Jump to content

Power window problems

Joemaggs
 Share

Recommended Posts

Joemaggs New Member

Joemaggs

Posted
Posted

I have a 2014 Chevy Silverado. My driver side window works fine. My passenger side window only works for the passenger side switch. My rear windows do not work at all. I replaced the switch and have the same problem. Any ideas I’m at a loss?

Ravenkeeper Senior Enthusiast

Ravenkeeper

Posted
Posted
2 hours ago, Joemaggs said:

I have a 2014 Chevy Silverado. My driver side window works fine. My passenger side window only works for the passenger side switch. My rear windows do not work at all. I replaced the switch and have the same problem. Any ideas I’m at a loss?

Double check the "Child Safety Switch" for the windows to make sure that it's not set.

 

Check fuses, and ohm wires from switches to window motor. 

 

 

durandetto Enthusiast

durandetto

Posted
Posted

Check the wires in the door jamb for breaks. Try grabbing the rubber boots and moving it around while operating the switches to see if they start working.

 

 

1. Test the driver's window switch power and ground feeds. 

 

2. Check for wire breaks in the door jamb boot. 

 

3. If there is low/no voltage on the Yellow wire in terminal 43 at the switch, cut the Yellow wire in terminal 22 in the X2 connector at the Body Control Module (BCM). 

 

4. Confirm there are 12 volts on the Yellow wire on the BCM side of the cut. 

 

5. If there are 12 volts, check for an open in the Yellow wire between the BCM and the driver power window switch.

 

Sent from my SM-G988U using Tapatalk

 

 

 

 

  • Like 1
durandetto Enthusiast

durandetto

Posted
Posted

You're welcome. I see that all the time at work. Probably best to add enough wire so your splices aren't in the bend.

Sent from my SM-G988U using Tapatalk

  • Like 1
  • 2 years later...
LARRY GOLLBACH New Member

LARRY GOLLBACH

Posted
Posted

Thanks for posting this topic. I had the exact same symptoms. I thought it was the switch also. Them I found this site. Found the same broken wires in the door jam harness.  Very helpful.  Thank you very much.

  • Like 1
  • 7 months later...
GOMD Enthusiast

GOMD

Posted
Posted

I have the same symptoms, but my wire harness looks good, except the thick black wire is cut and exposed some. Ordering a new harness now, hoping to have positive results.

 

Tyler Gibbs Enthusiast

Tyler Gibbs

Posted
Posted
On 3/11/2020 at 7:30 PM, durandetto said:

Check the wires in the door jamb for breaks. Try grabbing the rubber boots and moving it around while operating the switches to see if they start working.

 

 

1. Test the driver's window switch power and ground feeds. 

 

2. Check for wire breaks in the door jamb boot. 

 

 

 

 

 

 

Yup, this.

Tyler Gibbs Enthusiast

Tyler Gibbs

Posted
Posted
On 3/14/2020 at 8:46 AM, NE18 said:

Is this a common problem on the K2’s?

I know this post is from 2020 but when my 2018 was in the shop in July for this, the GM dealer said it was becoming more increasingly common.  As well as the hood sensor/switch failing.

GOMD Enthusiast

GOMD

Posted
Posted

So it ends up that while I found a slice in the black ground wire in the main door harness, I actually only needed to replace fuse #8 in the drivers side fuse panel to get everything working again. Thanks.

  • 1 year later...
Derek D New Member

Derek D

Posted
Posted (edited)

I have a 2018 Silverado. The passenger window will not roll down from the passenger door switch or the drivers door switch. All of the other windows work from their respective switch and the drivers panel. I replaced the switch and the window motor assembly (both OEM) but the problem remains. Additionally, the door ajar light is on continuously. I checked the fuses and the wiring and I can’t find any issues. Any advice? 

Edited by Derek D
Adding info
MikeBMW Senior Enthusiast

MikeBMW

Posted
Posted

Have you run a scan with a scan tool?
Also, have you checked all grounds (yeah, I know, always the easy answer without solving the problem)
Still, a scan would probably find the fault, might be a legacy code that needs a reset.

  • Like 1
  • 3 months later...
Mdp243 New Member

Mdp243

Posted
Posted

 I have a early model 2014 Chevy Silverado and the drivers side windows have stopped working as well as the stereo stays on after the vehicle is shut off (opening door does not cancel the radio) I have replaced the window switch, door wiring harness, and the latch on the drivers door. I have also checked all fuses and they are good any ideas where to look next.

  • 5 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Black02Silverado
      Post your UOA, (used oil analysis) here

      By Black02Silverado · Posted

      Here's the second UOA on my 22 Wrangler with the Ecodiesel. This has 5k miles on AMSOIL Signature Series DEO 5w-40. The first one was dealer installed oil, no clue what it was, the second is what AMSOIL recommended, European FS 5w-40, Most of the Ecodiesel world is showing great results using the European MS 5w-40, I figured I would see how the DEO works. This is using an Ecoguard oil filter. It's my understanding this engine likes to shed aluminum.  We will see. So far I don't think this is too bad.    
    • revmanii
      Disable DRL's

      By revmanii · Posted

      I'm surprised nobody seems to offer a solution like the start/stop device I put in my new truck. Remembers my setting when shutdown. And while it still starts up in start/stop, it stores/evaluates what mode it was in when shut down and will change it whithin a second or 2 of startup. It'd be nice to have something like that for the DRLs.
    • btm
      Sunroof Drain Hole Entry & Exit Location (w/ Pictures)

      By btm · Posted

      2015 Sierra 1500 here. Leaks from the sunroof to front driver side and soaks carpet. How do I fix this? Thanks!
    • Atlas
      Wow I'm in a pickle. (Broke down truck) and a story.

      By Atlas · Posted

      I will be doing that for sure, but I need to solve who has/ where I can find a bidirectional scan tool that will support OBD 1.5. I'm kicking myself because I ebay'ed a Snap On MT2500 that I didn't think I'd ever need anymore. D'oh!! I'd rather not buy another, so I'll contact a few local shops to see if they have one and how much they'd want to do the procedure. I'd rather have the ability to do it myself... I wish there was a modern tool that could do it all, but I'd have no idea what to buy.   The theory with the pulled timing is that it mimics a rich condition. The delayed spark causes incomplete burn and the O2 sensor picks up low oxygen levels. That's interpreted as a rich condition so the PCM pulls fuel and that shows up in the deeply negative fuel trims.
    • Chuck FB
      Joke Thread

      By Chuck FB · Posted

      An ultra wealthy man had the most beautiful daughter. But, there was a problem. Everything she touched would melt in her hands. No matter what, Metal, Wood, Stone. Anything she touched would melt. She could not feed herself. Because of this, men were afraid of her. Nobody would dare marry her. Her father was despaired. What could he do to help his daughter? He consulted doctors, scientists and anybody who could solve this problem. Finally one of them said, "If your daughter touches one thing that does not melt in her hands, she will be cured." He was overjoyed and came up with a plan. The next day, he held a competition. Any man who could bring his daughter an object that would not melt in her hands would be given billions of dollars to marry her. Three extremely intelligent and handsome young men took up the challenge. The first brought a very heavy steel rod, But alas, when the she touched it, it completely melted in a matter of seconds. He sadly went away. The second brought a beautiful diamond, knowing diamonds were one of the hardest substance in the world and would not melt. But alas, once she held it in her hand, it melted. He too was sent away disappointed. So now, there was one left He was very nervous & sweating. He approached the daughter & said, “put your hand in my pants pocket and feel what is in there." She did exactly what he asked. She felt something very hard. She held it in her hand, squeezing it as hard as she could. It did not melt & remained extremely hard. Her father was overjoyed. Everybody was overjoyed. She was finally cured. Nothing never, ever melted in her hand again. They married and they both lived happily ever after, raising a wonderful family. Question: What was in the the groom’s pants pocket??? Answer below ↓ M&Ms of course! They melt in your mouth, not in your hand. What on earth were you thinking?

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...