What have you done to your K2 today?

[cbrsilv15]

I didn't use any bracket and used the same locations. I just zip tied them up under the dash nice and snug. They don't move at all.

 

Those Oznium leds are great!!

[pgamboa]

I didn't use any bracket and used the same locations. I just zip tied them up under the dash nice and snug. They don't move at all.

 

Those Oznium leds are great!!

 

Ok - Thanks! I'm gonna try and tackle this...hopefully this weekend. By kids are already curious on these and hooking them up to 9v batteries. LOL.

[pgamboa]

Did you end up running all (4) Positive leads towards the BCM, and pigtailed to one wire to the power source?

 

I didn't use any bracket and used the same locations. I just zip tied them up under the dash nice and snug. They don't move at all.

 

Those Oznium leds are great!!

[cbrsilv15]

Yup. I tapped into the gray wire behind the drivers side pillar. All 4 to one wire. The grounds were all done individually beside the leds.

[cbrsilv15]

[cbrsilv15]

 

 

 

Wow. I hope I never have to separate that grille shell again.

[jerseytaylor]

well...you guys did it. fully scared me away from the RC 7.5" lift lol.

returned that today ha

luckily i never opened it/installed.

mcgaughys 7-9 ordered instead

[slj2008]

 

 

 

Wow. I hope I never have to separate that grille shell again.

 

looks good . how hard to take apart grill ???

[crafferty]

 

 

 

Wow. I hope I never have to separate that grille shell again.

The grille shell is so easy to separate compared to the headlight trim and bumpers. Paint looks good on it. I'm cleaning mine this weekend in prep for paint.

 

 

 

 

looks good . how hard to take apart grill ???

It's not hard at all. The plastic is very easy to work with.

 

Sent from my SM-G930V using Tapatalk

Edited October 6, 2016 by crafferty

[Silvern Sentry]

well...you guys did it. fully scared me away from the RC 7.5" lift lol.

returned that today ha

luckily i never opened it/installed.

mcgaughys 7-9 ordered instead

best decision ever. did you get the add a leaf pack too?

[cbrsilv15]

The grille was a pain to separate. Headlight trim was easier. Lol. There are about 20 or so clips on the back of the grille and they're a little tricky to get out. Just need 2 screwdrivers to pry with.

[ejehle91]

Really using those back up sensors and camera I see lol.

 

Sent from my SM-G930V using Tapatalk

Lol I knew someone was going to say this but I was in a hurry as the guy next to me waved for me to back out first. Careless on my part I know but I was looking out the mirrors at least. Also hungover and the parking sensors didn't ding at all. Oh well, I was eventually going to buy a painted one anyways!

[crafferty]

The grille was a pain to separate. Headlight trim was easier. Lol. There are about 20 or so clips on the back of the grille and they're a little tricky to get out. Just need 2 screwdrivers to pry with.

I just used one of my small vice grips to grab and pull back the tab. At the same time I wiggled the grille until it popped out then moved on. The hardest part was the middle section of the one grille that doesn't use tabs.

 

Sent from my SM-G930V using Tapatalk

[jerseytaylor]

best decision ever. did you get the add a leaf pack too?

i did yeah man

[crafferty]

i did yeah man

You'll be a lot happier with this setup.

 

Sent from my SM-G930V using Tapatalk