7.62 x 32 bullet VS U-joint?

[Redneck old greg]

Do you think a ak47 bullet would be able to get a U-joint out of the drive shaft? Mine wont budge.

[SouthernSilveradoGuy85]

I really hope you're trolling and not being serious........

 

By the way, anl AK-47 fires a 7.62x39.

[SgtShiv]

 

By the way, anl AK-47 fires a 7.62x39.

+1

[muddkatt]

^^^ +2

[muddkatt]

Do you think a ak47 bullet would be able to get a U-joint out of the drive shaft? Mine wont budge.

 

Probably not, but a 50 cal will remove it!

[SouthernSilveradoGuy85]

 

Probably not, but a 50 cal will remove it!

 

And not a 50 AE, but a 50 BMG, that should do it.

[Chris]

 

And not a 50 AE, but a 50 BMG, that should do it.

.500 Mag should knock it off.

[barry G]

bullets are horsepower.

a hammer is torque.

 

get it right.

[SouthernSilveradoGuy85]

.500 Mag should knock it off.

 

Ya I forgot about the 500 mag for the S&W revolvers lol. But, if you're going to do it might as well do it right and use a 50 BMG.

[Chris]

 

Ya I forgot about the 500 mag for the S&W revolvers lol. But, if you're going to do it might as well do it right and use a 50 BMG.

It is the only 50 i can get

[SnakeEyeSS]

"Man dies when bullet ricochets during auto repair attempt, nominated for Darwin award"

[muddkatt]

"Man dies when bullet ricochets during auto repair attempt, nominated for Darwin award"

 

If the 50 BMG is used, it wont ricochet.

[07Softail]

My .500 will take it out!

 

RT

[06pirate]

You are not the first person to consider firearms in place of wrenches. Some local genius tried a shotgun to loosen his lugnuts a few years ago. Too bad for him.

 

 

http://www.seattletimes.com/seattle-news/revenge-of-the-lug-nut-kitsap-county-man-gets-hurt-when-he-blasts-car-wheel-with-shotgun/

[00Silverado4x4]

Do you think a ak47 bullet would be able to get a U-joint out of the drive shaft? Mine wont budge.

So I should be moving this thread to the "How-to" section? lol