Jump to content

Experiences driving a 3500 SRW over 2500 and a 8ft bed vs 6'10"

OmahaBen
 Share

Recommended Posts

OmahaBen Enthusiast

OmahaBen

Posted
Posted

Two main questions

 

Would you consider a 3500 over the 2500?

Would you consider daily driving the 8ft bed over the following configuration? :

 

2021 GMC 2500 CrewCab Duramax Regular Bed 4x4.

 

It is roughly $1000 more to get the 3500.   $200 for only the long Bed.

 

I can see I will lose some ride quality with the 3500.  The 8ft bed will be a bit more tricky to maneuver in Omaha.  

 

I know I will use the 8ft bed on a regular basis. 

 

Thoughts and Experiences?

 

 

 

 

davester Senior Enthusiast

davester

Posted
Posted

The 3500 may also cost more for registration and insurance, depending on what your local taxes/regulations are.

If you tow heavy stuff, consider the DRW, as it handles that better.

 

Don't know why you'd consider the short bed if you regularly haul longer stuff.

 

I dd an extended cab, cab&chassis truck, with a 10' flatbed, which is both longer and wider than a similar srw 8' bed truck, and with the backup camera, it's not a big deal to park and drive around.  You do need a bigger spot, and stick out somewhat, but a backup camera and mirrors, I can get into a spot if it's wide enough, and right up to whatever's behind the truck.

 

 

cNate Enthusiast

cNate

Posted
Posted

What’s the difference between the 2500 and 3500 SRW of all other configuration is the same? Is it a heavier duty leaf in the rear that provides the increased payload and stiffness?


Sent from my iPhone using Tapatalk

Tomato Enthusiast

Tomato

Posted
Posted (edited)

Long beds are much easier to get around and deal with than you think. I actually went to a DRW long bed this time (daily driver) and was quite worried when I ordered it. I've had it since February with no regrets. Much easier than I thought after about 2-weeks of getting used to it.  And you can't beat the extra space in the bed with the 8'. 

Edited by Tomato
  • Like 3
  • 2 weeks later...
Stand By Enthusiast

Stand By

Posted
Posted

I haven't actually measured turning radius, but it's pretty good on these. I have a 2500 with heavy front springs. Ride is fine, don't believe a 3500 ride would be different. You don't get into the extra leaves until loaded. The 3500 does have a larger rear diff. 

StinkyCheese Senior Enthusiast

StinkyCheese

Posted
Posted

If you can afford it go for the 3500 SRW.  Always nice to have extra capacity for little if any empty ride impact.  Personally I'll never go back to a short bed and going from a crew cab 2500 short bed to a crew cab dually wasn't as huge of a deal as everyone seems to make it out to be.  Maybe the fact that I avoid cities by default helps but yeah.  With a dually I'm guaranteed an 8ft bed.  So would I choose a 3500 SRW 8ft over a 2500 short bed?  Yes, every single time if given the choice.  You already said you'd use the 8ft bed on a regular basis so you answered your own question :)

Njmurvin Enthusiast

Njmurvin

Posted
Posted

Comparing the Silverado 3500 CC 6'10" bed to my 04.5 Dodge Ram 3500 QuadCab 6'6" bed, the turning radius is way longer on the Chevy. I think it has more to do with the bigger cab in the Chevy (and resulting longer wheelbase). In fact, it feels very comparable to my brother's 06 Dodge Ram 3500 QuadCab with an 8' bed.

 

But, comparing GM CC short to GM CC long bed, I wouldn't expect as dramatic of a difference.

newdude Senior Enthusiast

newdude

Posted
Posted

Payload is the biggest thing I think 3500 > 2500.  If you run a big 5th wheel camper or a heavy travel trailer, 3500 will give you a better payload safety net vs. the 2500.  And yes, the 2500 can do much more payload than the old trucks, but the 1 ton is still more.

 

The door sticker is the definitive identifier based on how the truck is equipped, but on average its a 500-700lbs increase in payload on the 1 ton over a 2500.  

 

JimCost2014 Senior Enthusiast

JimCost2014

Posted
Posted

$1000.00 over the course of 60 to 72 payments is a small amount to have more truck than you need, but there when you really do need it.

davester Senior Enthusiast

davester

Posted
Posted

Note, depending on location, it can cost more than just the difference in purchase price, as insurance, licensing/registration fee's can also be higher for the 3500 vs the 2500.

JimCost2014 Senior Enthusiast

JimCost2014

Posted
Posted
1 hour ago, davester said:

Note, depending on location, it can cost more than just the difference in purchase price, as insurance, licensing/registration fee's can also be higher for the 3500 vs the 2500.

Really think enough to buy a truck that does not work for the OP going with the short bed 2500?

 

Either truck is going to be $70000.00 plus, I think he could probably handle a few more dollars to get what he needs if he can afford either truck.

Sledguyry Enthusiast

Sledguyry

Posted
Posted

In Minnesota 1 ton tabs are $120 a year. A 3/4 ton is 4-5 times that here. Easy decision for me.

 

 

Sent from my iPhone using Tapatalk

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.

  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts

  • Member Statistics

    342,912
    Total Members
    8,960
    Most Online
    RangerRick17
    Newest Member
    RangerRick17
    Joined

  • Who's Online   5 Members, 1 Anonymous, 600 Guests (See full list)

  • Latest Articles

  • Posts

    • newdude
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By newdude · Posted

      No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • jaszr2
      Active Grille Delete

      By jaszr2 · Posted

      Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
    • devonthegreat
      anyone interested in a 2002 Chevy Silverado 4x4 parts truck NYC

      By devonthegreat · Posted

      **SOLD** Please end or delete post. thank you
    • PBNB
      Tire pressure for 37s

      By PBNB · Posted

      Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...