Jump to content

Recommended Posts

Posted

Dealer just called, they changed the -battery cable, hopefully this will last!!!

Another week?

  • 3 weeks later...
Posted

 

 

here is the new starter pt # 12655055

 

Just a followup--mine was built in early January in Mexico and it has the new starter:

 

 

Starter.jpg

 

 

I'm guessing that means everybody with a truck built around that time or later likely has the new starter as well and should have no problems related to it. It is possible to check with it on the vehicle as you can see, but it's not all that easy. I stuck my phone in there and started taking blind pics until I grabbed the part number.

  • 1 month later...
Posted

Hi folks... this ignition problem just started for me this morning. No moisture (rain), dry conditions and sunny. Since I got my 14 Rado last February, I felt a weirdness in the ignition but couldn't figure out what it was. This morning, I got nothing on three attempts then it started as usual. I backward read the posts here (yes I'm lazy) to see if a solution has been implemented. It appears that it hasn't.

This is my third Silverado and my two previous models have been completely problem free... I feel that this 2014 model will be problematic.. not happy with all the problem issues on the Net.

  • 2 weeks later...
Posted

Anybody having issues related to the "Theft Deterrent" system causing it to not start? I have less than 1,000 miles on my new '14 Silverado dbl cab & I've had it not start at least a half dozen times now in the last week & the DIC just flashes a Theft Deterrent msg on it & the truck doesn't start. I turn the key back off, open the door & lock & unlock the doors with the power lock button on the drivers door & have had pretty good luck with it starting after that. Sometimes it stays running just fine, other times it stays running & the theft deterrent light stays on until I get to my destination & shut the truck off.

Today was the worst it's been, this far. I had it happen 4 times today, each time it failed, I was ultimately able to get it started, but had to play with it for almost 5 minutes each time to find something that got it to turn over(locking and unlocking the doors, opening the door closing the door, locking and unlocking your steering wheel, etc.)

I haven't had a chance to get it into the dealer yet. I will be scheduling an appt this week, but any insight would be greatly appreciated. Thanks.

 

 

Sent from my iPad using Tapatalk

  • 6 months later...
Posted

Purchased new 2014 Silverado, 2wd, 8 foot bed, 5.3 on 1/10/2015 with 12 miles on it. With in ten miles of use then cold morning temps placed key in ignition one click then blacked out gauges then 2nd try it started. The next day cold in morning four attempts before starting(one click black out dash) The next morning four attempts again each time one click blacked out dash! Went to dealer and it already has new starter put in because of build date. So begins checking software and resistance of battery cables! Dealer could not produce the event he had the truck for two days and is keeping it for now. I went to try it my self and it started in 10 degree temps on1/17/2015 ! Unhappy five time GM owner will keep at it and let you know.

Posted

Purchased new 2014 Silverado, 2wd, 8 foot bed, 5.3 on 1/10/2015 with 12 miles on it. With in ten miles of use then cold morning temps placed key in ignition one click then blacked out gauges then 2nd try it started. The next day cold in morning four attempts before starting(one click black out dash) The next morning four attempts again each time one click blacked out dash! Went to dealer and it already has new starter put in because of build date. So begins checking software and resistance of battery cables! Dealer could not produce the event he had the truck for two days and is keeping it for now. I went to try it my self and it started in 10 degree temps on1/17/2015 ! Unhappy five time GM owner will keep at it and let you know.

This sounds to me like a bad connection in the wiring somewhere. Not necessarily battery cables though.

Posted

New to this.

I have a 2015 gmc 3500 hd single wheel. I have 6.5 BDS lift on it with 35 inch tires. I put the lift on with 2000 km on the truck. Now I have 43000 km on it.

Iv seen some post about some 1/2 tone trucks with vibration problems

Well on my 2015 im getting vibration from 60 mph and around 75 mph. Any one Elsa having this or can help with find out what it is

It's not the tires I put the stock tires on and it's doing the same thing

 

 

Sent from my iPhone using Tapatalk

Posted

Update on Silverado long bed 2WD Starting issues, Checked battery cables per my request and Dealer reprogramed computer( Said it accepted the information )I don't know what that means cause the truck only had 12 miles on it to begin with! Was it not programed correctly at the factory?

Posted

Michael. Mitchell.1029, I have a 2014 crew cab slt with 20" wheels. I get a pronounced hum/vibration between those speeds as well. Dealer is baffled. Been fighting it since the first week over a year ago. Test drove other trucks and noise isn't in all of them. I'm thinking differential, but who knows.

  • 2 years later...
Posted (edited)

Hey wats up guys  Need help my truck is doing similar things as everybody else’s truck on this topic few days ago my truck didn't want to start no crake no nothing after a while it fired right up , than took batt to get tested it pass few day later same thing took starter off took it to get tested as well did not pass bought a starter kept the old one put new one in nothing I jumped the truck about 10 min fired up on first try took off new starter put old one back on did the same thing it fired up drove truck to autozone test battery and stater they past but truck won’t start again I sat there about ten mins messing with the batt cables hit the stater acople times move the lever from park to neutral nothing so I keep turning key over about 16 times one after another it fired up got home turn off and on about 4 times fired up so I don’t know what to do any more anyone else out there having same issues or any idea what’s going on with my 2014 Silverado 

Edited by Tbmack
  • 3 months later...
Posted

I Purchased My 2014 Silverado New, With in the first week, I experienced Electrical Dash board issues, No screen, system

resets. Messages Like open drivers window and Close, Anti theft deterrent disabled. the worst is turning the key and No starting. Dealer says they found no problems, during these visits. its been 4 years and still acts up. It seems random but sometimes goes thru what ever it fails to start. waiting then attempting to start again works but it is getting old. if I trade again it won't be for another GM vehicle. I have replaced the battery and cleaned all my connections including the grounds. it still occasionally repeats the starting issue.  I find the issue happens no mater how cold or warm it is, or dry or wet.   

Posted
2 hours ago, Larry Sucese said:

I Purchased My 2014 Silverado New, With in the first week, I experienced Electrical Dash board issues, No screen, system

resets. Messages Like open drivers window and Close, Anti theft deterrent disabled. the worst is turning the key and No starting. Dealer says they found no problems, during these visits. its been 4 years and still acts up. It seems random but sometimes goes thru what ever it fails to start. waiting then attempting to start again works but it is getting old. if I trade again it won't be for another GM vehicle. I have replaced the battery and cleaned all my connections including the grounds. it still occasionally repeats the starting issue.  I find the issue happens no mater how cold or warm it is, or dry or wet.   

Have you checked the battery cables themselves? Some were known to have bad terminations, as in the cable terminal wasn’t installed correctly or was pinching down on the cable insulation instead of the actual copper wire.  Other well known issue is the distribution block for the positive.  Do a search on here, lots of people with very similar issues had their problems resolved by replacing these.

Posted
7 hours ago, Larry Sucese said:

I Purchased My 2014 Silverado New, With in the first week, I experienced Electrical Dash board issues, No screen, system

resets. Messages Like open drivers window and Close, Anti theft deterrent disabled. the worst is turning the key and No starting. Dealer says they found no problems, during these visits. its been 4 years and still acts up. It seems random but sometimes goes thru what ever it fails to start. waiting then attempting to start again works but it is getting old. if I trade again it won't be for another GM vehicle. I have replaced the battery and cleaned all my connections including the grounds. it still occasionally repeats the starting issue.  I find the issue happens no mater how cold or warm it is, or dry or wet.   

Had the exact same issues on my truck, its been a year since it was fixed and so far no more problems. A couple of small glitches with MyLink but nothing like before. My issue ended up being the negative battery cable, the whole cable needed to be replaced, battery was replaced at the same time and the body ground was cleaned.  Don't know if you have tried replacing the entire negative cable yet, but it could be a solution to your problems. It is a bummer that you have had to deal with issues for 4 years. Best of luck!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Hello hello looking forward to expanding my knowledge of the 2026 2500 HD that I just bought.   Truck has 3500 miles on it four-wheel-drive crew cab and I’m about to put a 6 1/2 inch BDS lift on it 18 x 10 -25 offset with 37’s   Already have the wheels and tires just waiting on the lift install in about three weeks   Question what surprises am I not gonna be happy with?  I’m not new to lifted trucks so I know that acceleration towing gas mileage all that is affected..   Question is those of you that have this truck this powertrain with a 10 speed Allison and have done the mods that I’m doing,,, how bad is it? Is that Allison constantly gonna be hunting for the right gear to go into? And what about towing, acceleration, fuel consumption as mentioned?    Lastly how come I can’t find any ring pinion gear set up for these axles and when could I expect to see them?   I apologize if there’s any typos I’m doing speech to text on my iPhone.    
    • I've got a 2013 2500 6.0L Flexfuel. Drove the truck earlier today with no issues. Went to run an errand tonight and noticed key fob wouldn't work. Figured battery was dead, so replaced fob batter. Still wasn't working. Grabbed my other set of keys with the other fob and that one wasn't working either. So I manually unlock truck and insert key. Interior lights come on, dashboard lights up, turn key and truck starts. Turn truck off, like a moron, and try starting again. This time no crank, no click, no nothing. Lights still come on and dash lights up, but now I'm getting a service 4wheel drive, service tire monitor, etc. Check voltage on battery and Im showing 12.2v. Throw my battery charger on it and give it 15 mins and try starting again. But still no crank no start. Decide maybe its a bad battery, run to autozone grab a new one and put it in. Same issue. Disconnect battery and let it sit for 15 mins. Try again and still nothing. I had managed to roll the windows down earlier as its a humid night, but now I can't get them to roll up. Power locks are also not working now. Then randomly I try the key again, and it fires right up. Immediately I roll up the windows as we have nothing but rain forecast this week. I shut it back off wait 30 seconds and start up again. Worked a 2nd time. So turn it off, start putting things back together. Try one more time, and back to no crank no start. And now the car alarm starts going off. Had to disconnect battery and leave it that way for the night as I don't think my neighbors would appreciate my alarm going off again tonight. Any thoughts or help would be appreciated. 
    • No one will care for you like you care for you. Do what you can for as long as you can. IMHO of course. 
    • How about them NICKS!!! 
    • Hi there.  Long time lurker, first post.    i have read the previous posts regarding the water ingress problem with this emblem.  I bought my 1500 SLT the  summer of 2025 new and after reading the MANY problems with these emblems failing I decided to install one anyways.  As per a YouTube video, I sealed ( or tried to) this sign with silicone sealant around the outer perimeter joint and the holes that were already somewhat sealed on the rear plate of the emblem.  And installed the connector assembly using dielectric grease on the connectors. The installation looked great and worked well for about 4 months……then FAILURE.  Grrrrrr…… I live in the great white north and wash my truck weekly in an automatic car wash  to keep the salt off.  Let me tell you that removing the old, failed emblem is a whole different animal than removing the OEM individual letters without removing the grill assembly. Mainly because the illuminated logo is built differently than the original letters which  you can remove the red surface lettering with a knife or some kind of blade which gives access to the tabs which hold the logo onto the grill. So I had to essentially destroyed the old emblem to remove it. Doing so killed my chance of doing somekind of autopsy on the failed , old logo.  But there was plenty of water inside when I ripped it apart.  Prior to installing the new assembly I tried it with the old harness and it works fine.   Does anyone have any insight as to where the water is getting into this emblem? I intend to seal the new logo with slow curing epoxy this time around using a syringe.  I think this newer emblem may be an updated unit which I hope GM got the vendor to fix. It has an October 2025 date on it.    If this one  fails,  I am just going to revert back to the non-illuminated letters….AFTER PULLING THE GRILL.    Any thoughts on sealing with epoxy would be appreciated. Thx!   Doug  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...