Jump to content

silveradosid

Member
  • Posts

    2,688
  • Joined

  • Last visited

  • Days Won

    2

Everything posted by silveradosid

  1. thx do you have a part number i dont have a costco membreeship but i can get a friend to get them
  2. where did you get the winter blades from
  3. is it worth the price of hood , headlights,grill and a bumper
  4. maybe guys that have that lift can answer this but to me your lift has your driveline angles wrong and you need a new ujoint but even worst is how far it pulled the shaft out of your transmission
  5. to me it sounds like low freon and the a/c is cycling the clutch which also sounds like it is going to fail
  6. how long have you had the cam and does it work well at night on country roads
  7. nice i have to come to green bay even though my favorite team is doing well
  8. check wiring for the a/c high pressure switch for corroded connectors or broken wires that pressure switch will trigger the fan to come on
  9. bart has a valid point i gave up on gm who told me they had checked the driveshaft and it wasnt the problem i had the driveshaft checked at an independent shop and they told me it had 32 thou run out i put a new driveshaft in and it has reduced my vibrations to the point that i actually like to drive my truck again
  10. if you want to use a momentary grounding switch to turn off and on a circuit then this is the only way i know of that is cheap and simple
  11. have you cleaned the throttle body
  12. this is simpler than 5 relays
  13. rosco did you notice that it is happening when the engine is switching to v4 mode my truck does the same thing everytime it switches and i get a vibration when it does it
  14. get some tow mirrors and it will look like a big truck. nice job looks good
  15. left side temp sendor or blender door stuck disconnect the battery for 5 minutes and see if it resets
  16. All you need is a butter knife to get trim off start at any corner and just pry it out gently once you have a corner loose you can pull it off with your hands there are 4 screws that hold the display in and I think 10 torx screws on the back
  17. since you cannot buy the controls separately i took one apart to see what is inside there is a ribbon cable that goes to the controls you could disassemble yours and see if the cable has come loose or plug it back in and try wiggling the cable to see if it comes back on
  18. Radio lights on with the ignition off (they were the only lights on in the truck) does this still happen if so replace the board on the wiper motor
  19. try disconnecting the battery to reset it
  20. here is the wiring schematics heater.pdf
  21. if the fan only works on high speed then i would look at the resistor pack
×
×
  • Create New...