Jump to content

Recommended Posts

Posted
Wrong wrong wrong.  [emoji14] 

GM recommends using 93 octane gasoline for its top-of-the-line 6.2-liter V-8-equipped trucks. The owner’s manual does state as low as 87 octane is acceptable for the engine. However, to achieve maximum performance and fuel economy you must use 93.
 
So with that being said- you can get by fine for a few tanks of 87.  Won't have the same performance as you would running 91 or 93 but go ahead and do it if 91/93 is not available.  (91 above 3500-4000ft is essentially the same as 93 at sea level)
 
https://pickuptrucktalk.com/2020/10/misleading-these-trucks-recommend-or-require-premium-fuel/
 
So SHUT UP and drive. 
You can't get 93 in California. Only 91.

Sent from my SM-N960U using Tapatalk

  • 3 weeks later...
Posted (edited)
On 1/6/2021 at 12:06 PM, Transient said:

You can't get 93 in California. Only 91.

Sent from my SM-N960U using Tapatalk
 

we do have  a few 100 pumps at my local station, but price is $10/gal. but your gas milage is like 18mpg in the city and 40 mpg highway on that stuff. still not worth it. but dense hydrocarbons sure do put legs on these motors.

 

the 210 thermostat and 87 octane on a 12:1 CR motor =  sounds a bit dumb,

 

91 octane gives you a 2mpg gain over the cheap stuff. do the math  you'll see your paying more for 87 fuel /mile

 

Edited by flyingfool
Posted
we do have  a few 100 pumps at my local station, but price is $10/gal. but your gas milage is like 18mpg in the city and 40 mpg highway on that stuff. still not worth it. but dense hydrocarbons sure do put legs on these motors.
 
the 210 thermostat and 87 octane on a 12:1 CR motor =  sounds a bit dumb,
 
91 octane gives you a 2mpg gain over the cheap stuff. do the math  you'll see your paying more for 87 fuel /mile
 
I have a 6.2 and only use the premium fuel at top tier gas stations

Sent from my SM-N960U using Tapatalk

  • 1 month later...
Posted

Ok to add a little lightness to the discussion, when that zombie apocalypse arrive, your going to want as much fuel as possible to get away!

There are aftermarket options for the diesel but fewer for the gasser and none that replace the factory tank. For gasser HD when towing and getting 8mpg x36 gallons gives a max of 288miles. Now your going to stop earlier than that so at about 250 miles of travel which is less than 4 hours of traveling. I would like to travel 6 hours a day and fill up at the end which would require a 50 gallon tank. More efficient travel. Thats my reasoning behind wanting a larger tank. I do stop every few hours but its mostly roadside to piss or eat. Pulling a large 35' rig into some stations is not always the best option so doing it once a day is preferable.

Posted

I terrine only filling up while there's sunlight. Zombies are noisy, but B-rated movies have taught me they can use the darkness to sneak up on you. At least you'll have a better chance of seeing them coming while there's sunlight. Imo, filling up right before sundown and driving all night is better than driving all day. I could be wrong, and it wouldn't be the first time. However, Hollywood can't put anything in a movie that isn't true.

Sent from my SM-N960U using Tapatalk

  • Haha 1
Posted
On 2/26/2021 at 9:59 AM, GMC4Zee said:

Ok to add a little lightness to the discussion, when that zombie apocalypse arrive, your going to want as much fuel as possible to get away!

There are aftermarket options for the diesel but fewer for the gasser and none that replace the factory tank. For gasser HD when towing and getting 8mpg x36 gallons gives a max of 288miles. Now your going to stop earlier than that so at about 250 miles of travel which is less than 4 hours of traveling. I would like to travel 6 hours a day and fill up at the end which would require a 50 gallon tank. More efficient travel. Thats my reasoning behind wanting a larger tank. I do stop every few hours but its mostly roadside to piss or eat. Pulling a large 35' rig into some stations is not always the best option so doing it once a day is preferable.

Not as nice as a bigger replacement tank underneath, but a transfer tank in the bed and you can pump to the trucks tank when stopped for a bio break. 

Posted
20 hours ago, redwngr said:

Not as nice as a bigger replacement tank underneath, but a transfer tank in the bed and you can pump to the trucks tank when stopped for a bio break. 

I wish there were a gas approved tank available for the bed.. diesel yes but not gas in my area.  Ironic that I can put five jerry cans of gas in the bed but not a tank.  I'd love to have a 30+ gallon tank with a pump or directly connected to the existing gas tank.  I wouldn't necessary fill the bed tank but would use it primarily on long trips.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,972
    Total Members
    8,960
    Most Online
    Whit.the.COB
    Newest Member
    Whit.the.COB
    Joined
  • Who's Online   4 Members, 0 Anonymous, 1,257 Guests (See full list)


  • Latest Articles

  • Posts

    • Atlas, you kill me As aggravating as a project like this can be you have been unable to hide your fascination with learning and using that angst against this beast like a Ninjitsu Master. It amuses you, admit it now.      BTW, love your writing style. 😉       
    • I gotta say, I'm enjoying your narration. The troubles you've been having are amusing as you describe them. It's good to see that you're finally getting some satisfaction out the old beast though.
    • Declaring victory would upset the demons that possess this Blazer, so I won't. But I did make progress today--after it put up a fight. Always a fight.   I had the day off so I spent the morning cleaning up the shop and I thought I'd get ahead of things by filling the cooling system in prep for the final part I needed to arrive: the driver's side knock sensor. Glug, glug, glug....and then the unmistakable sound of liquid hitting the shop floor. It induces the same chagrin when the sonar and targeting laser temporarily malfunction during a late night bladder evacuation over the toilet with the bathroom light off. D'OH!!! That made a mess...   Oh, hey, that knock sensor I removed? It threads into a wet port. Who knew?! Learn something new every day. Put a pin in that chore, I'll fill it the rest of the way later.   The knock sensor arrived at about 1pm. I threaded it in, connected the wire, filled up the coolant, checked for leaks, and... drumroll.... fingers crossed for a perfect start, excellent timing, model fuel trims, and ...no squeaks... Here goes.....   No, it didn't start. At all. I cranked it a few times and it wasn't sounding good. Furthermore, I heard leaking again. Jesus H Tapdancing Christ, stop leaking all over the dang floor. This time I had accidentally overfilled the coolant reservoir and the churn of the water pump via cranking caused a bit to burp out. Ok, just, breathe... Put the flamethrower down. Dang thing wouldn't burn anyway, leaks too much...   Did you know the rotation of a round crank sensor in a round hole, matters? I do now. Took me about half hour to retrace steps and realize what I had done. Then it started right up.   No squeaks. The squeak was the old balancer.   Once it entered closed loop, fuel trims are dead on, hovering right around zero at idle. No more -30%. I'll credit the injector rebuild on that one.   Timing? I think there's an OBD 1.5 translation error with my Actron scanner. It's anywhere from -20 to -30 at idle, sometimes as high as -40 cruising. Sorry, the engine just isn't running that smoothly at -40 degrees ignition advance. It's just not. It's smooth all through the rev range and has decent power. I'm going to have to trust the seat of my pants on this one.   The new exhaust is very quiet. The old catalytic converter? Not melted, but definitely not healthy. Rains glitter when you turn it on its end...all the precious metal is flaking out. Once the new exhaust system burned in/smoked off a bit, the engine's exhaust smell is normal again. Not that I'd recommend going around huffing car exhaust, but, you know what I mean?   One problem to correct. The new exhaust has the opposite problem of the old spliced up exhaust. It wants to hit the floor where the old one wanted to rest on the cross member. Happy medium, please? Still noodling on that one, need to look at how I can adjust some hangers.   I don't know what's next. On one hand I want to run away from this thing as far and as fast as I can -- there have been a lot of NOT fun moments. On the other, now that it kinda drives nice, maybe drive it around for a little bit?   Shhh... it's not currently dripping oil all over the floor. I can see just a little wet at the bottom of the timing cover where it meets the oil pan seal. It's not dripping multiple drops with every ignition cycle, in fact, after some driving this evening it has yet to even form a drop that could drip off yet. But the weekend is young... I fully expect this could turn into Exxon Valdez by Sunday. Because this Blazer hates me. LOL.      
    • About that:   Once upon a time in a land far far away lived a car company that was shy about taking your money and wanted to be sure that they gave you more that you asked for so that you'd come back. No really, not a fairytale. 😱   But after the field got thinned out enough to limit the competition it seemed good enough to give you only what you asked for. Fair enough I say but in such a market you have to give something the others are not or they go to the one who does. Gimmicks or glitz. Oh, fins and chrome. Yea, shinny crow like cars. Yum.    Field narrows a bit more and 'brand loyalty' becomes a thing and the minute it does they start thinking to themselves, "Could we make more money if we gave them less than they expect and they will hang in there for brand and comfort with the known?" They gave it a try and da*n, it worked!!    Well, what if we teach them, groom them into believing that less is "Normal" and cut some more corners. Will that work? Oh heck yea!    🤔 I wonder, can we give then WAY less than they expect and make them mad enough to spit nails and STILL get them to pay up? Sure, if we get everyone else to do the same so that the choice is less or nothing at all. How would be do that? Platform sharing.  What a concept, right?  Steal like there is no tomorrow and it's legal too!    Truth is no one is going to give up driving, not for very long. The Gen Z crowd is fine with it and will be as long as someone not Gen Z will haul them around. At some point we all die.    Economic voting only works if you cast a NO vote now and again and enough of them to get dumb and dumber to wise up. Well, that's how I was taught anyway. And it should have worked. Would have worked. But the Bail out!!   Look, you have another choice if  you take that bag off your head. If the dumb it down to some predetermined expectation of how John Q Public will use it the, that is under design it to failure they you use it to a lower stress mode. D'ho!    A 1950 Royal Enfield Bullet 500 will go anywhere a Suzuki Hayabusa will and for just as long. But you will have to treat it for what it is and not for what you wish it was. 
    • Maybe I was just too unlucky, but I had nothing but bad luck with Bridgestones. Out of 3 sets, they all started losing a lot of air when they got down to about 1/2 tread life, and at that point also wet traction suffered more than it should have. Also, the only tire I ever had in my 60 years of driving that had a side wall blow out was a Bridgestone.   I'm currently running Goodyear Wrangler Workhorse AT and am very happy with them.   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...