Jump to content

Recommended Posts

Posted

 

 

You still looking into that owner/operator hauling stuff?

Got a job opportunity hauling RVs
Posted (edited)

I've had my auto zone Duralast gold battery coming up on 4 years now in December. Still strong!

 

Sent while in 'Murica...

The Yota just crossed the 6 year mark on its original battery. The terminals look like they are covered in moss. I keep saying I'll clean it properly when the battery dies(my 6's lasted 4 1/2 years), but it just won't. Probably do it this week. I think I'll just replace it before winter preemptively. Edited by SnakeEyes
Posted

Dad has a Four Seasons brand in his 99. It's been in there since he bought the truck in 2001. Still works. Idk how though lol!

  • Like 1
Posted

Scared myself, been on a road trip last two weeks. First time on this trip and only the second time ever the low fuel light came on! I checked gas buddy and found a place with cheap fuel so off I go. When I left hotel it said I had used 32.7 gallons from my 36 gallon tank went about 10 miles to the closest station sweating bullits the whole way put 34.5 gallons into the tank never ever going to do that again!!

Posted

Drove mine to work. Have a squeak in my new leaf springs on the drivers side. I'll have to fix that at some point.

Posted

Drove mine to work. Have a squeak in my new leaf springs on the drivers side. I'll have to fix that at some point.

Do you have the regular rubber bushings or polyurethane bushings? The polyurethane ones have a special grease to prevent them from squeaking. Found that out the hard way, had to uninstall the springs and press the bushings back out to put the grease in there. No more squeak now!

 

Sent while in 'Murica...

Posted

Changed out the NGK TR5 V-Power spark plugs on the 2002 Silverado today. The plugs had 40k on them, truck miles are 148K. They still looked good but I had a set of AC Delco Iridiums on the shelf so I put them in. Now I should be good for at least 100k miles.

I went a little crazy with the anti-seize on the last install. I didn't put that much on this time. I have to say they came out really easy. :lol:


2002Silveradosparkplugs006_zps2103277c.j
2002Silveradosparkplugs005_zps8ee9f764.j
2002Silveradosparkplugs001_zps0beafd07.j
2002Silveradosparkplugs002_zpsf6de6c45.j

Posted

80fb9804d291dce9bdfad260d9747015.jpg

09d59e1acf3b989a31aa52324db84c5b.jpg

Tore the carpet out of the Triton. Kinda semi restoring it. New seat skins, carpet, fortrex 112 trolling motor, 2 power pole blades, control and cables.

  • Like 1
Posted

Do you have the regular rubber bushings or polyurethane bushings? The polyurethane ones have a special grease to prevent them from squeaking. Found that out the hard way, had to uninstall the springs and press the bushings back out to put the grease in there. No more squeak now!

 

Sent while in 'Murica...

 

 

No idea lol!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...