Jason k

Posted
Posted

I'm desperately trying to figure out how to wire a power seat in mine, I can't get comfortable no matter what I do with the seat

K455 Enthusiast

K455

Posted
Posted
18 hours ago, Jason k said:

I'm desperately trying to figure out how to wire a power seat in mine, I can't get comfortable no matter what I do with the seat

Your right the seat is not very comfortable 

 

  • 5 months later...
Grinnen Enthusiast

Grinnen

Posted
Posted

Would this work on the power seats? Even those have no decent camber adjustment...it'll spill you out of the seat but not tilt back enough to cup you in it.

michael betz Enthusiast

michael betz

Posted
Posted
On 6/20/2019 at 10:45 AM, BPVTB said:

Randy at seating solutions has come up with a 2 piece design for the custom trailboss to raise the drivers seat. Excellent product, easy to install and he will answer any question you have. +1 (770) 401-9307 is his number his name is randy. Tell him I sent you over and he will help you out. My truck is the first kit with the “2nd design” of this product and is just what I needed.

DF611E52-2AFA-44D7-99E0-AD5C86F51F84.jpeg

839CE5A6-89F5-438F-915D-CDB08EBB1829.jpeg

4C5C7A61-2757-4378-8C5F-473EE14CB981.jpeg

AEC3B44C-992D-47D9-9833-3A2DAA445370.jpeg

Awesome. how much roundabout?

Dunn Senior Enthusiast

Dunn

Posted
Posted (edited)

the new truck seats are way too low, I am 6ft tall and without power seat I have it would be impossible to get comfy...….

 

and why is foam so stiff in new ones? it could be tad softer imo…..

 

was so close to getting a custom TB for same price as my RST and so so glad I didn't!.....I probably would have brought it back..

 

I would like to raise passenger side 1 inch + tho

Edited by Dunn
Grinnen Enthusiast

Grinnen

Posted
Posted

To be honest you can buy the material, trim to size, tap the holes and get 8 longer bolts if you just want to change the height.

I think what needs to be looked into is changing the seat angle so they are tilted back a bit to cup the occupant.

  • 2 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Another JR
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By Another JR · Posted

      Have considered installing a DC to DC charger in your camper to replace your isolator?  
    • newdude
      Gas fill door

      By newdude · Posted

      Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • newdude
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By newdude · Posted

      No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • jaszr2
      Active Grille Delete

      By jaszr2 · Posted

      Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...