Jump to content

Recommended Posts

Posted

6" BDS + 1.5" Zone BL. XD Series 820's 20x12, -44 offset on 35x12.5 Toyo MT 3c236f3882bfe944797daabb3ae4c330.jpgfd6c3eef7ab478e298e2c5cacc6aec45.jpg2e31c8f465d9b007f85ee79c5f570fe6.jpg

 

Sent from my SAMSUNG-SM-G900A using Tapatalk

  • Like 3
Posted

Got an odd question I asked in another thread but this place is more appropriate I think.

 

If I lift my truck 4" will the truck actually stand a true 4" higher or is there some sort of "settling" that takes place and it may sit lower?

 

I'm trying to figure out exactly how tall my truck will stand.

 

Stock it is 74" then if I add 35's (that is 3.5" taller than my current tires), then a 4.5" lift the truck should stand 82" high...is that correct or am I addding something wrong?

 

Just bought a new sierra, debating on lvl/33's or 4.5" lift/35's for garage fitment. Garage is 80-81" high.

 

Thanks!

Posted

Exact height could vary depending on wheel width and how much air you run in the tire. I can tell you with a 6" Lift and 35's I clear my garage just fine with a 7ft door.

Posted

Exact height could vary depending on wheel width and how much air you run in the tire. I can tell you with a 6" Lift and 35's I clear my garage just fine with a 7ft door.

Any chance u know the exact height to the top of your truck(shark fin)?

Posted

My trucks front fenders was 36 inch stock. A 2 inch rcx level raised it to 38 inches and a 2 inch taller tire raised it to 39.

You have to remember you split the tire height difference in half.

That being said I took the level out. Using the same tire I put in and rcx 5 inch kit. My front fenders now sits at 42 3/4 after settling. That means I got 5 3/4 inches out of a 5 inch kit. You can't trust what they are claiming the lift size to be.

I even emailed rcx because of lift laws around here and stated it was true 5 inch kit. Before settling it was 6 1/4 inches higher. I sat in the bed of my truck and my wife drove it out of the garage. I clear the 7 ft door by maybe 3 inches

  • Like 1
Posted

Would it be possible for you to take a shot down the side so I can see how far they stick out? This is the same setup I am looking to get, but am unsure of how far they will stick out.

Here ya go.

 

LrRZ3dnl.jpg

Posted

Perfect! Thanks a lot. They don't stick out as far as I thought.

Yeah not terrible, but I picked up a pair of fender flares for mine. Going to install them this weekend. They definitely stick out enough to chuck some big rocks at the side mirrors, lol.

Posted

Gentlemen,

 

I'm in the market for a lift on my 2015 Silverado 1500 4x4 and wanted to see if anyone has used the 4.5" Zone suspension lift with 33's yet? I tried looking thru the entire thread but 149 pages is pretty extensive. My last truck was a 2011 Silverado with a 3.5" X 1.75" suspension lift on 33's. I had the 20" x 9" KMC XD Cranks with zero offset running 305/55/R20 Trail Grapplers and ran into some rubbing issues turned in reverse. That being said, I was hoping the 4.5" would help with that. I haven't decided on the wheel just yet, but i do know I want to continue with the same tire as before. Any suggestions on offsets that would fit for possibly a 20" X 10" at most.

 

Lift I am considering;

http://www.ebay.com/itm/2014-2015-Chevrolet-Silverado-GMC-Sierra-1500-4-5-Zone-Suspension-Lift-kit-4x4-/171557627846?fits=Year%3A2015|Model%3ASilverado+1500&hash=item27f1a1a7c6:g:d7YAAOSwLzdWTSwq&vxp=mtr

 

Also, the lift on this page states "All wheel drive models require drive line modification"???????

 

Any help is much appreciated.

Posted

Alright question of the day...

I know that a 35/12.5R20 fits on a stock wheel with a 6'' lift, but will a 37"?

It might,

 

I saw a sierra a few days a go with a procomp lift on the stock AT wheels running 37s....probably rubs like a mofo ...I didnt ask the guy but man it looked sick. Didn't have my phone on me to take a picture.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined
  • Who's Online   1 Member, 0 Anonymous, 1,399 Guests (See full list)


  • Latest Articles

  • Posts

    • My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • I have 2 choices. 
    • Do you have access to BP fuels? Some stations have Silver 91 E-0 priced the same as their 93 E-10.  There is a local Marathon with 90 alky free for $6 a gallon but I go down the road to BP for $5-ish. They also have a 100 E-0 but that stuff is $10 a pop. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...