Jump to content

Recommended Posts

Posted

I’m looking for guidance on whether I can tow a 5800 lb travel trailer with my 2021 Sierra Elevation 1500 diesel, 3.24 Axle ratio. It’s difficult to obtain a clear answer on this anywhere. Thanks you in advance for sharing your experience.

Posted

Probably 6800 lbs for trailer and 1400 payload . In lookIng at the link attached, I don’t think I have the maximum trailer package so I’m wondering if the same towing capacity of 9200 lbs is advisable. I have the tow mode , intergrated brakes and rear camera view . I don’t know I have the right axle ratio , heavier shocks and extra cooler that comes with the max trailer option which wasn’t available .

Posted
2 hours ago, NeilAlberta said:

I’m looking for guidance on whether I can tow a 5800 lb travel trailer with my 2021 Sierra Elevation 1500 diesel, 3.24 Axle ratio. It’s difficult to obtain a clear answer on this anywhere. Thanks you in advance for sharing your experience.

 

 

All the information you need is directly in your driver's door jamb.  GM put these really neat and detailed towing information labels right on every truck produced.  

  • Like 1
  • Thanks 1
Posted
16 minutes ago, NeilAlberta said:

Probably 6800 lbs for trailer and 1400 payload . In lookIng at the link attached, I don’t think I have the maximum trailer package so I’m wondering if the same towing capacity of 9200 lbs is advisable. I have the tow mode , intergrated brakes and rear camera view . I don’t know I have the right axle ratio , heavier shocks and extra cooler that comes with the max trailer option which wasn’t available .

 

 

Max trailer just came out on the diesel for 2022.5 trucks.  2020-2022 don't have max trailer on the diesel.  

Posted

The sticker GM started putting on the T1's make things so much easier. I noticed Ford and Ram are doing something similar but again the sticker on the door , cant be any easier.  

Posted
3 hours ago, NeilAlberta said:

Probably 6800 lbs for trailer and 1400 payload . In lookIng at the link attached, I don’t think I have the maximum trailer package so I’m wondering if the same towing capacity of 9200 lbs is advisable. I have the tow mode , intergrated brakes and rear camera view . I don’t know I have the right axle ratio , heavier shocks and extra cooler that comes with the max trailer option which wasn’t available .

Post up a picture of the trailer label on the door post of the truck and you'll get interpretation help.

 

For comparision, mine is a denali 4wd with 6.5ft box and the 3.0L diesel. 

It will weigh different than your elevation diesel, so the payload and curb weight will be different.

 

It is 7200 gvwr, 5834 curb weight and 1366 payload.

(yes, gvwr - curb weight = payload)

 

It's conventional trailer weight rating (TWR) is 8800 lbs.

 

2wd/4wd, double/crew and short/standard box will change how much the elevation diesel is rated to tow.

 

All 2021 LM2 elevations have 3.32 axle ratio.

 

Posted

Thanks. I think I figured out how to interpret all the numbers now in the door label. I’ll post it tomorrow when I get it back from the shop. Thanks for your help👍

Posted

My guess is your truck has a max combined rating of 15,000lbs (truck and trailer)

 

When you look at your sticker it will probably say max trailer weight is around 9,200-9,500lbs but keep in mind that is if your truck is empty.

 

So if you subtract the 7,000lbs your truck weighs fully loaded you have 8,000lbs left for your trailer. Of course that would be “maxed out”. Most people advise against that. Some people will also tell you they are conservative with the numbers so you are fine. Depends on how comfortable you feel with it. 
 
If your trailer is 6,800lbs fully loaded and you fully loaded your truck then you would be at 13,800 pounds. That would be around 90% of the combined weight rating. So you would be under but not by much. Had a 5.3 Trail Boss and towed a 4500 pound dry weight trailer. Was probably between 12,000-13,000 when we towed. Never had any issues. 
 

Posted

The payload rating will be more of the concern with a travel trailer as they tend to lean closer to 15% tongue weight rather than the usual 10%. We tow a smaller 4000 lbs. GVWR camper and with the weight of propane, the power tongue jack, the deep cycle battery, and our hitching equipment on the front of the trailer, our tongue weight is right around 600 lbs.

 

If your trailer loaded is around 6800 lbs., that means you could potentially have up to 1020 lbs. of tongue weight, meaning you would be left with 380 lbs. of payload in the truck for passengers and cargo, if you have 1400 lbs. of payload. If your trailer has a more conservative 12% tongue weight, though (as an example), you would be at 816 lbs. of tongue weight and you get back almost 200 lbs. of payload in the truck.

 

If possible, I would hitch it up loaded and go to a weigh station to see what your axle weights are. That could also influence how you adjust your weight distribution hitch and where you place cargo both in the truck and trailer. If you usually travel with water on board, don't forget to fill that up, too, as water is 8 lbs. per gallon and adds up quick.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Hello All!   My 2019 Colorado 3.6 LT, 4WD Crew Cab has approximately 77,500 miles and I recently began experiencing the well-known transmission shudder between about 30 and 65 mph. The problem had worsened to the point that I could no longer attribute it to road conditions - and I had decided to bring the truck to the dealer - when recently, I experienced a sudden loss of power while driving at maybe 40 MPH. Several warning lights flashed, the “Check Stabilitrack” message appeared, and the Check Engine, Stabilitrack, and Traction Control icons remained illuminated. The truck regained driving power, but it stayed in a low gear with unusually high RPMs for the speed. (limp mode?) Because I was only about two miles from home, driving slowly, I was able to make it back and run an OBD-II scan, which showed fault codes U0101, P0700, and U0100. My next trip in the truck was to drive it to the dealer the following day. That trip began normally, but after about a mile I experienced another loss of power, along with the same warning lights and the same “Check Stabilitrack” message. As before the truck remained driveable, but again operated at an abnormally high RPM-to-speed ratio and seemed stuck in a single gear. About a mile later, the dashboard lit up once more, this time displaying “Check 4WD.” Soon after that, I arrived at the dealer. I have verified that the truck still has its original factory transmission fluid, which means it has never received the corrective fluid exchange outlined in GM Technical Service Bulletin #18-NA-355.  That was Thursday of last week and I've heard nothing yet from the dealer.    According to Technical Service Bulletin #18-NA-355 and the build date of my truck, my truck should have the newer LV fluid. I've done a little research and read something about a problem with the wiring harness as well.   Anyone have an insights into this situation?  Thank you!!
    • Having bumper and other body damages can be very frustrating, especially as a result of a parking lot collision/bump. Our team wants to learn more about the damages to your truck so we can look into ways we might be able to help. When you get the chance, please fill out our support form with more details: https://s.gmc.com/support-request . A member of our team will follow up with you as soon as next available. We want to get you enjoying your truck to the fullest again. 
    • Did you even read this article?   Even the title of the article says "U.S.-Iran Deal Doesn’t Mean a Swift Return of Oil and Gas Flows"   Remember, crude oil prices are based on FUTURE purchases by the oil companies.  Gas prices are based on FUTURE purchases by the station.  This article stated that many of the oil producing nations have to restart their processes to get the oil produced.  Then the oil has to be shipped to wherever.  And it doesn't get there overnight.  And most of that oil is not coming here. Check out this site:  https://afdc.energy.gov/data/10621   A graph will pop up to show where the US imports their oil from.  Notice that there isn't a lot of import from OPEC and Iraq.  Most of the US import comes from Canada. The US oil produces are selling their oil on the open market, which is why the US fuel costs went up.  So you're correct, the US oil companies are going to slow walk the price downward.
    • Having codes and an engine light with no hints on what might be causing it is nothing short of frustrating. How long have these concerns been present? We want to know more so we can look into ways we might be able to help you. When you get the chance, please fill out our support form with additional details on your experience so far. A member of our team will follow up with you as soon as next available: https://s.gmc.com/support-request 
    • Knowing the life of your brakes is a highly important status to keep track of. If you suspect your brake sensors need attention, please fill out our support form with additional details on your experience. When did you last take it in for inspection? Our team will follow up with next steps as soon as next available. Please include your username and GM Trucks Forum in the form as well. Support Form: https://s.chevy.com/support-request 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...