What did you do with your truck/shop today

Mckenzie · May 4, 2013

160 mile trip back home from Clemson!! And i got my new blinker/wiper/hazard switch put in !

Chris · May 4, 2013

I think my blower motor resistor went today. I can't use the "5" fan setting

Sent from my DROID RAZR MAXX using Xparent Red Tapatalk 2

MikeNH · May 4, 2013

If you lost five it is likely the high speed blower relay, not the resistor. Check the plug though as they do melt on the resistor harness.

Chris · May 4, 2013

Is that in the box under the dash?

Sent from my DROID RAZR MAXX using Xparent Red Tapatalk 2

MikeNH · May 5, 2013

Not sure honestly.

SarahsGMC · May 5, 2013

power steering pump has a blown gasket or seal whatever so thats leaking

both wheel bearings need to be replaced

my amp needs to be hooked up again because i hit bumps and the bass stops

fml

the end

brotherBONES · May 5, 2013

Washed, clay bar, amd waxed today... just to have it rain on ot a few hours later... I hate rainSent from my SCH-I535 using Tapatalk 2

MisterC190 · May 5, 2013

Changed dash... Cracked near top left corner of airbag. Gm helped fix it, so it's all good.

Apparently everyone w a 2008 and up eventually gets the same crack.

MikeNH · May 5, 2013

michigans finally warm thats all i care about

This!

Wasn't with my truck but I went with a friend in his '69 Chevelle to a cruise night at the Halo Burger in Grand Blanc. Quite a few nice cars on display.

Edited May 5, 2013 by MikeNH

kstruckcountry · May 5, 2013

I love Chevelles. Very cold here today. Worked on outfitting an 07 Cummins with balebed and hydraulic pump. I'm glad my pickup is so easy to work on under the hood, it's a bit of a chore just to get off the belt on these Dodges.

Daryl LBZ · May 5, 2013

I love Chevelles. Very cold here today. Worked on outfitting an 07 Cummins with balebed and hydraulic pump. I'm glad my pickup is so easy to work on under the hood, it's a bit of a chore just to get off the belt on these Dodges.

That's one thing I've always liked about GM's Trucks.

SarahsGMC · May 5, 2013

I think my blower motor resistor went today. I can't use the "5" fan setting

Sent from my DROID RAZR MAXX using Xparent Red Tapatalk 2

mine went while the heat was on 5 the resistor melted and blew smoke into the cab it melted so bad that the fans stayed on i had to pull the fuse.. the resistor is under the glovebox on passenger side right in middle closer to door, go in unplug it if you need to, if you are under i believe 150,000 miles they will replace it for free since it is under recall