Jump to content

Recommended Posts

Posted

I didn't see any oil filters????? You might need to make another trip. :jester:

In the toolbox, have around 8-12

 

 

Ryan

Posted (edited)

In the toolbox, have around 8-12

 

 

Ryan

I did that once, during one of those Advance Auto $50 off $100 for first thousand uses online sales......

 

 

Then I spent a few years hoping none of the cars got totaled before I could use them.

 

 

I still have a set of the expensive OE ACDelco plugs for the Shortstar V6 I never got around to using. Miss that engine's low end.

 

 

Anyone with a Intrigue 3.5 or Aurora V6 need some plugs?

Edited by SnakeEyes
Posted

Luckily the car and truck use the same filters

 

 

Ryan

Posted

Well i went to the mall today. Needed shoes. Spent about 2 hours in there. When i walked out i saw my windows were down. I forgot to roll them up. I was pulling my school uniform shirt off in the lot while it was running and then just killed the ignition and walked away

Posted

I drove my truck to the dealer ship and starting to wonder about trading in my 2013 Silverado next year. Just trying to decide what I want I'm thinking a regular cab short box Z71 Chevy definitely not a GMC. Any way that's what I did with my truck today.

Posted (edited)

Luckily the car and truck use the same filters

 

 

Ryan

Or, well, Tornadoes. But they'd take care of the filters also......

 

Thaat season is just around the corner, I had enough fun and excitement a few years ago when I recorded that one, still good for a while. [emoji23] [emoji26]

Edited by SnakeEyes
Posted

gassed up, 80 miles away from 50K (will happen this week)

Posted

damn

 

My wifes van is close to hitting 30K

  • Like 1
Posted

Drive her for work and then the 420 mile round trip I just made didn't help any. Be putting another 80 on tonight so it'll be a 500 mile run today

Posted

42ef174c5d7fd22b8ec0197af2d2e93a.jpg

Trucks almost 11 months young.... all the miles have been from me and a couple family members. ... not 1 problem

  • Like 1
Posted

42ef174c5d7fd22b8ec0197af2d2e93a.jpg

Trucks almost 11 months young.... all the miles have been from me and a couple family members. ... not 1 problem

Glad to see I'm not the only one putting crazy miles on my truck
Posted

It's the DMV. That's just normal my wife average is 40,xxx + the last three years

  • Like 1
Posted (edited)

Swapped out the cabin air filters, hadn't done it since 2011...

 

Old vs new (dark stuff is carbon material?)

 

b80902061aa8330a1b49b3e0dc5b6e97.jpg

Edited by white1500
Posted

Or, well, Tornadoes. But they'd take care of the filters also......

 

Thaat season is just around the corner, I had enough fun and excitement a few years ago when I recorded that one, still good for a while. [emoji23] [emoji26]

124b30c3a0ae8c02bb16e27c4a9e9b1c.jpg

 

fa862cc01bdb640d649904e412f26518.jpg

 

 

Ryan

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • I have the same running boards on my truck and I do agree they are bulky. I also find myself stepping over them when getting in and out of the truck. Besides providing protection to the rocker panels, they aren't very useful.  I will be replacing them soon with the Amp Powersteps. 
    • Monthly payment is only part of the equation. With today's prices and interest rates, I'd look at the total monthly cost: payment, insurance, registration, fuel, maintenance, and expected repairs. A vehicle that fits comfortably into your budget is usually the better choice than stretching for a higher trim. I've also kept my vehicles longer over the past few years. New cars have gotten expensive enough that driving one for 10+ years, while staying on top of maintenance, often ends up being the most cost-effective approach.
    • 10 Ford and Chevy engines proven to reach 300,000 miles   You may note a common 3K OCI on this list of gas motors. I skipped over the diesels. Dh'O. 
    • Thanks newdude!  By the time manual selection is needed, I'm probably too much of a control-freak to depend on the transmission sensing braking to activate automatic downshifting.  I would be anticipating the situation and already be manually downshifting.   This truck replaced a 2004.5 LLY diesel with the Allison 5-speed.  Putting it in T/H made noticeable differences (when the torque converter locked, upshift points, downshift behavior).  On this 2024 gasser with the 10L1000 I haven't been able to detect much, if any, difference.  Ok, I can never tell now when the torque converter locks up.  But I also don't notice differences in shifting.  For downhills, I've probably already manually downshifted by then anyway.  Since it's also more awkward (than the 2004.5) to engage/disengage I don't even bother.  Or maybe it doesn't really matter with just a 3k lb. camper in the bed?   Thanks also for the list of reasons the charging system might select various voltages.  However, what I am seeing doesn't fall into any of those categories.  It very definitely, and very consistently, rises after coasting/braking.  Maybe not immediately, but not very long after coasting/braking.  Very consistently drops voltage when no longer coasting/braking.  It might also be interacting with the camper battery charging (I might disconnect the camper and see if it changes the charging behavior).  I also need to recheck turning on headlights for when I want to force it to charge the camper.   Another JR, in June I converted the camper to LiFePO4.  Since it's not a good idea to try to charge lithiums directly using truck, I installed a Victron Orion XS DC-DC charger (which BTW is AMAZING!!).  Being cheap, I only had to buy that one item (besides the battery, of course) to do the conversion.  The camper OEM 120v battery charger (only 19 years old and works perfectly) and the truck feed the input to the DC-DC charger (not at the same time).  But I didn't want the camper charger feeding back to the truck so I kept the old separator.  I considered replacing the separator with a 30amp diode but that means more work and might add another 1/2 volt drop.  One thing that surprised me was the voltage drop over the long 10awg wire run, so I can only charge smoothly at 8 amps (because the DC-DC charger is completely configurable).  Another reason I don't want an added voltage drop with the diode.  I might also be a little lazy but all this work is being done under the sink with a small cabinet opening.    
    • apparently CA smog is (or at least was)  checking that the vehicle is using the oem and/or a ca smog approved tune, so I expect you'll fail inspection doing it.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...