Jump to content

Recommended Posts

Posted

Dealer just called, they changed the -battery cable, hopefully this will last!!!

Another week?

  • 3 weeks later...
Posted

 

 

here is the new starter pt # 12655055

 

Just a followup--mine was built in early January in Mexico and it has the new starter:

 

 

Starter.jpg

 

 

I'm guessing that means everybody with a truck built around that time or later likely has the new starter as well and should have no problems related to it. It is possible to check with it on the vehicle as you can see, but it's not all that easy. I stuck my phone in there and started taking blind pics until I grabbed the part number.

  • 1 month later...
Posted

Hi folks... this ignition problem just started for me this morning. No moisture (rain), dry conditions and sunny. Since I got my 14 Rado last February, I felt a weirdness in the ignition but couldn't figure out what it was. This morning, I got nothing on three attempts then it started as usual. I backward read the posts here (yes I'm lazy) to see if a solution has been implemented. It appears that it hasn't.

This is my third Silverado and my two previous models have been completely problem free... I feel that this 2014 model will be problematic.. not happy with all the problem issues on the Net.

  • 2 weeks later...
Posted

Anybody having issues related to the "Theft Deterrent" system causing it to not start? I have less than 1,000 miles on my new '14 Silverado dbl cab & I've had it not start at least a half dozen times now in the last week & the DIC just flashes a Theft Deterrent msg on it & the truck doesn't start. I turn the key back off, open the door & lock & unlock the doors with the power lock button on the drivers door & have had pretty good luck with it starting after that. Sometimes it stays running just fine, other times it stays running & the theft deterrent light stays on until I get to my destination & shut the truck off.

Today was the worst it's been, this far. I had it happen 4 times today, each time it failed, I was ultimately able to get it started, but had to play with it for almost 5 minutes each time to find something that got it to turn over(locking and unlocking the doors, opening the door closing the door, locking and unlocking your steering wheel, etc.)

I haven't had a chance to get it into the dealer yet. I will be scheduling an appt this week, but any insight would be greatly appreciated. Thanks.

 

 

Sent from my iPad using Tapatalk

  • 6 months later...
Posted

Purchased new 2014 Silverado, 2wd, 8 foot bed, 5.3 on 1/10/2015 with 12 miles on it. With in ten miles of use then cold morning temps placed key in ignition one click then blacked out gauges then 2nd try it started. The next day cold in morning four attempts before starting(one click black out dash) The next morning four attempts again each time one click blacked out dash! Went to dealer and it already has new starter put in because of build date. So begins checking software and resistance of battery cables! Dealer could not produce the event he had the truck for two days and is keeping it for now. I went to try it my self and it started in 10 degree temps on1/17/2015 ! Unhappy five time GM owner will keep at it and let you know.

Posted

Purchased new 2014 Silverado, 2wd, 8 foot bed, 5.3 on 1/10/2015 with 12 miles on it. With in ten miles of use then cold morning temps placed key in ignition one click then blacked out gauges then 2nd try it started. The next day cold in morning four attempts before starting(one click black out dash) The next morning four attempts again each time one click blacked out dash! Went to dealer and it already has new starter put in because of build date. So begins checking software and resistance of battery cables! Dealer could not produce the event he had the truck for two days and is keeping it for now. I went to try it my self and it started in 10 degree temps on1/17/2015 ! Unhappy five time GM owner will keep at it and let you know.

This sounds to me like a bad connection in the wiring somewhere. Not necessarily battery cables though.

Posted

New to this.

I have a 2015 gmc 3500 hd single wheel. I have 6.5 BDS lift on it with 35 inch tires. I put the lift on with 2000 km on the truck. Now I have 43000 km on it.

Iv seen some post about some 1/2 tone trucks with vibration problems

Well on my 2015 im getting vibration from 60 mph and around 75 mph. Any one Elsa having this or can help with find out what it is

It's not the tires I put the stock tires on and it's doing the same thing

 

 

Sent from my iPhone using Tapatalk

Posted

Update on Silverado long bed 2WD Starting issues, Checked battery cables per my request and Dealer reprogramed computer( Said it accepted the information )I don't know what that means cause the truck only had 12 miles on it to begin with! Was it not programed correctly at the factory?

Posted

Michael. Mitchell.1029, I have a 2014 crew cab slt with 20" wheels. I get a pronounced hum/vibration between those speeds as well. Dealer is baffled. Been fighting it since the first week over a year ago. Test drove other trucks and noise isn't in all of them. I'm thinking differential, but who knows.

  • 2 years later...
Posted (edited)

Hey wats up guys  Need help my truck is doing similar things as everybody else’s truck on this topic few days ago my truck didn't want to start no crake no nothing after a while it fired right up , than took batt to get tested it pass few day later same thing took starter off took it to get tested as well did not pass bought a starter kept the old one put new one in nothing I jumped the truck about 10 min fired up on first try took off new starter put old one back on did the same thing it fired up drove truck to autozone test battery and stater they past but truck won’t start again I sat there about ten mins messing with the batt cables hit the stater acople times move the lever from park to neutral nothing so I keep turning key over about 16 times one after another it fired up got home turn off and on about 4 times fired up so I don’t know what to do any more anyone else out there having same issues or any idea what’s going on with my 2014 Silverado 

Edited by Tbmack
  • 3 months later...
Posted

I Purchased My 2014 Silverado New, With in the first week, I experienced Electrical Dash board issues, No screen, system

resets. Messages Like open drivers window and Close, Anti theft deterrent disabled. the worst is turning the key and No starting. Dealer says they found no problems, during these visits. its been 4 years and still acts up. It seems random but sometimes goes thru what ever it fails to start. waiting then attempting to start again works but it is getting old. if I trade again it won't be for another GM vehicle. I have replaced the battery and cleaned all my connections including the grounds. it still occasionally repeats the starting issue.  I find the issue happens no mater how cold or warm it is, or dry or wet.   

Posted
2 hours ago, Larry Sucese said:

I Purchased My 2014 Silverado New, With in the first week, I experienced Electrical Dash board issues, No screen, system

resets. Messages Like open drivers window and Close, Anti theft deterrent disabled. the worst is turning the key and No starting. Dealer says they found no problems, during these visits. its been 4 years and still acts up. It seems random but sometimes goes thru what ever it fails to start. waiting then attempting to start again works but it is getting old. if I trade again it won't be for another GM vehicle. I have replaced the battery and cleaned all my connections including the grounds. it still occasionally repeats the starting issue.  I find the issue happens no mater how cold or warm it is, or dry or wet.   

Have you checked the battery cables themselves? Some were known to have bad terminations, as in the cable terminal wasn’t installed correctly or was pinching down on the cable insulation instead of the actual copper wire.  Other well known issue is the distribution block for the positive.  Do a search on here, lots of people with very similar issues had their problems resolved by replacing these.

Posted
7 hours ago, Larry Sucese said:

I Purchased My 2014 Silverado New, With in the first week, I experienced Electrical Dash board issues, No screen, system

resets. Messages Like open drivers window and Close, Anti theft deterrent disabled. the worst is turning the key and No starting. Dealer says they found no problems, during these visits. its been 4 years and still acts up. It seems random but sometimes goes thru what ever it fails to start. waiting then attempting to start again works but it is getting old. if I trade again it won't be for another GM vehicle. I have replaced the battery and cleaned all my connections including the grounds. it still occasionally repeats the starting issue.  I find the issue happens no mater how cold or warm it is, or dry or wet.   

Had the exact same issues on my truck, its been a year since it was fixed and so far no more problems. A couple of small glitches with MyLink but nothing like before. My issue ended up being the negative battery cable, the whole cable needed to be replaced, battery was replaced at the same time and the body ground was cleaned.  Don't know if you have tried replacing the entire negative cable yet, but it could be a solution to your problems. It is a bummer that you have had to deal with issues for 4 years. Best of luck!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • 2017 Silverado L83 5.3l 6speed transmission Hello, not a new member but havent posted in a while and my old signup info isnt working so had to create a new account. anyways, I have an issue with my truck and hope someone can spread some light on whats happening: -when it goes to 4cyl mode it makes a clunk sound (but not when coasting or going downhill) -when in 4 cyl mode and under load it makes a load pulsating sound (not a tick). -goes away completely when in M5 gear or when plugging in an AFM delete. Im guessing it is one of 2 things but im not convinced of either to be honest. 1. lifter stuck in v8 mode 2. torque converter shudder realistically it doesn't seem like the TC as there is no physical vibration , and it never happens in v8 mode. but maybe? and wouldnt a lifter make a sound whether with load or not? any ideas let me know please. thank you!  
    • Which has made me wonder with the various engine failures of a few brands in the last few years, is it sub par materials such as lifters etc causing failures, or bearing clearances on the crank etc or perhaps bad designing of an engine physically or causing too much load on the components due to the hp/torque they can push out of them. Or is the oil viscosity and additive package of current oils or a lack of oil flow by an oil pump not able to supply sufficient oil at idle or under high load at low rpm. Or is it every item I listed that combined together has pushed the limits so far to the left that there is hardly a margin of safety left and add in some fuel dilution and too long of an OCI and premature engine failure is the result ?. 
    • He is not saying that an SAE *W20 will have more viscosity than a *W40 due to MORE VII polymers. He is saying that although multiple *W40 may post in the PDS the same or similar 100 C and 150 C viscosities that the blenders choice of modifier TYPE and AMOUNT to get his chosen base to grade will not give identical real world viscosities in shear and at temperature. All will pass the SII test but not all will pass the 100 C HTHS (unpublished value) testing the blender does and relies on to get the required by law "percentage improvement' referenced to his last great work.    Tis the problem with the lie. Once told others are required to support it. 
    • I have a `25, 1500 that auto sets on incline. Never knew that at first. I have the electronic shifter. Just think if it didn`t do that? Unlike a mechanical shift that you can muscle out of park, how would you get this thing out? That would be a problem.   What I found out later is, I don`t have to push the button to release. Just put it in gear.   Setting parameters? Don`t know if it`s possible.
    • 2023 GMC 3500 HD, SLE, 6.6L Gas, 4x4, 6 Spd Options:  SLE Convenience Package; Driver Alert Package 1; Spray on Bedliner; X31 Off Road Package; TRAILERING MIRRORS, HEATED POWER -ADJUSTABLE, AUTO DIMMING, WITH TURN INDICATORS WHEELHOUSE LINERS, REAR INC. REAR AXLE - 3.73 RATIO INC. GVWR, 11,350 LBS. (5148 KG) INC. FRONT AND REAR PARK ASSIST, INC. ULTRASONIC     I have been launching my new boat and noticed some things related to the parking brake.. I usually set the parking brake (habit) when on flat ground for typical driving.    When backed down on the launch ramp to launch the boat and I place gear selector into Park, the parking brake activates automatically. My second nature is to set parking brake manually and noticed I was turing the parking brake off.  The parking brake appears to be setting itself automatically.   I looked all over my owner's manual and only found references to being on an incline and manually setting parking brake, or at times parking brake will be auto engaged, but nothing specific to my situation.    When is the parking brake automatically engaged?  Under what specific circumstances?  Can the auto set parameters be changed?     I like the auto set feature.  It would be nice if always engaged when shifted into Park and released when shifted out of Park (like my wifes 2025 RAV4).   Thanks!    
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...