Jump to content

Recommended Posts

Posted

Two 10 minute segments is it. No way around that as far as I know. Depending on the frost it may not totally clear the window but even with the worst of the winter last year (-15F air temp, windchill almost -40) it got the heat plenty warm.

Posted

I guess it is better than nothing. She has heated seats, so she can at least be warm while she waits for the windows to clear up.

Posted

If you need to warm up for more than 10 minutes why not just use a block heater? 20 minutes seems excessive, but then again the coldest temp I've ever been in has been in the 20's. lol

 

 

And I finally washed my truck last night, along with dressing up the rubber, plastic, and tires as usual. Looking down at her from our second story office just got more enjoyable!

Posted

Hoping to hear from the adjuster today about the final verdict on my truck. Meanwhile all I can do is look at the pictures of the truck then and now.... :(

Posted

Block heater doesn't do anything for getting warm air into the cab, and it still takes a while to get the coolant warm. Unless it's extremely cold (-30 or less) I'd bet the electricity to run the heater costs more than the fuel to idle for a few minutes.

  • Like 2
Posted (edited)

This was about a week ago... But I couldn't get past this sand section since my left wheel would just dig in. So much for off roading. lol

 

a4c8edc743e05e978aadfb143d48e5dc.jpg068952da6abb05cf9a82603f9d703869.jpg

Edited by white1500
Posted (edited)

I wish there was cold and snow in Colorado

 

I mean this with all due respect. Dumb a**, (said in the Red Foreman tone from that 70's show) be careful what you wish for. :lol:

 

It has been sub zero wind chills in IL most of the week & cannot wait until this crap is gone.

Suppose to be 31(will wash truck) Sunday to get the salt off. But that 31 degree temp has

a ice/snow storm following it Sunday eve into Monday & the temps go right back down to single digits. :banghead:

 

My joke & thoughts of winter aside, this crash on I94 in MI has been on the news the past couple of hours.

Sad day for multiple families & in particular for the one life that was lost.

http://www.freep.com/story/news/local/michigan/2015/01/09/i-94-pileup-kalamazoo-county/21500281/

Edited by '01LS1
Posted

Gm has a decent on on the Cruze and aveo I think but I really like Chryslers black metallic.

 

Was reading the other day Chrysler/Ram is bringing it back on the trucks. The article mentioned they only switched to straight black

after the earthquake/tsunami in Japan a couple years ago. A major component of the color was either sourced or the tech was based there.

Posted

Gm has a decent on on the Cruze and aveo I think but I really like Chryslers black metallic.

 

GM has it too. I think it's Granite Black Metallic or something. Saw it on a Caddy CTS-V at the GM display up at Ignace a couple years ago. In the sun the color was stunning.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Are you playing Slide Down endlessly but your score is still low? Are you constantly crashing into obstacles as the game speed increases? Don't worry, this article will share 5 invaluable tips to help you master the race and impress your friends. Golden Rules 1. Look one step further. The mistake of 90% of new players is only staring at their character. The secret of experts is to look towards the top of the screen (where the slide is about to appear). This gives your brain an extra 0.5 - 1 second to process the situation and determine the direction of movement before the obstacle approaches. 2. Use gentle movements; don't swipe too hard. Slide Down is very sensitive. Moving your finger too forcefully or with excessive amplitude will cause your character to be thrown off course or crash into a wall. Practise moving your finger with small, decisive, and precise movements. 3. Don't be greedy for gold in dangerous locations. Gold coins are tempting for buying skins, but life is more important. If you see a gold coin right on the edge of a cliff or next to a spike trap, ignore it. Our goal is a High Score, and your score only increases if you survive. 4. Make the most of Power-ups. During the slide, you'll encounter items like Magnets (attract gold) or Shields (temporary invincibility). Never miss them! Especially the Shield, it's your "get out of jail free card" to help you get through those deadly fast sections. 5. Stay calm when speed peaks. When your score exceeds 500 or 1000, the game speed will be very fast. At this point, don't try to think logically; let your natural reflexes work. Take deep breaths and don't panic. Apply these 5 tips to your next game, and your leaderboard will surely improve dramatically. Good luck climbing the Slide Down leaderboard!
    • If you use compressed air regularly, one problem you cannot ignore is moisture. Water in the air line can cause rust, unstable air pressure, poor tool performance, and even damage to sensitive equipment. That is why I highly recommend using a desiccant air dryer. A desiccant air dryer is designed to remove moisture from compressed air by using drying materials such as activated alumina or molecular sieve. Compared with basic water separators, it can achieve much lower dew points, making it especially useful for applications that require dry and stable air. For workshops, painting systems, pneumatic tools, CNC machines, laser cutting equipment, and industrial production lines, a desiccant air dryer can make a big difference. It helps protect equipment, improve air quality, reduce maintenance costs, and extend the service life of the whole compressed air system. Another advantage is reliability. Many desiccant air dryers are built for continuous operation and can maintain stable drying performance even in demanding environments. For users who care about long-term efficiency and equipment protection, this is a smart investment. When choosing a desiccant air dryer, I suggest paying attention to air flow capacity, working pressure, dew point performance, regeneration method, and maintenance requirements. A good model should match your compressor system and actual air consumption. Overall, if moisture is causing problems in your compressed air system, a desiccant air dryer is definitely worth considering. It is practical, efficient, and highly useful for anyone who needs clean, dry, and reliable compressed air.
    • My brand new 2007 Silverado's wax frame was rust from end to end partway through it's SECOND winter here in MA. That stuff is completely useless.    
    • I went another direction after losing a trailer tire, thanks to not being able to access air at ANY of the 5 gas stations and garages I stopped at prior, with a Toyota Tacoma onboard, 50 miles from the Canadian border. They were either out of order, access was blocked, or the hose a few feet too short and I couldn't get any closer without risking damage to someone's property.   https://postimg.cc/gallery/X5QJ55w
    • I took a 12 second video on my iphone but the file is too big to upload. I will have to figure out how to extract the audio or just do another start with an audio recording. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...