Jump to content

Recommended Posts

Posted

How's it going , new to forum and hoping someone could shed some light. I have a 2019 silverado custom 5.3 w/ 6 speed trans with about 37k. A month ago  the truck threw error p0741, it  would Rev high and not want to shift so dealer replaced tcm and new fluid.  A few weeks past and code comes back with trans temp running around 215* when it did so dealer replaced torque converter  and said it was good to go. I took for a extended  drive of so.e city and a Lil hwy for around d 1hr and Temps climbed to 225*.  Is 225* high? Doesn't seem normal and dealer is saying they. Ant find anything wrong 

20210429_195723.heic

Posted

How's it going , new to forum and hoping someone could shed some light. I have a 2019 silverado custom 5.3 w/ 6 speed trans with about 37k. A month ago  the truck threw error p0741, it  would Rev high and not want to shift so dealer replaced tcm and new fluid.  A few weeks past and code comes back with trans temp running around 215* when it did so dealer replaced torque converter  and said it was good to go. I took for a extended  drive of so.e city and a Lil hwy for around d 1hr and Temps climbed to 225*.  Is 225* high? Doesn't seem normal and dealer is saying they. Ant find anything wrong 

Posted

That is high for standard driving. Without load just driving around they are usually around 180-195 and it's pretty typical to see 210-225 while towing.

Posted (edited)

Temp probably  would have kept climbing   But I pulled over to cool it down Dealership is telling me nothing wrong with my truck

Edited by Thatguy233
Posted

Mine use to do that then I bypassed the thermostat and BINGO. Runs 160 F on 95 F days. (Not towing). 

Posted
2 hours ago, Thatguy233 said:

How's it going , new to forum and hoping someone could shed some light. I have a 2019 silverado custom 5.3 w/ 6 speed trans with about 37k. A month ago  the truck threw error p0741, it  would Rev high and not want to shift so dealer replaced tcm and new fluid.  A few weeks past and code comes back with trans temp running around 215* when it did so dealer replaced torque converter  and said it was good to go. I took for a extended  drive of so.e city and a Lil hwy for around d 1hr and Temps climbed to 225*.  Is 225* high? Doesn't seem normal and dealer is saying they. Ant find anything wrong 

How much powertrain warranty left? Do you have a backup ride to get to work?

 

Drive it till it dies (transmission) or go get a second opinion from a better dealership who values your business.

 

Sometimes they will balk at inheriting someone else's crappy work/attitude, but some will. 

Posted
9 hours ago, Grumpy Bear said:

Mine use to do that then I bypassed the thermostat and BINGO. Runs 160 F on 95 F days. (Not towing). 

Hi Grumpy Bear, I have been following you posts about the thermostat delete.  Tried to find the exact posts again, but could not by managed to find the thread.  I have a 2019 GMC with the 8L90 box. 30000km on the clock so far and no issues.  Wanting to keep the truck for as long as possible, I have been following threads about the problems experienced with this transmission.  I came across your threads on the thermostat delete and have been going through them with interest.  Having originally come from  Africa where keeping transmissions cool whilst working them hard was a top priority.  I found it interesting that GM put a thermostat in the cooler lines.  It just so happened that yesterday I had to take a trip to the nearest town, 250km away so I thought I would watch the transmission fluid temp in line with what I had read in your posts.  The ambient temp was 35F.  Transmission was 64F when I took the truck out the garage.  I had driven for 2 hours and covered 190km before the transmission temp reached 169F.  It stayed there for the remainder of the trip.  The trip on the way back was pretty much the same with the ambient temp having gone up marginally to 40F.  Transmission temp remained the same.  In this case, the thermostat would not have even opened?  I was surprise that it did not build more heat, and was even more surprised, as you have said previously how long it takes to get to running temperature.

 

With thermostat removed I can see how it would warm up more quickly pulling heat from the radiator as you mentioned.  Under the conditions above, what do you recon the truck would run at with the thermostat removed?

 

Something else that I have been doing some research on is the proactive upgrading of the oil from the current Dexron HP to the improved Mobil 1LV ATF HP now rather than the planned 70000km based on the problems experienced with these boxes.  Speaking to GM they are sort of downplaying it.  Have you any thoughts or experience with transmission oils and any thought on additives like Lubeguard that are meant to improve oil and transmission performance? 

 

Although I still have three years left on the drivetrain warranty, I do not want to allow a problem to start now, that I will have to live for for the life of the truck.  Similar to your outlook on longevity of the vehicle and doing that's right now to ensure this.

 

Any insight greatly appreciated 

Posted

Thanks for input,   Yeah I'm thinking when that torque converter was going out it also started doing damage to the tranny.   I got about 23000 miles left on the warranty

Posted
20 minutes ago, Thatguy233 said:

Thanks for input,   Yeah I'm thinking when that torque converter was going out it also started doing damage to the tranny.   I got about 23000 miles left on the warranty

Take it to another dealership while it is still covered by GM.

Posted
59 minutes ago, Thatguy233 said:

Thanks for input,   Yeah I'm thinking when that torque converter was going out it also started doing damage to the tranny.   I got about 23000 miles left on the warranty

As stated above, I would take it to another dealer. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • The guy that owns K&P filters last I checked in with him has over 300,000 miles on his Dodge base Hemi using his own 35 micron absolute stainless mesh filter from its first oil change.    The GM study I've posted a dozen times shows the relationship in engine life based in multiples of base units, not miles or years. That is the base unit is the number of miles the motor ran using the reference filter efficiency.    The above two paragraphs dismantle anecdotal arguments IF one changes oil often enough to prevent particle formation and the motor is in otherwise good shape. That is not full of silica (no air filter) or suffering a metallurgical issue that is not part of the lubrication discussion. Poor heat treat in example.   Data from UOA's I've reviewed from more than a few engines can show remarkably broad variations in oil cleanliness using the exact same filter over the course of an engines life.     Lastly there is the common sense of it. Wear debris WILL circulate the engine BEFORE it ever sees a filter in route to that filter and WILL harm the pump which NEVER sees filtered oil.    Alpha question then becomes, given the facts, how long do you believe is a reasonable service life from a vehicle you are certain you will not pass down? That is the junk yard will be it's resting place when you're done with it? (the moral issue most don't care about).    Omega question is then how diligent are you prepared to be in general mechanical, air & oil maintenance? Preventing particulates and keeping them sufficiently dilute; preventing the precursors from generation, amalgamation and precipitation.    If I get a good look at the engine bay of a vehicle I have a fair idea of the owners commitment to the inside of the power train. That 30 micron WIX is still more efficient than a sieve.                 
    • It also depends on what criteria someone is using for “best” when talking filters.  Are we going off best efficiency?   Best quality/QC?  Etc. because the two may not mutually exclusive.  
    • They’re not the same wiz as 10-15 years ago.  QC has fallen pretty hard.  The XP line was never good though in the first place.    https://bobistheoilguy.com/forums/threads/wix-filter-rusted-through.386492/post-6991372   https://bobistheoilguy.com/forums/threads/i-ve-used-my-last-wix-filter.27299/   https://bobistheoilguy.com/forums/threads/looking-for-a-better-replacement-for-wix-51258.403977/   https://bobistheoilguy.com/forums/threads/convince-me-in-using-the-purolator-boss.401537/post-7420147   the forums are littered with posts and examples of not great wix filters the last couple years 
    • *Your      
    • I'd guess that it's because they are Mann-Hummel filters since about 2016, they own Wix and are mostly all made in China now. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...