Jump to content

Recommended Posts

Posted

I have noticed I have a clunk noise coming from somewhere. Im thinking its coming from up front but not sure. Sounds like a suspension driveline or steering issue. Notice it alot while turning on uneven ground or when I swerve back and forth somewhat harsh on the road. Im taking it to the dealer this afternoon, just thought I might see if anyone else experienced this and has an idea. Truck does have a 2" level.

Posted

I have a 2" level and had the same clunk as you. Mine was caused by a bad upper ball joint, replaced both upper control arms loaded with ball joints from Moog for $160. Truck only had 44k with the level kit on it, 54k total

  • Like 1
Posted

I got 18,000 now. So leveling kits been on for about 15,000 miles now. What uca did you go with.

Posted

A friend of mine had this issue on his non-lifted truck and it turned out to be bad shocks in the front. Now he has a 2" level in the front and a 1.5" lift in the back with bigger tires and the noise has returned. He's not sure if everything needs to be re-torqued after the level/lift or if the replacement Ranchos went bad again. I've also heard of this noise happening with a loose tie rod. Bottom line is it could a few different things that you need to look into.

Posted

Doesn't seem to do it when going straight so much, even when hitting bumps or going over train tracks.

Posted

Doesn't seem to do it when going straight so much, even when hitting bumps or going over train tracks.

 

My friend said he heard it during sharp turns, especially when entering and exiting parking lots where there's the concrete apron and slight dip to drive over. It turned out to be bad shocks.

Posted

That's mainly when I hear it aswell as when swerving back and forth just to figure where it's coming from

Posted

I had the same issue on my 2014 with a RC 2.5" Leveling lift kit. Thought is was the ball joints but ended up being a bad bearing in the steering column. Dealership said this has been an issue in many trucks.

Posted

Couldnt come up with anything. They retourqed the the rear springs. They also said to spray them with lubricant. Said they can try "chassis ears" to see where it's coming from.

  • 2 months later...
Posted (edited)

Did you ever figure this out?

 

Mine makes a pop sound when turning sharp in parking lots. Today when I was rotating tires, I did the checks you do when you have it lifter, Push/Pull on the top and bottom of the wheel. Push/Pull on the left and right side of the tire. I found some movement when working the top and bottom of the wheel. So I think I am looking at ball joints, either upper or lower. I will look closer when my son comes over for Thanksgiving this week.

Edited by Eddie 70
Posted

This may not be the same issue y'all are having, but it's worth a shot. I had a popping noise from the front end..at full turn. It was caused by the sway bar bushings. They had dirt and debri in them. Simply cleaned them and the pop was gone. I also had a clunk coming from the rear. I was expecting the worse, but it turned out to be the leaf springs making noise only when turning. Spring clamps will fix that issue, but I decided to go with the bicycle tube idea..someone mentioned on this form. These are two easy/cheap solutions for annoying noises. I hope this helps.

  • 3 months later...
Posted

I had the same issue on my 2014 with a RC 2.5" Leveling lift kit. Thought is was the ball joints but ended up being a bad bearing in the steering column. Dealership said this has been an issue in many trucks.

What was your issue on why they had the bearing in the column replaced? I am having a issue and the dealership can't find it. It has a pop/feel when turning from one street 90 degrees to the next. But it is intermittent! Any help would be appreciated.

Posted

I had a upper a arm loose at the frame. Made a popping noise. Tightening it up fixed mine.

  • Like 1
Posted

I had a upper a arm loose at the frame. Made a popping noise. Tightening it up fixed mine.

 

Turns out mine was the same thing. I was amazed at finding this. Problem for me was I didn't find until I had new upper control arms at the house and had painted them. On top of that I didn't get around to swapping them until a month or so later. I should be okay for a while now though.

Posted

My 2014 spent weeks at the dealership over three different times and they could not ever figure it out. Every time I pulled out of the dealership parking lot my front end would pop, I was so annoyed and pissed about the entire situation. This was the first half ton I ever owned and I hated it!!! I finally got the front end fixed by buying a new 2016 2500HD, I will never try a half ton again/

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Based on what I can tell, yes.   As for updating it, its a mixed bag.  Updates do fix a lot of issues, but occasionally can create some oddities.  They do more good than harm though overall.     Here's what the most current one does and a  V171 Improvements Important: Improvements will vary by model, build configuration, system, and sales region. Not all vehicles have all features. OnStar and Wi-Fi may not work after remote start CarPlay may not automatically reconnect Part of the Driver Attention messaging screen may be in English even though the language is set to something else XM may not work After a dead 12V the radio may set to Arabic at each startup Bluetooth contacts might not be able to sync with the vehicle During an OTA the 12V battery may drain Customer might see a screen telling them to return to the dealer After changing the Wi-Fi SSID or password a device may not disconnect If a device is connected on the 2.4Ghz band, nothing will connect to the 5Ghz one, which could show as slow Wi-Fi speeds Customers might have noticed Wi-Fi dropping in certain areas and reconnecting later Customer might see the top of the screen blinking during Android Auto Android Auto may not connect CarPlay audio might momentarily cut out The "Add Phone" button may be grayed out The radio may not start up   V167 Most Notable Improvements:   Outside Air Temperature is incorrect. -You may see a popup message for Engine Shift. (Corvette Only) After changing the exhaust sound they get a popup that "mode change not applied", even though it was. -When changing volume, the volume bar is for Traffic instead of Audio. -(Corvette Only) Improvements to the placement of buttons and text. -If the customer receives the message "Apple CarPlay Could not connect", the cursor might move in the opposite direction than expected when using the control knob. -Android Auto automatically starts playing their music, even though they have turned that off in settings. -Intermittently they have a red OnStar LED with no OnStar function and/or no audio. -The minimum length of the Wi-Fi password was increased to 12 characters. -The popup message "Driver Attention Check, check your mirrors or Super Cruise will shut down" may not have come up on the display when it should have. -Startup animation added for 20th anniversary of the V-Series on Cadillacs. -The Navigation app received location improvements when going under long underpasses. -In the Navigation app there are filters for charging points that the vehicle cannot use.   V164 Most Notable Improvements Most notable improvements contained in this release may include: Apps Intermittently, an “SD Card Removed” message will pop up in the Navigation app. While in the audio app, the radio may stop working. Trailer Tire Pressure sensors may not be learned in the Trailer app. Not being able to return to the home screen while in the Camera app. After an ignition cycle, the radio might go to a black screen or stop working if using Sirius XM. Spotify icon truncated on Audio app.   SXM When changing power modes with the ignition switch, the HVAC pop up might appear. During startup, the radio will show the brand splash screen then go blank. Receiving a confirmation pop-up when changing drive modes. A “Return to Dealer” message may appear on the radio screen. SuperCruise setting toggle may not work. System After an ignition cycle, the radio might go black or stop working if using Sirius XM (SXM). Settings When performing a factory reset, the radio may stop working. After performing a factory reset, the radio may stop working when trying to switch users. When trying to go into the Language section quickly after startup, the radio may stop working. Projection Wireless CarPlay cannot be connected after unpairing another wireless Android Auto device. When the Android Auto screen comes up to connect wirelessly, the screen may freeze if the Cancel button is pressed. Removed the Apple CarPlay Cannot Connect screen when a device fails to pair during the autoconnect process. CarPlay information may not show up in the audio app. Near Field Communications (NFC) chime may be heard when NFC does not work. The Cannot Connect screen does not pop up after the first connection on wireless CarPlay fails. Apple CarPlay is now functional in Guam. Over the Air (OTA) When a software update is cancelled, the downloading logo may still be displayed. Energy When using the Energy app, the radio may stop working. When plugging in the vehicle, the display might show “Now” instead of “Charging Upon Plug In.” Instrument Cluster Voice recognition can be started while on an OnStar or phone call. When downloading contacts, there is a progress bar and circles on the Recents page of the cluster. The temperature on the cluster and the display may be different. After receiving and ending a call on the secondary paired phone, the cluster may get stuck on the phone menu. Bluetooth Intermittent Bluetooth connection loss.
    • Looking for help troubleshooting a metallic like front end rattle. Figured I’d see if anyone had thoughts before I schedule an appointment with the dealer.   The rattle is fairly loud and occurs primarily when the front driver side wheel hits a bump, even fairly minor road seams. Sometimes does it when the passenger hits a bump but I don’t believe when the rear hits. Rattle still occurs when foot is pressing brake peddle so I think that rules out the caliper rattle I’ve read about. I’ve also checked the running boards and they are tight.   Most noticeable at slow speeds.    Any insight is appreciated. 
    • We try to make cruise the coast. It’s where our favorite casino is. I only want to spectate. Never took a car. Always had one to take. I belonged to a club once. Even when I used to drag raced. It was during test and tune. Probably because I’m not a night owl, party person. 
    • We had a pretty big cars and coffee in Indy this past weekend.  Pretty much anything and everything was there.  
    • Good looking Olds, and TRX!   I haven't been into car shows either. I'm probably not a convert but I did push myself this year to attend a few select events to challenge some assumptions and try to experience car-based social clubs in a different way. I joined up with the local Hagerty group for some cars/coffee events, group drives. A month ago I showed my '94 Camaro I rescued last fall at Radwood. Had a good time, but, there was some sitting around with the car and that's the part of shows I don't enjoy as much. I prefer to be a spectator, walk the show, grab a burger, go home.   Radwood was the only era-limited event, but where it had strict model year limitations, it made it up in variety. Having Jason Camissa there was also a hoot.   Where I see old 50's car shows, doo-wop and winga dinga music stuff fading out, same with "only" vintage muscle clubs, it seems to be the activity-based clubs/events which are gaining strong popularity. Places where all cars and interests come together.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...