Jump to content

Recommended Posts

Posted

I have a 2022 Silverado RST bad module and only 8k miles. Part is on back order nation wide! Dealer saying 2/3 weeks. I need to get compensated for this bullshit. 60k piece of ******. I should have kept my 2013 GMC Yukon with 140k miles and never been in the shop. 😡

  • 2 months later...
Posted

I have a 2023 AT4X 6.2L.  At 2750 miles the fuel pump went bad. Motor went into limp mode with reduced acceleration. Took my dealer a week to even get to it. Found out the fuel pump was shot, trailer break controller was bad along with 13 codes thrown. Truck has now been at the shop for 4 weeks (both parts were backordered) plus the week it took to get it on the schedule, so 5 weeks total to date. Had to insist they rent me a truck. Hopefully this is the last time its in the shop for anything major. Pretty ridiculous to see that similar issues have been going on for years over multiple model changes. Get you ****** together GMC! You're certainly charging premium dollar to us, the product should reflect your sticker.

  • 4 months later...
Posted

I have a 2022 Silverado and got stuck in remote area. Starter works no turn over threw a code p129f fuel module. So now 3 days later truck still broke down in remote area. Trying to get a wrecker to it.  This is unsatisfactory and Chevy should have replaced them before it went bad. Vehicle still under full warranty. The cost is the towing at this point. Hope insurance and Chevy warranty helps out.

Posted

I have a 2020 Sierra AT4 and having codes p0499 & PO488.  Does anyone know where the location of the fuel pump control module is.   There is not a lot of good information that I have found so far as to location and replacing.  Frustrating is an understatement.  Thank you for any help!   

Posted

I'm not a member here but I do  have a 2020 sierra with 75,000 miles on it and my fuel pump control module is going out. There is a federally mandated emissions warranty on them for 8 years or 80,000 miles. I am having mine replace at the dealership under warranty. The dealer should inform you of this. If you have had it done you should be eligible for reimbursement. I just learned this with mine. Check into it. 

  • 5 months later...
Posted

2019 LT w/only 31K.  Would hesitate sporadically and a couple of hard jerks but didn't think too much of it.  Was going down the road doing 55-60 and suddenly hard jerked and check engine light showing "no fuel".  I barely made it into a park.  Had it towed and sure enough the mechanic had to replace the fuel gas module.  I am at a loss that this issue is widely known and yet we pay good money on a truck that GM knows there is an issue.  Of course my 3 years is up but my mileage would have been under warranty.  May look into an F150 next time.

Posted
On 3/27/2024 at 8:12 PM, SilveradoRST said:

Is there something I can do to avoid this failure?  Is it the luck of the draw manufacturing defect?

No nothing you can do to avoid this failure. Fuel pumps and modules have been going out since cars were first invented.

  • 4 months later...
Posted

I had a P0499/498 and took it to the dealer. I ask about the Emission warranty until 83k as shown on my owners portal and the dealer advisor told me it only covered the catalytic converter and PCM in Georgia.. cost me 665.00 to get it replaced for the fuel pump control module.. so how did the gentlemen in the earlier comment have his covered? Gongrats to you mate. My truck is a 2019 LT trailboss with 55,700 miles on it. Really like this truck but its about one more check engine light from getting traded for a Ram Rebel... 7 times to the shop in 55K about had it. 

  • 3 months later...
Posted

23 5.3 1500 LTZ with 16k miles.

I’m fairly certain the same problem.

We were on the way to lunch and going through an intersection when the engine cut. It wouldn’t fire up; just turned over and over.

 

Called a tow truck and had it dropped at Chevy.

Posted

2023 Sierra SLT 5.3 with 11k miles (at the time).

 

About 2 months ago, my truck suddenly would not start one morning, and I'm still under factory warranty. OnStar authorized tow delivered it to the dealer. Cause was a failed fuel pump power control module. This may, or may not, be the same as the fuel pump issue the original poster mentioned.

 

Here is the info from my service record if it helps.

Campaign: 24-NA-139

Service finding: code U18A2, loss of communication with fuel pump driver control module

Part replaced: 13554821

Posted

Just got my truck back; was same thing. Fuel pump control module was shot. They had them in stock; took a day to fix. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • If anyone lands here looking for an update - the problem wasnt with the hose, the clamp, etc... I purchased a metal Thermostat housing that just must not of been made to spec. It just wouldn't plug up the hose.. Went back to a plastic cheap housing - leak fixed. Some plumbers tape carefully placed in tandem with a clamp likely would've gotten the job done.   Best,
    • For anyone following, this is what I have deduced from this forum - and my very specific niche case. Please do let me know if you see me going in the wrong direction here. For context, I have a 16 sierra 1500 w/t. Has TC and Cargo light switches. Removed the switch to find the X1 and X2 of the S48A connection populated with wires (x1 10-14, and x2 1-5).   Took photos of the X61A-X5 to find the wires from S48A-X1 land here at their respective pins (10, 11, 17, 23 on the X5). Was hopeful that this means my X51A fuse box has the appropriate pins... No cigar. So now I will be routing wires from the rear of the X61A-X1 to the engine bay and to their respective negative relay triggers. Please see to the diagram. If any has insight as to where the S48A-X2 pins 4 and 5 land that would be awesome.   Note: please disregard fuse sizes. Main fuse will like be 25A, all mini bus fuses will likely be 10-15A   Cheers
    • 287,500 Mile Service   8/13/2026   Reset Fuel Trims   Since the work done in the previous post there was a good improvement in response in all areas except right after a fill up where the LTFT would go -20%+ for about four miles while the STFT was near neutral. Before the work they both went very negative for a few miles after a fill up but act normal thereafter.    We did a systems check of the vapor recovery system for functionality and ability to hold a vacuum. That checked out fine. But this doesn't mean the charcoal canister is dead in the water. Testing that is next up. For now the reset of the fuel trims.    I intentionally shorted the fill exactly two gallons to eliminate any chance of filling the canister. On start up the trims were behaving normally until I got up and rolling where the LTFT went -10 / -11%% but the short was + 2 to 0%. Within a mile the the STFT offset the LTFT and by 2 miles they were neutral. HUGE improvement but still not hunky-dory.    I'll watch them for a few days. Perhaps another tank where I will fill completely to 'first click' and compare. Meanwhile on the hunt for a new canister and I'll toss another purge value at it for good measure. Pending the outcome of the canister test that is. Progress of any kind is welcome.    Fuel economy improvement with bringing hole #3 back to the living was a noticeable bump to the positive. Even on the few miles I drove after the refill I already see another bump up by the trims reset.     She's purring like a kitten with a warm bowl of milk.    BTW, adding 50 rpm to the idle took the majority of the negative timing out on cold start up and leaned the cold idle. No longer burbles in the cat. What a dumb way to heat a cat.      
    • Yeah, shame I can’t really get that filter easily anymore. Running a PureOne. Your fave!    TAN would be neat to see. Confirmation I ran it too long probably. 🤣
    • My son and I both bought new trucks in 2017. Both of us immediately put Truck Covers USA American Roll Covers on our trucks. My son still has his truck and it never sees the inside of a garage. We live in Alabama, so not much snow. My truck was my daily driver and was in the garage when I wasn't driving it or at work. No issues with either cover even after almost 9 years. About a year ago I sold my truck to my brother and bought a 2025 Silverado 2500. The second thing that I put on that truck was a new Truck Covers USA cover. They are very well made and have a very positive locking system. I looked at a Retrax and my concern was the way that the cover locked to the rail. BTW, the first thing I put on the new truck was step bars. Those new trucks are high!
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...