Jump to content

Low voltage issue

lance9386

By lance9386
in Troubleshooting & Recalls

 Share

Recommended Posts

lance9386 Enthusiast

lance9386

Posted
Posted

Why is voltage dipping well below 14 when the truck is running?? It's intermittent, it will go back up to normal at times..

fondupot Senior Enthusiast

fondupot

Posted
Posted (edited)

RTFM. If the needle is within the hash marks to either side of 14 volts. Its fine.

 

Straight from my owners manual:

 

"When the engine is running, this gauge shows the condition of the charging system. The gauge can transition from a higher to lower or a lower to higher reading. This is normal. If the vehicle is operating outside the normal operating range, the charging system light comes on."

Edited by fondupot
  • Like 1
MNDaveC Enthusiast

MNDaveC

Posted
Posted

I'd certainly be keeping a close eye on things if it starts fluctuating if there were no obvious electrical drains. Belt slipping? Low RPM?

MikeNH Senior Enthusiast

MikeNH

Posted
Posted

This is normal. Look through the forum or read the manual.

 

Someone posts this question like once a week. ;)

  • Like 1
lance9386 Enthusiast

lance9386

Posted
  • Author
Posted

Thanks guys. I did RTFM... but.. I have never seen a vehicle unable to maintain 14.4V while running unless there was a huge draw on the electrical system. I find that at idle is mostly when this happens. At night with the headlights on it stays right above 14, where it should be. I just think that is very strange, but apparently it is by design.

fondupot Senior Enthusiast

fondupot

Posted
Posted

Thanks guys. I did RTFM... but.. I have never seen a vehicle unable to maintain 14.4V while running unless there was a huge draw on the electrical system. I find that at idle is mostly when this happens. At night with the headlights on it stays right above 14, where it should be. I just think that is very strange, but apparently it is by design.

 

Its a design element that comes from the fuel efficient alternators on these trucks. When the battery is within an acceptable range, the alternator is not engaged, this is less draw on the motor which saves fuel.

  • Like 3
lance9386 Enthusiast

lance9386

Posted
  • Author
Posted

 

Its a design element that comes from the fuel efficient alternators on these trucks. When the battery is within an acceptable range, the alternator is not engaged, this is less draw on the motor which saves fuel.

Thanks for the explanation! That is good to know.

MMC Enthusiast

MMC

Posted
Posted

Saves fuel and extends battery life, GM's been doing this for years.

  • 10 months later...
Silver ice 6.2 Senior Enthusiast

Silver ice 6.2

Posted
Posted (edited)

I haven't seen a pic.. and thought I would post.. here you go when I first noticed i said oh wow that's nice..lmao bit looked online and seen that it's normal. And yes that was my reaction at first

post-145646-0-28256900-1436131420_thumb.jpg

post-145646-0-28256900-1436131420_thumb.jpg

post-145646-0-28256900-1436131420_thumb.jpg

post-145646-0-28256900-1436131420_thumb.jpg

Edited by Silver ice 6.2
  • Like 1
20L8TSierra24 Senior Enthusiast

20L8TSierra24

Posted
Posted

I was just thinking about this because my truck is barely starting at times. My needle looks like above and I load checked the battery and it came back good.

  • 9 months later...
thejimmian Enthusiast

thejimmian

Posted
Posted

does anyone with cooled seats notice a drop in seat fan speed when the voltage goes below 14v o nthe dash? I have recently noticed that when the truck turns the alternator off to save gas i basically loose the highest cooling level (fan speed is the same on level 2 and level 3). pretty annoying. i think it is the same story with the AC blower fan as well.

KLRV6 Enthusiast

KLRV6

Posted
Posted

 

Its a design element that comes from the fuel efficient alternators on these trucks. When the battery is within an acceptable range, the alternator is not engaged, this is less draw on the motor which saves fuel.

And the battery will last longer by not forcing higher voltage on it when not needed. I was worried when I noticed it the first time.

  • Like 1
  • 2 years later...
Kevin Gorczyca New Member

Kevin Gorczyca

Posted
Posted (edited)

Here is my 2017 Denali with the 6.2L and 35,000 miles. Notice my two pictures have different miles on the trip meter. I was driving around for 4 hours yesterday morning and it stayed this low the whole time. This line represents around 12 v. You mean to tell me that this thing was in fuel saver mode charging at 12v for half a day? I’m having tons of electric problems on my truck and the dealer is using this as an excuse to not find the real problem. I’m also having transmission shuddering and slipping trouble, severe detonating on 93 octane (only when it’s cold and dry out), and front parking sensors and crash avoidance sensors throwing codes. Had front power seat and rear wiper not work intermittently too. Dealer is just making excuses but I think in my case this is NOT operating as designed. Can anyone elaborate on this?

F433DB0B-83C9-4CE8-9457-A5D74A616943.jpeg

4793C5DA-EA7F-4EE6-85C5-1F29BA5E396D.jpeg

Edited by Kevin Gorczyca
Added engine size and mileage
  • 1 year later...
Nasir222 Enthusiast

Nasir222

Posted
Posted

I have 2017 Silverado LTZ Crew Cab and it stays low in the daytime and jumps to normal range at night and I have a decent audio system upgrade and never had problems before... or noticed it. I noticed that when I push the audio in the daytime I have a clipping monitor that shuts the amp down when it hits clipping that only has happened when it gets close to the left side mark of the 14v. Weird because I would have never known if I didn't have the clipping monitor on my amp 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Coastie05
      It's Been a Long Time...

      By Coastie05 · Posted

      Welcome back!
    • davester
      New to Me 2010 SLE (Quirks, Issues)

      By davester · Posted

      not all plugs will be used.  gm uses more generic harnesses that support most/all options, and if your truck doesn't have a specfiic option, the plug won't be used (commonly will have a dummy insert in the plug , or it'll be taped up, but some may just be left as is).  But it's sldo possible some p.o. has installed the wrong/cheaper parts that aren't correct for your vehicle...
    • fm2176
      New to Me 2010 SLE (Quirks, Issues)

      By fm2176 · Posted

      First off, I'm not trying to just get easy advice/fixes for the issues I've noticed so far.  I'll be combing through the site via searches and such, and if past experiences are any indication, should find what I need.  For the sake of conversation, though, I figured I'd post the handful of things I've noticed in the 12 hours since buying my 2010 SLE CCSB.     Indicator lights: Airbag and TPMS.  The tire pressures aren't reading for any of the wheels, so I'm pretty certain the sensors were either removed, are damaged, or are otherwise inoperable.  I used to mount and balance tires 25 years ago but am pretty much ignorant when it comes to TPMS.  My 2006 didn't have the sensors and this might be the fourth vehicle I've owned that does.     Radio: Rear speakers aren't working.  I removed the driver's side rear door panel and checked the speaker and wiring.  I also removed the sill and b-pillar covers to check the wiring.  A few minutes of Google Fu showed that this is potentially a head unit issue.    Switches: Power mirrors don't turn left/right.  I ordered replacement driver's door switches that should arrive tomorrow.  The windows and locks work but it was only about $20 for all of them.  The driver's side rear window switch lets the window down but won't put it back up.  I think the passenger rear doesn't work at all.  In the coming days/weeks, I'll break out my multimeter to check all of that.   Unknown wiring harness: There's a box attached to the front driver's side of the engine compartment, right where the second battery shelf is located.  There are three plugs, one of which looks like it fits a standard headlight-style bulb (9007 or similar).  It doesn't look like it's plugged into anything.  I'll do some digging and if I don't see anything elsewhere on the site, post some pictures here.   Unknown plugs on brake booster: There are at least two female plugs on the brake booster that aren't being used.  I think it might be a replacement/aftermarket, so maybe those are used for a different application, as there don't seem to be any unplugged harnesses and no indicator lights are on.   Little squeaks when turning: Sounds almost like a bushing around the bed of the truck.  I'll have to pay close attention as I get more familiar with the truck.   Clunk on acceleration: possibly the infamous drivetrain clunk.  My 2006 had it and I'm just not familiar enough with this truck yet to fully grasp what it is.   Anyway, my apologies for the vague and all over the place post.  This truck is new to me, and it's been four years since I drove my 2006.  With 200k miles, I know I'll need to learn this truck quickly to avoid having any major issues, despite being confident it's got much more life to it.  My 2006 had nearly 320k on it when I parked it (nearly 300k of which I put on the truck), and it was still drivable then, though I suspected the head gasket might have blown.  I'd hoped to have that truck back by now, but it's gone forever, as I detailed in my reintroduction thread.  
    • lowrider
      Range RA007 DFM Module

      By lowrider · Posted

      I always drive in Sport mode. With more driving, I am finding the initial response when accelerating is much quicker now🖕 Lou
    • Tyler Gibbs
      2022 2500HD with a new RSI SmartCap

      By Tyler Gibbs · Posted

      Is it an optical illusion in the pic or is the truck really squatting that much horribly?

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...