Jump to content

Recommended Posts

Posted

I suddenly began hearing what sounds like a ball bearing rolling around behind the face of the dash in my 2018 Silverado. I've checked every space I could access inside the cab and in the engine compartment, but nothing was found. Anybody have a similar issue? 

Posted

Could be something like a nut from a tree got into the HVAC system.  Had leaves get in my blower in a previous vehicle and made a bad noise. No idea how they got in there.

Posted

Uncle years ago had a rattle in the door of a new car.

Dealer found a Coke bottle in the door with a note inside the bottle that said something like "you found me"

 

:)

  • Like 1
Posted

I laughed when I read this because in my day it would most likely be ball bearings or marbles down the vents.  We often lost "steelies" or marbles in the car! (and we were allowed to sit in the front seat!) :-)

  • Like 1
Posted
1 hour ago, Donstar said:

I laughed when I read this because in my day it would most likely be ball bearings or marbles down the vents.  We often lost "steelies" or marbles in the car! (and we were allowed to sit in the front seat!) :-)

Dang...haven’t heard or even read the word “steelies” for probably 45 years. Thanks for the memories ???

Posted
9 minutes ago, SS502 said:

Dang...haven’t heard or even read the word “steelies” for probably 45 years. Thanks for the memories ???

 

How 'bout "aggies"?

  • Like 1
Posted
11 minutes ago, duquephart said:

 

How 'bout "aggies"?

Other than those guys from Texas...no but they were second to only the Steelies! Ah the good ole days ?

Posted
23 minutes ago, SS502 said:

Dang...haven’t heard or even read the word “steelies” for probably 45 years. Thanks for the memories ???

I'm with ya.

Cat eye's.

:)

  • Like 1
Posted
1 hour ago, diyer2 said:

I'm with ya.

Cat eye's.

:)

 

Bumble Bees. Mustard & Ketchup. This could take all day.

Posted
1 hour ago, duquephart said:

 

Bumble Bees. Mustard & Ketchup. This could take all day.

Good ones! Tradesies?     … I hope Geezerglide16 is finding this information helpful!

Posted

Sounds like the grandkids dropped something in the vent. (nasty little buggers I do not let them in my truck) Might be a good opportunity to purchase a borescope they make them now that connect right up to your smartphone for CHEAP  Check this one out     https://www.amazon.com/DEPSTECH-Semi-Rigid-Inspection-Megapixels-Waterproof/dp/B06WRNGYXY/ref=pd_lpo_vtph_469_lp_t_3/144-4291733-7538323?_encoding=UTF8&psc=1&refRID=K4G9036R4HMB55X0EMGV   

 

Might find like a million dollar rare coin in there Hahahahaha 

Posted

Thanks for the link...just ordered it. My wife and I are the only ones who ever ride in the truck, and we never put anything on the dash. I'm betting its a screw or something that came loose inside the heating duct. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,915
    Total Members
    8,960
    Most Online
    ChristopherDobson
    Newest Member
    ChristopherDobson
    Joined
  • Who's Online   3 Members, 0 Anonymous, 1,253 Guests (See full list)

  • Latest Articles

  • Posts

    • Monthly payment is only part of the equation. With today's prices and interest rates, I'd look at the total monthly cost: payment, insurance, registration, fuel, maintenance, and expected repairs. A vehicle that fits comfortably into your budget is usually the better choice than stretching for a higher trim. I've also kept my vehicles longer over the past few years. New cars have gotten expensive enough that driving one for 10+ years, while staying on top of maintenance, often ends up being the most cost-effective approach.
    • 10 Ford and Chevy engines proven to reach 300,000 miles   You may note a common 3K OCI on this list of gas motors. I skipped over the diesels. Dh'O. 
    • Thanks newdude!  By the time manual selection is needed, I'm probably too much of a control-freak to depend on the transmission sensing braking to activate automatic downshifting.  I would be anticipating the situation and already be manually downshifting.   This truck replaced a 2004.5 LLY diesel with the Allison 5-speed.  Putting it in T/H made noticeable differences (when the torque converter locked, upshift points, downshift behavior).  On this 2024 gasser with the 10L1000 I haven't been able to detect much, if any, difference.  Ok, I can never tell now when the torque converter locks up.  But I also don't notice differences in shifting.  For downhills, I've probably already manually downshifted by then anyway.  Since it's also more awkward (than the 2004.5) to engage/disengage I don't even bother.  Or maybe it doesn't really matter with just a 3k lb. camper in the bed?   Thanks also for the list of reasons the charging system might select various voltages.  However, what I am seeing doesn't fall into any of those categories.  It very definitely, and very consistently, rises after coasting/braking.  Maybe not immediately, but not very long after coasting/braking.  Very consistently drops voltage when no longer coasting/braking.  It might also be interacting with the camper battery charging (I might disconnect the camper and see if it changes the charging behavior).  I also need to recheck turning on headlights for when I want to force it to charge the camper.   Another JR, in June I converted the camper to LiFePO4.  Since it's not a good idea to try to charge lithiums directly using truck, I installed a Victron Orion XS DC-DC charger (which BTW is AMAZING!!).  Being cheap, I only had to buy that one item (besides the battery, of course) to do the conversion.  The camper OEM 120v battery charger (only 19 years old and works perfectly) and the truck feed the input to the DC-DC charger (not at the same time).  But I didn't want the camper charger feeding back to the truck so I kept the old separator.  I considered replacing the separator with a 30amp diode but that means more work and might add another 1/2 volt drop.  One thing that surprised me was the voltage drop over the long 10awg wire run, so I can only charge smoothly at 8 amps (because the DC-DC charger is completely configurable).  Another reason I don't want an added voltage drop with the diode.  I might also be a little lazy but all this work is being done under the sink with a small cabinet opening.    
    • apparently CA smog is (or at least was)  checking that the vehicle is using the oem and/or a ca smog approved tune, so I expect you'll fail inspection doing it.
    • yes, leaking exhaust will mess up o2 sensor readings, which in turn messes up fuel trims.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...