Jump to content

Recommended Posts

Posted

FYI-

Ive got a NIB set of RB10s for sale. Fits 2015 Crew Cab. Im in Austin, TX. Prefer FTF

 

 

 

Sent from my iPhone using Tapatalk

  • Like 1
Posted

I got mine from "autoaccessoriesgarage" on eBay for $440 shipped before xmas. 5FEC5E68-C61D-47AA-B5E0-2C22045CF869.png

Do they have these in Chrome/ stainless?
Posted

If you are not able to pick up Longhorn-cops killer deal in texas you might be able to get them with a 15% discount from www.autoaccessoriesgarage.com if you call them today? the 15% coupon ends today.

 

rb10.png

Posted

FYI-

Ive got a NIB set of RB10s for sale. Fits 2015 Crew Cab. Im in Austin, TX. Prefer FTF

 

 

 

Sent from my iPhone using Tapatalk

 

What does FTF mean and how much do you want for them?

 

Tyler

Posted (edited)

 

What does FTF mean and how much do you want for them?

 

Tyler

FTF = face to face

So no shipping, you come pick up... basically. :)

 

Here's his original FS post. You may want to message him directly.

http://www.gm-trucks.com/forums/topic/180323-new-gorhino-rb10s-fs/?do=findComment&comment=1733846

Edited by BassOverflow
  • Like 1
Posted

 

What does FTF mean and how much do you want for them?

 

Tyler

Pm sent

 

 

Sent from my iPhone using Tapatalk

Posted

I know this may have already been answered but kind of have a time sensitive question and need an answer quick before the guy sells them. Will a set of 2007-2013 GM assist steps fit on a 2015? Would have searched through the pages if they guy didn't say he has someone else lined up today if I don't take them.

Posted

I know this may have already been answered but kind of have a time sensitive question and need an answer quick before the guy sells them. Will a set of 2007-2013 GM assist steps fit on a 2015? Would have searched through the pages if they guy didn't say he has someone else lined up today if I don't take them.

I don't know a 100% answer but looking at gmpartsdirect all the steps shown that fit 2007-2013 do not fit 2014-2015.
Posted

I don't know a 100% answer but looking at gmpartsdirect all the steps shown that fit 2007-2013 do not fit 2014-2015.

 

I have found some on autoanything.com that show 2007-2016, but I think I am just going to go with the raptor 6" stainless steel ovals. That way I don't have any fitment issues as theirs specifically say 14-16. Thanks for the info though.

  • Like 1
Posted (edited)

Installed my RB10s. There's a lot of adjustment in and out. I tried to line them up with the rocker as best I could.

 

bd310b419360ec0b3a30c36a6910ed37.jpg

 

 

Sent from my iPhone using Tapatalk

Edited by p7m89mm
  • Like 1
Posted (edited)

Installed my RB10s. There's a lot of adjustment in and out. I tried to line them up with the rocker as best I could.

 

bd310b419360ec0b3a30c36a6910ed37.jpg

 

 

Sent from my iPhone using Tapatalk

 

Do you have any more photo's . were did you get them from ?

Edited by tahoe08
  • Like 1
Posted

From the picture, they look like they stick out quite a bit. Can they be brought in more? Was really thinkin of gettin these. Canadian price is ridiculous though.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,813
    Total Members
    8,960
    Most Online
    520Zilla
    Newest Member
    520Zilla
    Joined
  • Who's Online   4 Members, 0 Anonymous, 561 Guests (See full list)


  • Latest Articles

  • Posts

    • Hi all,   I just bought a 2021 suburban RST with 88,000 miles on it and everything has been good but I’ve been noticing within the last month or so that there are small electrical things going on and I know what the AGM batteries and all the electric electrical in these big trucks you need to have a constant flow with good voltage   That being said, I bought a new battery thinking that that might have something to do with it but today I went to get in and start it and it said no key found when I had the key right in my pocket   It also proceeded to flash the lights inside and outside for over 30 minutes as I went to disconnect the battery as soon as I touch the negative terminal, I heard the relay reset and everything come back up. I got in the truck and started it no problem.   Anyone else have this happen to them? I’m starting to think it’s the KARR system that the dealer installed short circuit stuff.
    • I don't drive this truck on a regular basis since I have a new company truck with no out of pocket fuel or maintenance cost. Yesterday I got it out to run some errands and got the title message on my DCI. A quick Google search suggested to first clean the Map Sensor. I pulled it out and it was sooty so cleaned it up and reinstalled it. Issue not resolved. My OBDII is a couple years old so didn't see any codes. Today I took it to a friend at AutoZone to get him to check it with his reader. It had the following codes: P20C3 P02BB P221F Stating the most likely solution is to replace diesel emission fluid (DEF) tank assembly.   So, I guess a trip to the dealer is necessary. I read where there was a backorder on these tank assemblies several years ago so hope that has been resolved.
    • Are you using a weight distribution hitch system with your trailer as that alone can change the actual tire pressure requirements needed. It would prove interesting to see what the actual individual axle weights are on your truck when you are hooked up to the trailer. In fact when your hooked to the trailer, typically if anything unless it has a large capacity weight distribution system that is over cranked, often the weight on the front axle will be less when hooked up vs driving empty and certainly if one doesn't have a weight distribution hitch. Really the only times one may get up there with weight on the steer axle is if there was a snow plow mounted on the front or a motorcycle on a rack or with a very large jockey tank full of fuel at the front of the box that transfers a bit of its weight to the front axle.    And of course your tires carry more weight for a given tire pressure due to their size vs a stock sized tire so there is that to take into the equation as well. 
    • Great info here thank you. I just joined, we have a 2014 Silverado truck we bought about 4 years ago with less than 5,000 miles on it. It has approximately 24,000 on it now. It appears to have all the standard issues that people are talking about. Occasional charging problems especially using 110 volt, occasional blinking triangle where nothing will turn on when first starting the truck but it will reset itself if you wait 10 to 15 minutes. Noisy coupler between the flywheel and the generator. Our truck is speed limited to 74 mph, is there any way to change that? The latest issue we have been dealing with is when driving long distance on the highway at full speed the generator does not keep the batteries charged. The meter will go into the yellow/red border Zone for charge status and the yellow triangle will illuminate solid but the generator will not keep the battery charged, not sure why the controller doesn't tell the gas engine to increase RPM to increase generator output it usually stays well below 25 kilowatts even though the battery is discharging and I have to slow down the highway to 45 mph and eventually pull over and let the truck idle to charge the battery so I can continue driving at speed. Has anyone had this issue before or have any idea how to diagnosed it? When via Motors was around it they were very helpful at troubleshooting. This becomes much if the Terrain is hilly and you're towing a small trailer
    • I have the GMC accessory (REV) cover installed by dealer. Ordered with the truck.  They did a very good install job, can't find a single issue. Some water gets in around the tailgate but no where else.  You can see daylight around the tailgate but that's not the covers fault.  Installation is means everything. Guys at my dealer were seasoned pros, not inexperienced here today good tomorrow types, like many dealers employ for these jobs.   I don't mind paying for a professional job.    
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...