Jump to content

What did you do with your truck/shop today

SarahsGMC

By SarahsGMC
in The Off-Topic Bar

 Share

Recommended Posts

SouthCo Senior Enthusiast

SouthCo

Posted
Posted

Changed the oil a few days ago. Noticed the steering rack was seeping. Made an appointment today for that and the transmission tube fix since the warranty ends at the end of the month. Then cleaned her inside and out.

  • Replies 16.9k
  • Created
  • Last Reply

Top Posters In This Topic

  • Chris

    2024

  • RyanbabZ71

    1417

  • Jsdirt

    1327

  • SarahsGMC

    1181

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

C25A1guy
C25A1guy

Took my wife to labor & delivery. Daughter born.

Chris
Chris

I drove across town to pick up my degree since im still waiting on parts

srwoolc
srwoolc

Took my truck into the back country of Colorado.     Sent from my SAMSUNG-SM-G930A using Tapatalk

Posted Images

SarahsGMC Senior Enthusiast

SarahsGMC

Posted
  • Author
Posted

Heading across state today been awake since 2pm yesterday, instead of boring gas consuming highway I'm taking scenic route hitting all the farm towns. It's not bad.

99silveradoz71 Senior Enthusiast

99silveradoz71

Posted
Posted

^Sounds like a nice day. Went down south and had a nice lunch before doing some vegetable shopping and making it a lazy afternoon.

Chris Senior Enthusiast

Chris

Posted
Posted

Installed the Scangauge 2 in my truck

20130802_200241_zpsb0cef41a.jpg

kstruckcountry Senior Enthusiast

kstruckcountry

Posted
Posted

Installed the Scangauge 2 in my truck

20130802_200241_zpsb0cef41a.jpg

I thought about putting mine there, but I decided it was easier to see up on the dash. I've had a few people ask if it's a "tuner". :lol:

Chris Senior Enthusiast

Chris

Posted
Posted

It's not bad with it there. I used to have my tablet there. But this time the lower compartment is usable and so are both cupholders.

SarahsGMC Senior Enthusiast

SarahsGMC

Posted
  • Author
Posted

Well me and Ethan replaced an inner tie rod because it was blown tomorrow our friend will align it should be good to go after that we will replace the driver side soon since its on its way out eventually.. Going to truck warz tomorrow as well. Just relaxing with beer right now.

MikeNH Senior Enthusiast

MikeNH

Posted
Posted

Not much. Been a great week in Vermont seeing friends I only see once a year and a few I haven't seen in ages. Truck is gassed up for the short hop back to NH tomorrow. Then its office duty most of the week until I head back to Michigan.

RyanbabZ71 Senior Enthusiast

RyanbabZ71

Posted
Posted

nothing

 

Hung out around some cool cars and worked the camarocross event

 

Thats me in the yellow vest (photo taken by a guy from GM)

 

Only a few casualties. The worst being the ZL1 that hit a barrier

 

 

 

 

DSC00232.JPG

ImageUploadedByTapatalk1375495732.227531.jpg

ryan.jpg

DSC00232.JPG

ImageUploadedByTapatalk1375495732.227531.jpg

ryan.jpg

DSC00232.JPG

ImageUploadedByTapatalk1375495732.227531.jpg

ryan.jpg

DSC00232.JPG

ImageUploadedByTapatalk1375495732.227531.jpg

ryan.jpg

SarahsGMC Senior Enthusiast

SarahsGMC

Posted
  • Author
Posted

I got the best look ever when I bought these

did that stop your PS leak? replace seal?

Not really but ya not leaking red so I'm thinking it is still leaking old fluid, I'm going to get some Lucas stop leak

RyanbabZ71 Senior Enthusiast

RyanbabZ71

Posted
Posted

Running the start line on Class 1-3 camarocross this afternoon.

 

 

starting.jpg

starting.jpg

starting.jpg

starting.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • newdude
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By newdude · Posted

      No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • jaszr2
      Active Grille Delete

      By jaszr2 · Posted

      Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
    • devonthegreat
      anyone interested in a 2002 Chevy Silverado 4x4 parts truck NYC

      By devonthegreat · Posted

      **SOLD** Please end or delete post. thank you
    • PBNB
      Tire pressure for 37s

      By PBNB · Posted

      Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...