Jump to content

Recommended Posts

Posted

Pulled the trigger on some DC Gunmetal 7 wheels. Half an inch more offset than stock, should look good IMO

 

c5f1f9f5e65467e2b359b351dd432179.jpg

That is gonna look awesome! Can't wait to see them on the truck.

  • Like 1
Posted (edited)

Took the family and Dog to Outter Banks for the week. First road trip with the new truck.

 

Oh yeah, hurricane chased us out one day early.

post-156876-0-98367400-1472953733_thumb.jpeg

post-156876-0-98367400-1472953733_thumb.jpeg

post-156876-0-98367400-1472953733_thumb.jpeg

post-156876-0-98367400-1472953733_thumb.jpeg

Edited by DAY11
Posted

Parking lot, not pictured a K2 Sierra AT

 

2af1f8138f29b66140a6b18b52064b45.jpg

 

 

Ryan

Posted

Drove down to River Ranch with a friend for an over night get away. Sometimes I think Google knows me too well. It took us down a 10 mile dirt/gravel road instead of a paved road. Got to see lots of Florida ranch land on the 1.5 hour drive there, as well as the return trip. Truck got a good dirt/mud water bath on that dirt road. The stay at the ranch was fun even if some of the activities were closed due to all the rain we've been having.

 

6a76ef9a6d682f731bbb313e1e4ad237.jpg

 

Truck needs a good bath now, I don't think the rain that's going on now is going to do much to clean it. If it stops raining my buddy and I are going to install a bunch of lights on our trucks. Also need to check the tranny filter as there's an ever so tiny bit of fluid accumulating on the filter bottom, only about a drop. Nothing falling on the driveway that I can tell.

Posted

Now that tropical storm Hermine is gone I decided to give it a much needed bath and shine.

 

IMG_2688_zpsgpj2nlrc.jpg

Posted

7f28e83743a2d8e6eff9f9c6a85ddb8d.jpg

 

Tailgate used as a table for our seafood boil

 

 

Ryan

Posted

Packed up and drove home. Cleaned the interior of the truck

 

67b5c245421f7884c95ffbfe864c5c0e.jpg

 

e40e19c470843736c1332e85dcb6ad74.jpg

 

d4ca94b12ef33cc7d95b838a9dd59cba.jpg

 

0ae0830c6bf0c6a189afbfbbbfb15429.jpg

 

 

Ryan

  • Like 1
Posted

I built some headlights and fired off a few rounds at some tannerite off the 86 [emoji23] attachicon.gif20160904_200506.jpghttps://vimeo.com/181439261

 

Sent from my SM-G925V using Tapatalk

GOOD GRIEF, WOMAN! I'd hate to piss you off!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,912
    Total Members
    8,960
    Most Online
    RangerRick17
    Newest Member
    RangerRick17
    Joined
  • Who's Online   5 Members, 1 Anonymous, 557 Guests (See full list)


  • Latest Articles

  • Posts

    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...