Jump to content

Recommended Posts

Posted

Hello all,

 

I have a 2020 Silverado RST 5.3 8 speed. I have read all about the problems with harsh shifting, clunking, etc.. 

 

I have experienced some of the issues myself and feel like I am hypersensitive with paying attention to gear changes while i drive. The hesitation/harsh shifts sometimes happen, the clunk sometimes happens. Not everyday, but often enough for me to notice.

 

My question:

 

Will this thing actually last or is it going to cause me a headache down the line? I’m not super savvy with transmissions, so this is why I ask. I want a solid, reliable truck that’s going to last me a long time with no issues. Will this thing last? Or should i dish this thing off and consider a different truck. Any answers will be greatly appreciated.

 

Thanks!

Posted

I had a 8 speed in my 2015 6.2 and once the fluid issue was sorted out tranny was fine hptuners helped too. But from I’ve heard talking to guys in my area who run camaros hard with the 8 speeds they say there a pretty bulletproof tranny. I’m sure more ppl will respond also.

Posted

Mine works fine after the flush and reflash. 
 

Remember some of the clunks and jerks are from GM finally realizing these 350+ horsepower engines need beefy transmissions. These things are big with big moving parts. 

Posted
16 hours ago, Jmoss17 said:

Hello all,

 

I have a 2020 Silverado RST 5.3 8 speed. I have read all about the problems with harsh shifting, clunking, etc.. 

 

I have experienced some of the issues myself and feel like I am hypersensitive with paying attention to gear changes while i drive. The hesitation/harsh shifts sometimes happen, the clunk sometimes happens. Not everyday, but often enough for me to notice.

 

My question:

 

Will this thing actually last or is it going to cause me a headache down the line? I’m not super savvy with transmissions, so this is why I ask. I want a solid, reliable truck that’s going to last me a long time with no issues. Will this thing last? Or should i dish this thing off and consider a different truck. Any answers will be greatly appreciated.

 

Thanks!

Welcome to the site.

 

Just out of curiosity, not trying to be mean/start a fight, why did you buy a truck that you have so many fears with?

Posted

I am no mechanic and do not know a lot about transmissions but I will tell you that I had the 8 speed transmission in my 2018 Silverado and had no issues what so ever. I had put 85,000 miles on it before I traded it in (the only reason for the trade in was the super high trade in value, and I found an AT4 with the 6.2 V8). Every now and then I had a hard shift but it was rare.  I honestly believe if you take care of these trucks they will last darn near forever. 

  • Like 1
Posted

I have had a few sloppy shifts, and every week or so I would have a day of hard downshift into 1st. It has got better with time. Now it rarely downshift hard. Got 17,000. I don't see hardly any people needing trans work on the newer trucks. You will see a few people on here with problems but you got to thinks there's millions of the new trucks on the road.

Posted

I have a 2020 5.3 w/ 8-speed transmission and have had ZERO issues with it.  GM allegedly got the fluid type issues figured out and started utilizing the updated transmission fluid type in late 2019 so most of the issues that owners have had were resolved with the 2020 models.

Posted

Hey there, absolutely no offense taken!

 

I got in a surprise wreck last September which totaled my vehicle and put me in the market for a new one. For work purposes, I needed a replacement vehicle as soon as possible. The first dealership I went to was a GM dealer. Pulled the trigger on a silverado in more of a rushed fashion as the dealer was able to negotiate a price I wanted. I didn’t really put in the research that I would have liked to before getting the vehicle. Overall, I still love this vehicle and want to hang onto it. After experiencing some odd shifting, I researched a little more and found out a lot of people have these problems.

 

My first vehicle ever was a 2002 silverado. I sold it a while back and have wanted another one ever since. These forums are tweaking me out a little bit to be honest and I am hopeful that this truck will be badass and serve me for many years! It is reassuring to see people aren’t having problems for the most part! 

  • Like 1
Posted

Thanks everyone for the replies. Being new to the site, I am having issues figuring out how to reply to every single thread. That said, I appreciate everyone’s insight! 

 

Like I said, this issue doesn’t happen everyday, but certainly enough for me to notice. Hoping it resolves itself over time like some of you have mentioned!

 

 

Posted
On 8/8/2021 at 3:08 AM, Jmoss17 said:

I want a solid, reliable truck that’s going to last me a long time with no issues.

That boat sailed about 30 years ago. If you can get 5 years out of a late model vehicle with out taking a serious beating you've beaten the odds.

Posted

Toyota, Honda, Hyundai, Some GMs there just in my experience. All 5-20 years of trouble free miles. If I was buying new today. Toyota-Lexus, Hyundai-Kia, VW, Acura, if they got rid of the road noise Honda. Heavy duty Ford Diesel GM gas. 

Posted

GM did not solve all of the 8L90 issues with the new fluid. My 2021 Silverado 5.3 with 8 speed has harsh downshifts into 1st gear at stop lights. I have left it at the dealer for the 3rd time to try to resolve this. We will see if they can do anything to cure it this time.

Posted
2 hours ago, It's Tim said:

That boat sailed about 30 years ago. If you can get 5 years out of a late model vehicle with out taking a serious beating you've beaten the odds.

 

Huh? What is a serious issue? A failed sensor? A frozen touch screen? A memory seat recall not working? Vehicles these days that statement is quite the opposite. You would be hard pressed to have a reliable high mileage vehicle 30+ years ago that you would trust and easily last hundreds of thousands of miles without plenty of TLC. Lets put it this way, I would take a 5 year old 100k truck from today and drive it around the country, I would be more leery of taking a 100k mile 1985 truck around the country. If something were to happen it would be easier to fix the older one but the chances are higher the new one would be trouble free. They may have been simpler but no way more reliable than todays vehicles. Now the meat and potatoes of vehicles are much more stout and better lasting than yesteryears they do have a ton more sensors and technologies that can fail and cause an inconvenience but it is very rare to see a major mechanical failure today outside of the roque manufacturing defects or supplier issue (not to say it doesn't happen but it is rare). It is much easier to keep an older vehicle running with it being simpler and if you are mechanically skilled to work on those failures but again, more reliable that is a hard no. 

 

OP, to answer your question, YES. What you read on forums is a very small percentage of people and it is more geared towards complainers, that transmission should give you a long time of trouble free running. 

 

Tyler

Posted

It took me a while to figure out this forum is more "new owners" than "enthusiasts".

 

This is my first new vehicle and the forums I read a lot prior to this dealt with older vehicles or offroading.  More people willing to deal with rattles, clanks, noises, and dents and other "imperfect" things since they are either older vehicles or these issues are par for the course.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,840
    Total Members
    8,960
    Most Online
    appletrav
    Newest Member
    appletrav
    Joined
  • Who's Online   3 Members, 0 Anonymous, 344 Guests (See full list)

  • Latest Articles

  • Posts

    • This is a 1/2 ton thing ONLY.  All HDs 2020-2026 have the two speed transfer case, with Autotrac as an option.     1/2 tons 2019-2026, regular 4x4s come with a single speed case (no 4LO!), and trucks with Z71 ordered, or all Trail Boss trucks come with the 2 speed case.  2 speed case is also an option on WT, and is also standard on High Country.  
    • 2013 5.3 still to this day calls for the PF48 filter.  Which as a 15psi bypass pressure.     There is a TSB, 17-NA-157 that talks about the PF-63 and PF-64 filters which have a higher bypass rating of 22psi.    TSB HERE - temp.xml   "Beginning in 2012, the oil pumps began to regulate main gallery feedback instead of pump out pressure. This means that the oil pump now does not begin to regulate until pressure is built up to the main gallery. This change reduces the amount of time it takes to provide oil to the engine bearing and lifters during extreme cold start conditions.  Main gallery feedback oil pump control systems are present on the following engine families which use Spin-on oil filters: Small Gas Engine (SGE), Large Gas Engine (LGE), High Feature (HFV6) Gen2 and Small Block Gen5 gasoline engines. These engines with the main gallery feedback oil pump control systems are factory built with an ACDelco® oil filters"   It also calls out what engines use those filters.  The gen 4 small blocks were not on that list (LMG, LC9, L9H, L92, L94, L20, L96).  Gen 5 small blocks use the higher pressure filter.          That all said...   Your 7045 Napa filter is the PF63 equivalent, with 22psi bypass.  You are already using the higher bypass pressure filter.  You CAN keep using it, you don't technically have to use it though.  
    • Do you know WHY the filter relief setting was increased to 22 psig?    When the new system goes into the second stage the pump volume ramps up considerably. It was found that the 15 psi filter bypass setting put the filter in bypass on a warm engine when the second stage was activated. Raising the filter bypass setting forced the filter to do what it designed to do. Filter. Preventing debris from circulating during high load, high rpm operation.    So next question is how did GM find this out? VLOM/lifter failures and a deep dive by Melling Corp.    Last question. Is it required? Look at it like this; a motor may be equipped with a rev limiter. But it only works if the set point in reached. That 22 psig setting only matters if the pressure differential across the filter media exceeds 15 psig during normal warm operation. Second stage kicks in around 3000-3500 rpm.    I can't answer your question because I don't know you and how you use the truck. But I think there is enough information here to let you decide for yourself. 😉
    • Probably not their first rodeo, so it should go as planned most likely.  Typically the service manager or tech doing the swap will put some seat time to shake it down after they get it all put back together.  We usually put 50-100mi before we hand them back so if something happens, its not after you get it.  A coolant leaks, oil leaks, a ground left off or loose, vibration, etc.     The new engines so far have been good?  There's been a couple that have popped out there again (the replacement engine) but most have been okay.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...