Jump to content

5th wheel chucking

Meade2024
 Share

Recommended Posts

Dren Show Enthusiast

Dren Show

Posted
Posted

I pull a Rockwood 2981bh which is very similar to your fifth wheel.  I was using a GMC 2500 standard bed crew cab with a B&W Companion hitch.  I also feel there was a lot of "chucking" while towing.  I recently had to turn my lease in and purchased a 2025 GMC 3500, but haven't towed with it yet.

  • Replies 31
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Meade2024
Meade2024

I redid some measurements now that we are loaded and on level ground and found the rail to camper to be 8 inches, dropped the hitch 2 inches, also greased every connection point on the hitch itself an

Dren Show
Dren Show

I did something similar with my B&W hitch.  It used to rattle a bit over bumps in my 2022 2500.  It was installed by the place I bought it from.   When I moved it over to my 2025 3500, I

Posted Images

Randal Scott Enthusiast

Randal Scott

Posted
Posted

How was your hitch Held down in your 2500hd? If it is the puck system, then it may need tighten up. If it was connected to the gooseneck hitch, was it tight?  I'm not familiar with the B&W hitch, is there any adjustments to the Jaws? How level is your fifth wheel when hooked to the truck? 

Dren Show Enthusiast

Dren Show

Posted
Posted
21 hours ago, Randal Scott said:

How was your hitch Held down in your 2500hd? If it is the puck system, then it may need tighten up. If it was connected to the gooseneck hitch, was it tight?  I'm not familiar with the B&W hitch, is there any adjustments to the Jaws? How level is your fifth wheel when hooked to the truck? 

Thank you for the suggestions.  The fifth wheel hitch is using the puck system.  I don't think there is any adjustment on the jaws.  I think most everything was tight at the hitch, but it seemed like the trailer was exerting a lot of force on the truck when going over bumps and things like that.

 

The front of the trailer was a touch high.  I remember working with Camping World :) to balance the distance between the bed and the trailer, with how level the trailer was.  To maintain a minimal distance between the bed and trailer, the front of the trailer was an inch or two high.

Randal Scott Enthusiast

Randal Scott

Posted
Posted

I would check the tongue weight. If you can add more, I would.  Not a lot. Some of these RV'S have the axles in the middle of the main body, which gives you a big overhang on the rear. That's one of the main reasons of chucking. IMO that's why the need for tongue weight. They put the axles in the middle to reduce the tongue weight for lighter cargo capacity trucks. 

Dren Show Enthusiast

Dren Show

Posted
Posted
On 3/6/2025 at 12:37 PM, Randal Scott said:

I would check the tongue weight. If you can add more, I would.  Not a lot. Some of these RV'S have the axles in the middle of the main body, which gives you a big overhang on the rear. That's one of the main reasons of chucking. IMO that's why the need for tongue weight. They put the axles in the middle to reduce the tongue weight for lighter cargo capacity trucks. 

I think your thought might be exactly what I have going on.  The axles are in about the middle of the trailer.  It is the ultra-lite series 5th wheel so I bet they were trying to minimize tongue weight.

Randal Scott Enthusiast

Randal Scott

Posted
Posted

Yeah, the 5th wheel I have now and the one I had before. It's like if you could take the front one and put it behind the back one, it would ride better. The campers that I had before these, the axles were back farther. Giving more front overhang. 

Meade2024 Enthusiast

Meade2024

Posted
  • Author
Posted

Took the advice, leveled the camper to the truck better, still a little nose high, but can’t drop the hitch anymore without and still have 5.5 inches of clearance between the bed rails and the camper.  
 

Tightened up the hitch to the rails using rubber spacers, and loosened the bolts on the hitch, put the weight of the camper on it, and retroqued the bolts

 

Things are way better, still can tell im

hauling, but no longer feel like im getting beat up…thank you all

  • 3 weeks later...
Dren Show Enthusiast

Dren Show

Posted
Posted
On 2/18/2025 at 12:17 PM, Randal Scott said:

Does your hitch rock in the bed rails without being hooked to the rv?  You need to get that play fixed.  Loosen the bolts and press on the hitch to get it settled, then slowly tighten the bolts. I have had others tell me to hookup to the rv and then Loosen the bolts. The weight will hold the hitch down to tighten it. Just make sure the tow vehicle and the rv are not pushing or pulling at each other. Need them relaxed. That's why the puck system is a little better. You have adjustments on each corner. 

I did something similar with my B&W hitch.  It used to rattle a bit over bumps in my 2022 2500.  It was installed by the place I bought it from.

 

When I moved it over to my 2025 3500, I tightened the nuts that are on the handles to lock into the puck system.  While the handles require more force to turn now, the hitch doesn't rattle.

  • Like 1
  • 1 month later...
Meade2024 Enthusiast

Meade2024

Posted
  • Author
Posted

Did a long trip down to the smokies..12 hours each way..Pennsylvania roads suck!  Decided to try some sumosprings on the truck..will let you know how it works out for my next trip in June

64BAwagon Senior Enthusiast

64BAwagon

Posted
Posted
On 4/8/2025 at 9:30 AM, Dren Show said:

I did something similar with my B&W hitch.  It used to rattle a bit over bumps in my 2022 2500.  It was installed by the place I bought it from.

 

When I moved it over to my 2025 3500, I tightened the nuts that are on the handles to lock into the puck system.  While the handles require more force to turn now, the hitch doesn't rattle.

Its a bit of a dance to get the cams just tight enough where they dont have any slop in them but still be able to get them to lock in. I put some lube on mine to lock them in easier. 

namtaru Enthusiast

namtaru

Posted
Posted (edited)

I went straight to a GooseBox on our Reflection. Zero chucking. All the space in the bed is nice too.

Edited by namtaru
Scott Surges New Member

Scott Surges

Posted
Posted

Ever consider getting a Gen-Y pin box.  I have the gooseneck version and I don't experience any chucking...

Randal Scott Enthusiast

Randal Scott

Posted
Posted

I like the idea of the Goosebox hitch. But they aren't rated as high as it Fifth wheel hitch. Even the towing tag on my 2500hd saids that I can tow a heavier Fifth wheel then a Gooseneck tongued trailer. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined

  • Who's Online   5 Members, 0 Anonymous, 1,664 Guests (See full list)

  • Latest Articles

  • Posts

    • Coastie05
      Replacing 2.7L on 2021 Silverado with 2023 2.7L

      By Coastie05 · Posted

      I’m definitely interested to hear the end result here. 
    • MASONV88888888
      Another 6.2L engine failure!

      By MASONV88888888 · Posted

      My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Grumpy Bear
      OCI, not when but why?

      By Grumpy Bear · Posted

      Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • MASONV88888888
      Rattle in the rear!

      By MASONV88888888 · Posted

      Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • Buckwild27
      Gas Prices

      By Buckwild27 · Posted

      I have 2 choices. 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...